參數資料
型號： PC33887VW
廠商： FREESCALE SEMICONDUCTOR INC
元件分類： 運動控制電子
英文描述： STEPPER MOTOR CONTROLLER, PDSO20
封裝： LEAD FREE, PLASTIC, HSOP-20
文件頁數： 3/32頁
文件大?。?/td> 859K
代理商： PC33887VW
Analog Integrated Circuit Device Data
Freescale Semiconductor
11
33887
DYNAMIC ELECTRICAL CHARACTERISTICS
DYNAMIC ELECTRICAL CHARACTERISTICS
Table 5. DYNAMIC ELECTRICAL CHARACTERISTICS
Characteristics noted under conditions 5.0 V ≤ V+ ≤ 28 V and -40
°C ≤ TA ≤ 125°C unless otherwise noted. Typical values
noted reflect the approximate parameter mean at TA = 25°C under nominal conditions unless otherwise noted.
Characteristic
Symbol
Min
Typ
Max
Unit
TIMING CHARACTERISTICS
PWM Frequency (23)
fPWM
–
10
–
kHz
Maximum Switching Frequency During Active Current Limiting (24)
fMAX
–
20
kHz
Output ON Delay (25)
V+ = 14 V
tD(ON)
–
18
s
Output OFF Delay (25)
V+ = 14 V
tD(OFF)
–
18
s
ILIM Output Constant-OFF Time for Low-Side MOSFETs
tA
15
20.5
26
s
ILIM Blanking Time for Low-Side MOSFETs
tB
12
16.5
21
s
Output Rise and Fall Time (29)
V+ = 14 V, IOUT = 3.0 A
tF, tR
2.0
5.0
8.0
s
Disable Delay Time (30)
tD(DISABLE)
–
8.0
s
Power-ON Delay Time (31)
tPOD
–
1.0
5.0
ms
Wake-Up Delay Time (31)
tWUD
–
1.0
5.0
ms
Output MOSFET Body Diode Reverse Recovery Time (32)
tRR
100
–
ns
Notes
23.
The outputs can be PWM-controlled from an external source. This is typically done by holding one input high while applying a PWM
pulse train to the other input. The maximum PWM frequency obtainable is a compromise between switching losses and switching
frequency. See Typical Switching Waveforms, Figures 12 through 19, pp. 14–16.
24.
The Maximum Switching Frequency during active current limiting is internally implemented. The internal current limit circuitry produces
a constant-OFF-time pulse-width modulation of the output current. The output load’s inductance, capacitance, and resistance
characteristics affect the total switching period (OFF-time + ON-time) and thus the PWM frequency during current limit.
25.
Output Delay is the time duration from the midpoint of the IN1 or IN2 input signal to the 10% or 90% point (dependent on the transition
direction) of the OUT1 or OUT2 signal. If the output is transitioning HIGH-to-LOW, the delay is from the midpoint of the input signal to
the 90% point of the output response signal. If the output is transitioning LOW-to-HIGH, the delay is from the midpoint of the input signal
to the 10% point of the output response signal. See Figure 6, page 12.
26.
ILIM Output Constant-OFF Time is the time during which the internal constant-OFF time PWM current regulation circuit has tri-stated
the output bridge.
27.
Load currents ramping up to the current regulation threshold become limited at the ILIM value. The short circuit currents possess a di/dt
that ramps up to the ISCH or ISCL threshold during the ILIM blanking time, registering as a short circuit event detection and causing the
shutdown circuitry to force the output into an immediate tri-state latch-OFF. See Figures 10 and 11, page 13. Operation in Current Limit
mode may cause junction temperatures to rise. Junction temperatures above ~160
°C will cause the output current limit threshold to
progressively “fold back”, or decrease with temperature, until ~175
°C is reached, after which the TLIM thermal latch-OFF will occur.
Permissible operation within this fold-back region is limited to nonrepetitive transient events of duration not to exceed 30 seconds. See
28.
ILIM Blanking Time is the time during which the current regulation threshold is ignored so that the short-circuit detection threshold
comparators my have time to act.
29.
Rise Time is from the 10% to the 90% level and Fall Time is from the 90% to the 10% level of the output signal. See Figure 8, page 12.
30.
Disable Delay Time is the time duration from the midpoint of the D (disable) input signal to 10% of the output tri-state response. See
31.
Parameter has been characterized but not production tested.
32.
Parameter is guaranteed by design but not production tested.
相關PDF資料
PDF描述
PC33899CVW BRUSH DC MOTOR CONTROLLER, PDSO30
PC33926PNB BRUSHLESS DC MOTOR CONTROLLER, 5 A, PQCC32
PC33926PNBR2 BRUSHLESS DC MOTOR CONTROLLER, 5 A, PQCC32
PC33991DH STEPPER MOTOR CONTROLLER, PDSO24
PC33991DHR2 STEPPER MOTOR CONTROLLER, PDSO24
相關代理商/技術參數
參數描述
PC33887VW/R2 制造商:MOTOROLA 制造商全稱:Motorola, Inc 功能描述:5.0 A H-Bridge with Load Current Feedback
PC33887VWR2 制造商:MOTOROLA 制造商全稱:Motorola, Inc 功能描述:5.0 A H-Bridge with Load Current Feedback
PC33888APNB 制造商:MOTOROLA 制造商全稱:Motorola, Inc 功能描述:Quad High-Side and Octal Low-Side Switch for Automotive
PC33888APNBR2 制造商:MOTOROLA 制造商全稱:Motorola, Inc 功能描述:Quad High-Side and Octal Low-Side Switch for Automotive
PC33888PNB 制造商:MOTOROLA 制造商全稱:Motorola, Inc 功能描述:Quad High-Side and Octal Low-Side Switch for Automotive
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*