- 您現在的位置：買賣IC網 > PDF目錄96107 > MTU18N50E (MOTOROLA INC) 18 A, 500 V, 0.31 ohm, N-CHANNEL, Si, POWER, MOSFET PDF資料下載
參數資料
| 型號： | MTU18N50E |
| 廠商： | MOTOROLA INC |
| 元件分類： | JFETs |
| 英文描述： | 18 A, 500 V, 0.31 ohm, N-CHANNEL, Si, POWER, MOSFET |
| 文件頁數： | 4/8頁 |
| 文件大小： | 160K |
| 代理商： | MTU18N50E |
MTU18N50E
4
Motorola TMOS Power MOSFET Transistor Device Data
POWER MOSFET SWITCHING
Switching behavior is most easily modeled and predicted
by recognizing that the power MOSFET is charge controlled.
The lengths of various switching intervals (
t) are deter-
mined by how fast the FET input capacitance can be charged
by current from the generator.
The published capacitance data is difficult to use for calculat-
ing rise and fall because drain–gate capacitance varies
greatly with applied voltage. Accordingly, gate charge data is
used. In most cases, a satisfactory estimate of average input
current (IG(AV)) can be made from a rudimentary analysis of
the drive circuit so that
t = Q/IG(AV)
During the rise and fall time interval when switching a resis-
tive load, VGS remains virtually constant at a level known as
the plateau voltage, VSGP. Therefore, rise and fall times may
be approximated by the following:
tr = Q2 x RG/(VGG – VGSP)
tf = Q2 x RG/VGSP
where
VGG = the gate drive voltage, which varies from zero to VGG
RG = the gate drive resistance
and Q2 and VGSP are read from the gate charge curve.
During the turn–on and turn–off delay times, gate current is
not constant. The simplest calculation uses appropriate val-
ues from the capacitance curves in a standard equation for
voltage change in an RC network. The equations are:
td(on) = RG Ciss In [VGG/(VGG – VGSP)]
td(off) = RG Ciss In (VGG/VGSP)
The capacitance (Ciss) is read from the capacitance curve at
a voltage corresponding to the off–state condition when cal-
culating td(on) and is read at a voltage corresponding to the
on–state when calculating td(off).
At high switching speeds, parasitic circuit elements com-
plicate the analysis. The inductance of the MOSFET source
lead, inside the package and in the circuit wiring which is
common to both the drain and gate current paths, produces a
voltage at the source which reduces the gate drive current.
The voltage is determined by Ldi/dt, but since di/dt is a func-
tion of drain current, the mathematical solution is complex.
The MOSFET output capacitance also complicates the
mathematics. And finally, MOSFETs have finite internal gate
resistance which effectively adds to the resistance of the
driving source, but the internal resistance is difficult to mea-
sure and, consequently, is not specified.
The resistive switching time variation versus gate resis-
tance (Figure 9) shows how typical switching performance is
affected by the parasitic circuit elements. If the parasitics
were not present, the slope of the curves would maintain a
value of unity regardless of the switching speed. The circuit
used to obtain the data is constructed to minimize common
inductance in the drain and gate circuit loops and is believed
readily achievable with board mounted components. Most
power electronic loads are inductive; the data in the figure is
taken with a resistive load, which approximates an optimally
snubbed inductive load. Power MOSFETs may be safely op-
erated into an inductive load; however, snubbing reduces
switching losses.
Figure 7. Capacitance Variation
–10
–5
0
5
10
25
GATE–TO–SOURCE OR DRAIN–TO–SOURCE VOLTAGE (VOLTS)
C,
CAP
ACIT
ANCE
(pF)
VGS
VDS
Ciss
Coss
Crss
TJ = 25°C
VDS = 0 V VGS = 0 V
6000
5000
4000
3000
2000
1000
0
15
20
8000
7000
Ciss
Crss
相關PDF資料 |
PDF描述 |
|---|---|
| MTU20N40E | 20 A, 400 V, 0.19 ohm, N-CHANNEL, Si, POWER, MOSFET |
| MTV16N50E-RL | 16 A, 500 V, 0.4 ohm, N-CHANNEL, Si, POWER, MOSFET |
| MTV16N50E | 16 A, 500 V, 0.4 ohm, N-CHANNEL, Si, POWER, MOSFET |
| MTV20N50E | 20 A, 500 V, 0.24 ohm, N-CHANNEL, Si, POWER, MOSFET |
| MTV25N50E-RL | 25 A, 500 V, 0.2 ohm, N-CHANNEL, Si, POWER, MOSFET |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MTU1D0305MC | 功能描述:DC/DC CONVERT +/-5V 100MA 1W SMD RoHS:是 類別:電源 - 板載 >> DC DC Converters 系列:MTU1 標準包裝:15 系列:Econoline REC7.5 類型:隔離 輸出數:1 電壓 - 輸入（最?。?18V 電壓 - 輸入（最大）:36V Voltage - Output 1:15V Voltage - Output 2:- Voltage - Output 3:- 電流 - 輸出（最大）:500mA 電源（瓦） - 制造商系列:7.5W 電壓 - 隔離:2kV（2000V） 特點:具有遠程開/關功能 安裝類型:表面貼裝 封裝/外殼:24-DIP SMD 模塊（18 引線） 尺寸/尺寸:1.26" L x 0.78" W x 0.44" H（32.0mm x 19.9mm x 11.2mm） 包裝:管件 工作溫度:-40°C ~ 71°C 效率:86% 電源（瓦特）- 最大:7.5W 其它名稱:10011014 |
| MTU1D0305MC-R | 制造商:Murata Power Solutions 功能描述:- Tape and Reel 制造商:Murata Power Solutions 功能描述:MTU1D0305MC-R |
| MTU1D0505MC | 功能描述:DC/DC轉換器 1W 5Vin 5Vout 200mA Dual SMT RoHS:否 制造商:Murata 產品: 輸出功率: 輸入電壓范圍:3.6 V to 5.5 V 輸入電壓（標稱）: 輸出端數量:1 輸出電壓（通道 1）:3.3 V 輸出電流（通道 1）:600 mA 輸出電壓（通道 2）: 輸出電流（通道 2）: 安裝風格:SMD/SMT 封裝 / 箱體尺寸: |
| MTU1D0505MC-R | 功能描述:DC/DC轉換器 1W 5Vin 5Vout 200mA Dual SMT RoHS:否 制造商:Murata 產品: 輸出功率: 輸入電壓范圍:3.6 V to 5.5 V 輸入電壓（標稱）: 輸出端數量:1 輸出電壓（通道 1）:3.3 V 輸出電流（通道 1）:600 mA 輸出電壓（通道 2）: 輸出電流（通道 2）: 安裝風格:SMD/SMT 封裝 / 箱體尺寸: |
| MTU1D0509MC | 功能描述:DC/DC轉換器 1W 5Vin 9Vout 111mA Dual SMT RoHS:否 制造商:Murata 產品: 輸出功率: 輸入電壓范圍:3.6 V to 5.5 V 輸入電壓（標稱）: 輸出端數量:1 輸出電壓（通道 1）:3.3 V 輸出電流（通道 1）:600 mA 輸出電壓（通道 2）: 輸出電流（通道 2）: 安裝風格:SMD/SMT 封裝 / 箱體尺寸: |
發布緊急采購，3分鐘左右您將得到回復。