參數資料
型號: P80C591
廠商: NXP Semiconductors N.V.
英文描述: Single-chip 8-bit microcontroller with CAN controller
中文描述: 單芯片8 - CAN控制器位微控制器
文件頁數: 157/161頁
文件大?。?/td> 588K
代理商: P80C591
1999 Aug 19
157
Philips Semiconductors
Objective Specification
Single-chip 8-bit microcontroller with CAN controller
P8xC591
25.1
Timing symbol definitions
Oscillator:
f
CLK
= clock frequency
t
CLK
= clock period
Timing symbols (acronyms):
Each timing symbol has five characters. The first character
is always a 't' (= time). the remaining four characters of the
symbol (typed in subscript), depending on their relative
positions, indicate the name of a signal or the logical status
of that signal. the designations are as follows:
A =address
C = clock
D = input data
H = logic level HIGH
I = instruction (program memory contents)
L = Logic level LOW or ALE
P = PSEN
Q = output data
R = RD signal
t = time
V = valid
W = WR signal
X = no longer a valid logic level
Z = float
Examples:
t
AVLL
= time for address valid to ALE LOW
t
LLPL
= time for ALE LOW to PSEN LOW
26 EPROM CHARACTERISTICS
The P8xC591 contains three signature bytes that can be
read and used by an EPROM programming system to
identify the device. The signature bytes identify the device
as an P8xC591 manufactured by Philips:
(030H) = 15H indicates manufactured by Philips
(0031H) = 98H indicates Hamburg
(60H) = 01H indicates P87C591
26.1
If security bits 2 or 3 have not been programmed, the
on-chip program memory can be read out for program
verification.
Program verification
If the encryption table has been programmed, the data
presented at port 0 will be exclusive NOR of the program
byte with one of the encryption bytes. The user will have to
know the encryption table contents in order to correctly
decode the verification data. The encryption table itself
cannot be read out.
26.2
With none of the security bits programmed the code in the
program memory can be verified. If the encryption table is
programmed, the code will be encrypted when verified.
When only security bit 1 (see Table 113) is programmed,
MOVC instructions executed from external program
memory are disabled from fetching code bytes from the
internal memory. EA is latched on Reset and all further
programming of the EPROM is disabled. When security
bits 1 and 2 are programmed, in addition to the above,
verify mode is disabled.
Security bits
When all three security bits are programmed, all of the
conditions above apply and all external program memory
execution is disabled.
Table 113
Program security bits for EPROM devices
P = programmed; U = unprogrammed.
Note
1.
Any other combination of the security bits is not defined.
PROGRAM
LOCK BITS
(1)
SB1 SB2 SB3
PROTECTION DESCRIPTION
1
U
U
U
No Program Security features enabled. (Code verify will still be encrypted by the
Encryption Array if programmed.).
MOVC instructions executed from external Program Memory are disabled from
fetching code bytes from internal memory, EA is sampled and latched on reset,
and further programming of the EPROM is disabled.
Same as 2, also verify is disabled.
Same as 3, and external memory execution is disabled.
2
P
U
U
3
4
P
P
P
P
U
P
相關PDF資料
PDF描述
P83C591 Single-chip 8-bit microcontroller with CAN controller
P87C591 Single-chip 8-bit microcontroller with CAN controller
P83C591VFA Single-chip 8-bit microcontroller with CAN controller
P80CE560 8-BIT SINGLE CHIP MICROCONTROLLERS
P87CE560EFB BATTERY CHG UNIV 12VDC @ 500MA
相關代理商/技術參數
參數描述
P80C591SFA 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:Single-chip 8-bit microcontroller with CAN controller
P80C591SFB 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:Single-chip 8-bit microcontroller with CAN controller
P80C592 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:8-bit microcontroller with on-chip CAN
P80C592FFA 制造商:NXP Semiconductors 功能描述:
P80C592FFA/00,512 功能描述:8位微控制器 -MCU 80C51 W/CAN 16MHZ ROMLESS RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT