- 您現在的位置：買賣IC網 > PDF目錄11733 > ORT82G5-3FN680C (Lattice Semiconductor Corporation)IC TRANCEIVERS FPSC 680FPBGA PDF資料下載
參數資料
| 型號： | ORT82G5-3FN680C |
| 廠商： | Lattice Semiconductor Corporation |
| 文件頁數： | 71/119頁 |
| 文件大小： | 0K |
| 描述： | IC TRANCEIVERS FPSC 680FPBGA |
| 產品變化通告： | Product Discontinuation 01/Aug/2011 |
| 標準包裝： | 24 |
| 系列： | * |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁當前第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁
Lattice Semiconductor
ORCA ORT42G5 and ORT82G5 Data Sheet
55
Parallel Loopback at MUX/DEMUX Boundary, Excluding SERDES
This is a low-frequency test mode used to test the MUX/DEMUX logic block. As with the mode described in the pre-
vious section, the loopback path is at the interface between the SERDES blocks and the MUX and DEMUX blocks
and uses the parallel 10-bit buses at these interfaces (see Figure 33). However, the loopback connection is made
such that the output signals from the TX MUX block are used as the input signals to the RX SERDES block. In this
loopback mode the MRWDxx[39:0], TWDxx[31:0], TCOMMAxx[3:0] and TBIT9xx[3:0] signal lines function normally
and the high-speed serial input and output buffers are not used. Use of this mode also requires conguration of the
FPGA logic to connect the MRWDxx[39:0], TWDxx[31:0], TCOMMAxx[3:0] and TBIT9xx[3:0] signal lines to exter-
nal pins. The basic loopback path is shown in Figure 33.
Figure 33. Parallel Loopback at MUX/DEMUX Boundary, Excluding SERDES
This test mode is enabled by setting the pin PLOOP_TEST_ENN to 0. PASB_TESTCLK must be running in this
mode at 4x frequency of RSYS_CLK[A2, B2] or TSYS_CLK_[AC, AD, BC, BD] for the ORT42G5 and
RSYS_CLK[A1,A2,B1,B2] or TSYS_CLK_[AA, AB... BD] for the ORT82G5.
SERDES Characterization Test Mode (ORT82G5 Only)
The SERDES characterization mode is a test mode that allows for direct control and observation of the transmit
and receive SERDES interfaces at chip ports. With these modes the SERDES logic and I/O can be tested one
channel at a time in either the receive or transmit modes. The SERDES characterization mode is available for only
one quad (quad B) of the ORT82G5.
The characterization test mode is congured by setting bits in the control registers via the system bus. There are
four bits that set up the test mode. The transmit characterization test mode is entered when SCHAR_ENA=1 and
SCHAR_TXSEL=1. Entering this mode will cause chip port inputs to directly control the SERDES low-speed trans-
mit ports of one of the channels as shown in Table 23.
Table 23. SERDES Transmit Characterization Mode
The x in the table will be a single channel in SERDES quad B, selected by the SCHAR_CHAN control bits. The
decoding of SCHAR_CHAN is shown in Table 24.
Chip Port
SERDES Input
PSCHAR_CKIO0
TBCBx
PSCHAR_LDIO[9:0]
LDINBx[9:0]
DEMUX
MUX
Embedded Core
FPGA Logic
40
MRWDxx[39:0]
32
4
Receive
Transmit
TWDxx[31:0]
TCOMMAxx[3:0]
TBIT9xx[3:0]
Data
Checking
Data
Generation
n
m
{
Parallel
Loopback
Connection
Test
Equipment
相關PDF資料 |
PDF描述 |
|---|---|
| PIC32MX775F512H-80I/MR | IC MCU 32BIT 512KB FLASH 64QFN |
| VI-J4H-IW-F1 | CONVERTER MOD DC/DC 52V 100W |
| PIC18F4682-I/PT | IC PIC MCU FLASH 40KX16 44TQFP |
| ORSO82G5-1FN680I | IC TRANCEIVERS FPSC 680FPBGA |
| PIC32MX775F256L-80I/PT | IC MCU 32BIT 256K FLASH 100TQFP |
相關代理商/技術參數 |
參數描述 |
|---|---|
| ORT82G5-3FN680C1 | 功能描述:FPGA - 現場可編程門陣列 10368 LUT 372 I/O RoHS:否 制造商:Altera Corporation 系列:Cyclone V E 柵極數量: 邏輯塊數量:943 內嵌式塊RAM - EBR:1956 kbit 輸入/輸出端數量:128 最大工作頻率:800 MHz 工作電源電壓:1.1 V 最大工作溫度:+ 70 C 安裝風格:SMD/SMT 封裝 / 箱體:FBGA-256 |
| ORT82G5-FPSC-EV | 功能描述:可編程邏輯 IC 開發工具 Ev Eval Brd RoHS:否 制造商:Altera Corporation 產品:Development Kits 類型:FPGA 工具用于評估:5CEFA7F3 接口類型: 工作電源電壓: |
| ORT82G5-G2-PAC-EV | 功能描述:可編程邏輯 IC 開發工具 ORT82G5 ispGDX256 is pPAC PwrMgr 1208 BC RoHS:否 制造商:Altera Corporation 產品:Development Kits 類型:FPGA 工具用于評估:5CEFA7F3 接口類型: 工作電源電壓: |
| ORT8850 | 制造商:LATTICE 制造商全稱:Lattice Semiconductor 功能描述:Field-Programmable System Chip (FPSC) Eight-Channel x 850 Mbits/s Backplane Transceiver |
| ORT8850-FPSC-EV | 功能描述:可編程邏輯 IC 開發工具 ORCA ORT8850 FPSC Eval Brd RoHS:否 制造商:Altera Corporation 產品:Development Kits 類型:FPGA 工具用于評估:5CEFA7F3 接口類型: 工作電源電壓: |
發布緊急采購，3分鐘左右您將得到回復。