參數資料
型號: P89LPC938FA
廠商: NXP SEMICONDUCTORS
元件分類: 微控制器/微處理器
英文描述: 8-bit microcontroller with accelerated two-clock 80C51 core 8 kB 3 V byte-erasable Flash with 10-bit A/D converter
中文描述: 8-BIT, FLASH, 18 MHz, MICROCONTROLLER, PQCC28
封裝: PLASTIC, MS-018, SOT-261-2, LCC-28
文件頁數: 20/68頁
文件大小: 318K
代理商: P89LPC938FA
9397 750 14051
Koninklijke Philips Electronics N.V. 2005. All rights reserved.
Product data sheet
Rev. 01 — 25 February 2005
20 of 68
Philips Semiconductors
P89LPC938
8-bit microcontroller with 10-bit A/D converter
The frequency of this clock output is
1
2
that of the CCLK. If the clock output is not needed
in Idle mode, it may be turned off prior to entering Idle, saving additional power.
7.4 On-chip RC oscillator option
The P89LPC938 has a 6-bit TRIM register that can be used to tune the frequency of the
RC oscillator. During reset, the TRIM value is initialized to a factory pre-programmed
value to adjust the oscillator frequency to 7.373 MHz,
±
1 % at room temperature.
End-user applications can write to the TRIM register to adjust the on-chip RC oscillator to
other frequencies.
7.5 Watchdog oscillator option
The watchdog has a separate oscillator which has a frequency of 400 kHz. This oscillator
can be used to save power when a high clock frequency is not needed.
7.6 External clock input option
In this configuration, the processor clock is derived from an external source driving the
XTAL1/P3.1 pin. The rate may be from 0 Hz up to 18 MHz. The XTAL2/P3.0 pin may be
used as a standard port pin or a clock output.
When using an oscillator frequency
above 12 MHz, the reset input function of P1.5 must be enabled. An external circuit
is required to hold the device in reset at power-up until V
DD
has reached its
specified level. When system power is removed V
DD
will fall below the minimum
specified operating voltage. When using an oscillator frequency above 12 MHz, in
some applications, an external brownout detect circuit may be required to hold the
device in reset when V
DD
falls below the minimum specified operating voltage.
Fig 6.
Block diagram of oscillator control.
÷
2
002aab102
RTC
ADC0
CPU
WDT
DIVM
CCLK
UART
OSCCLK
I
2
C-BUS
PCLK
TIMER 0 AND
TIMER 1
HIGH FREQUENCY
MEDIUM FREQUENCY
LOW FREQUENCY
XTAL1
XTAL2
RC
OSCILLATOR
WATCHDOG
OSCILLATOR
(7.3728 MHz
±
1 %)
PCLK
RCCLK
SPI
CCU
32
×
PLL
(400 kHz
+
30 %
20 %)
相關PDF資料
PDF描述
P89LV51RB2BBC 8-bit 80C51 3 V low power 16/32/64 kB Flash microcontroller with 1 kB RAM
P89LV51RB2 8-bit 80C51 3 V low power 16/32/64 kB Flash microcontroller with 1 kB RAM
P89LV51RB2BA 8-bit 80C51 3 V low power 16/32/64 kB Flash microcontroller with 1 kB RAM
P89LV51RD2BN 8-bit 80C51 3 V low power 16/32/64 kB Flash microcontroller with 1 kB RAM
P89LV51RD2 8-bit 80C51 3 V low power 64 kB Flash microcontroller with 1 kB RAM
相關代理商/技術參數
參數描述
P89LPC938FA,129 功能描述:8位微控制器 -MCU 80C51 8K FL 768B RAM RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT
P89LPC938FA129 制造商:NXP Semiconductors 功能描述:P89LPC938FA/PLCC28/TUBESM//
P89LPC938FDH 制造商:NXP Semiconductors 功能描述:MCU 8BIT 80C51 8K FLASH TSSOP28 制造商:NXP Semiconductors 功能描述:MCU 8BIT 80C51 8K FLASH, TSSOP28 制造商:NXP Semiconductors 功能描述:MCU 8BIT 80C51 8K FLASH, TSSOP28, Controller Family/Series:(8051) 8052, Core Siz
P89LPC938FDH,529 功能描述:8位微控制器 -MCU 80C51 8K FL 768B RAM RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT
P89LPC938FDH529 制造商:NXP Semiconductors 功能描述:IC 8BIT MCU 80C51 18MHZ TSSOP-28