- 您現在的位置：買賣IC網 > PDF目錄367743 > P89LPC938FA (NXP SEMICONDUCTORS) 8-bit microcontroller with accelerated two-clock 80C51 core 8 kB 3 V byte-erasable Flash with 10-bit A/D converter PDF資料下載
參數資料
| 型號： | P89LPC938FA |
| 廠商： | NXP SEMICONDUCTORS |
| 元件分類： | 微控制器/微處理器 |
| 英文描述： | 8-bit microcontroller with accelerated two-clock 80C51 core 8 kB 3 V byte-erasable Flash with 10-bit A/D converter |
| 中文描述： | 8-BIT, FLASH, 18 MHz, MICROCONTROLLER, PQCC28 |
| 封裝： | PLASTIC, MS-018, SOT-261-2, LCC-28 |
| 文件頁數： | 24/68頁 |
| 文件大?。?/td> | 318K |
| 代理商： | P89LPC938FA |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁當前第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁
9397 750 14051
Koninklijke Philips Electronics N.V. 2005. All rights reserved.
Product data sheet
Rev. 01 — 25 February 2005
24 of 68
Philips Semiconductors
P89LPC938
8-bit microcontroller with 10-bit A/D converter
7.13 I/O ports
The P89LPC938 has four I/O ports: Port 0, Port 1, Port 2, and Port 3. Ports 0, 1and 2 are
8-bit ports, and Port 3 is a 2-bit port. The exact number of I/O pins available depends upon
the clock and reset options chosen, as shown in
Table 7
.
[1]
Required for operation above 12 MHz.
7.13.1
Port configurations
All but three I/O port pins on the P89LPC938 may be configured by software to one of four
types on a bit-by-bit basis. These are: quasi-bidirectional (standard 80C51 port outputs),
push-pull, open drain, and input-only. Two configuration registers for each port select the
output type for each port pin.
1. P1.5 (RST) can only be an input and cannot be configured.
2. P1.2 (SCL/T0) and P1.3 (SDA/INT0) may only be configured to be either input-only or
open-drain.
7.13.1.1
Quasi-bidirectional output configuration
Quasi-bidirectional output type can be used as both an input and output without the need
to reconfigure the port. This is possible because when the port outputs a logic HIGH, it is
weakly driven, allowing an external device to pull the pin LOW. When the pin is driven
LOW, it is driven strongly and able to sink a fairly large current. These features are
somewhat similar to an open-drain output except that there are three pull-up transistors in
the quasi-bidirectional output that serve different purposes.
The P89LPC938 is a 3 V device, but the pins are 5 V-tolerant. In quasi-bidirectional mode,
if a user applies 5 V on the pin, there will be a current flowing from the pin to V
DD
, causing
extra power consumption. Therefore, applying 5 V in quasi-bidirectional mode is
discouraged.
A quasi-bidirectional port pin has a Schmitt triggered input that also has a glitch
suppression circuit.
7.13.1.2
Open-drain output configuration
The open-drain output configuration turns off all pull-ups and only drives the pull-down
transistor of the port driver when the port latch contains a logic 0. To be used as a logic
output, a port configured in this manner must have an external pull-up, typically a resistor
tied to V
DD
.
Table 7:
Clock source
Number of I/O pins available
Reset option
Number of I/O pins
(28-pin package)
26
25
25
24
24
23
On-chip oscillator or watchdog oscillator
No external reset (except during power-up)
External RST pin supported
No external reset (except during power-up)
External RST pin supported
[1]
No external reset (except during power-up)
External RST pin supported
[1]
External clock input
Low/medium/high speed oscillator
(external crystal or resonator)
相關PDF資料 |
PDF描述 |
|---|---|
| P89LV51RB2BBC | 8-bit 80C51 3 V low power 16/32/64 kB Flash microcontroller with 1 kB RAM |
| P89LV51RB2 | 8-bit 80C51 3 V low power 16/32/64 kB Flash microcontroller with 1 kB RAM |
| P89LV51RB2BA | 8-bit 80C51 3 V low power 16/32/64 kB Flash microcontroller with 1 kB RAM |
| P89LV51RD2BN | 8-bit 80C51 3 V low power 16/32/64 kB Flash microcontroller with 1 kB RAM |
| P89LV51RD2 | 8-bit 80C51 3 V low power 64 kB Flash microcontroller with 1 kB RAM |
相關代理商/技術參數 |
參數描述 |
|---|---|
| P89LPC938FA,129 | 功能描述:8位微控制器 -MCU 80C51 8K FL 768B RAM RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT |
| P89LPC938FA129 | 制造商:NXP Semiconductors 功能描述:P89LPC938FA/PLCC28/TUBESM// |
| P89LPC938FDH | 制造商:NXP Semiconductors 功能描述:MCU 8BIT 80C51 8K FLASH TSSOP28 制造商:NXP Semiconductors 功能描述:MCU 8BIT 80C51 8K FLASH, TSSOP28 制造商:NXP Semiconductors 功能描述:MCU 8BIT 80C51 8K FLASH, TSSOP28, Controller Family/Series:(8051) 8052, Core Siz |
| P89LPC938FDH,529 | 功能描述:8位微控制器 -MCU 80C51 8K FL 768B RAM RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT |
| P89LPC938FDH529 | 制造商:NXP Semiconductors 功能描述:IC 8BIT MCU 80C51 18MHZ TSSOP-28 |
發布緊急采購，3分鐘左右您將得到回復。