- 您現在的位置：買賣IC網 > PDF目錄367723 > P80C591 (NXP Semiconductors N.V.) Single-chip 8-bit microcontroller with CAN controller PDF資料下載
參數資料
| 型號： | P80C591 |
| 廠商： | NXP Semiconductors N.V. |
| 英文描述： | Single-chip 8-bit microcontroller with CAN controller |
| 中文描述： | 單芯片8 - CAN控制器位微控制器 |
| 文件頁數： | 26/161頁 |
| 文件大?。?/td> | 588K |
| 代理商： | P80C591 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁當前第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁第126頁第127頁第128頁第129頁第130頁第131頁第132頁第133頁第134頁第135頁第136頁第137頁第138頁第139頁第140頁第141頁第142頁第143頁第144頁第145頁第146頁第147頁第148頁第149頁第150頁第151頁第152頁第153頁第154頁第155頁第156頁第157頁第158頁第159頁第160頁第161頁
1999 Aug 19
26
Philips Semiconductors
Objective Specification
Single-chip 8-bit microcontroller with CAN controller
P8xC591
12.2.1
I
NTERFACE
M
ANAGEMENT
L
OGIC
(IML)
The Interface Management Logic interprets commands
from the CPU, controls addressing of the CAN Registers
and provides interrupts and status information to the CPU.
Additionally it drives the universal interface of the PeliCAN.
12.2.2
T
RANSMIT
B
UFFER
(TXB)
The Transmit Buffer is an interface between the CPU and
the Bit Stream Processor (BSP) and is able to store a
complete CAN message which should be transmitted over
the CAN network. The buffer is 13 bytes long, written by
the CPU and read out by the BSP or the CPU itself.
12.2.3
R
ECEIVE
B
UFFER
(RXB, RXFIFO)
The Receive Buffer is an interface between the
Acceptance Filter and the CPU and stores the received
and accepted messages from the CAN Bus line. The
Receive Buffer (RXB) represents a CPU-accessible
13-byte-window of the Receive FIFO (RXFIFO), which has
a total length of 64 bytes depending on the
implementation. With the help of this FIFO the CPU is able
to process one message while other messages are being
received.
12.2.4
A
CCEPTANCE
F
ILTER
(ACF)
The Acceptance Filter compares the received identifier
with the Acceptance Filter Table contents and decides
whether this message should be accepted or not. In case
of a positive acceptance test, the complete message is
stored in the RXFIFO. The ACF contains 4 independent
Acceptance Filter banks supporting extended and
standard CAN frames with “change on the fly” feature.
12.2.5
B
IT
S
TREAM
P
ROCESSOR
(BSP)
The Bit Stream Processor is a sequencer, controlling the
data stream between the Transmit Buffer, RXFIFO and the
CAN-Bus. It also performs the error detection, arbitration,
stuffing and error handling on the CAN bus.
12.2.6
E
RROR
M
ANAGEMENT
L
OGIC
(EML)
The EML is responsible for the error confinement of the
transfer-layer modules. It gets error announcements from
the BSP and then informs the BSP and IML about error
statistics.
12.2.7
B
IT
T
IMING
L
OGIC
(BTL)
The Bit Timing Logic monitors the serial CAN bus line and
handles the Bus line-related bit timing. It synchronizes to
the bit stream on the CAN Bus on a “recessive” to
“dominant” Bus line transition at the beginning of a
message (hard synchronization) and resynchronizes on
further transitions during the reception of a message (soft
synchronization). The BTL also provides programmable
time segments to compensate for the propagation delay
times and phase shifts (e.g., due to oscillator drifts) and to
define the sampling time and the number of samples to be
taken within a bit time.
12.2.8
T
RANSMIT
M
ANAGEMENT
L
OGIC
(TML)
The Transmit Management Logic provides the driver
signals for the push-pull CAN TX transistor stage.
Depending on the programmable output driver
configuration the external transistors are switched on or
off. Additionally a short circuit protection and the
asynchronous float on hardware reset is performed here.
相關PDF資料 |
PDF描述 |
|---|---|
| P83C591 | Single-chip 8-bit microcontroller with CAN controller |
| P87C591 | Single-chip 8-bit microcontroller with CAN controller |
| P83C591VFA | Single-chip 8-bit microcontroller with CAN controller |
| P80CE560 | 8-BIT SINGLE CHIP MICROCONTROLLERS |
| P87CE560EFB | BATTERY CHG UNIV 12VDC @ 500MA |
相關代理商/技術參數 |
參數描述 |
|---|---|
| P80C591SFA | 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:Single-chip 8-bit microcontroller with CAN controller |
| P80C591SFB | 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:Single-chip 8-bit microcontroller with CAN controller |
| P80C592 | 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:8-bit microcontroller with on-chip CAN |
| P80C592FFA | 制造商:NXP Semiconductors 功能描述: |
| P80C592FFA/00,512 | 功能描述:8位微控制器 -MCU 80C51 W/CAN 16MHZ ROMLESS RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT |
發布緊急采購，3分鐘左右您將得到回復。