參數資料
型號: MTD1312T4
廠商: ON SEMICONDUCTOR
元件分類: JFETs
英文描述: 6 A, 30 V, 0.016 ohm, N-CHANNEL, Si, POWER, MOSFET
封裝: CASE 369A-13, DPAK-3
文件頁數: 10/12頁
文件大?。?/td> 115K
代理商: MTD1312T4
MTD1312
http://onsemi.com
7
I S
,SOURCE
CURRENT
t, TIME
Figure 11. Reverse Recovery Time (trr)
Standard Cell Density
High Cell Density
tb
trr
ta
trr
VDS, DRAIN-TO-SOURCE VOLTAGE (VOLTS)
I D
,DRAIN
CURRENT
(AMPS)
Figure 12. Maximum Rated Forward Biased
Safe Operating Area
0.1
1.0
100
10
0.1
1.0
100
dc
10 ms
1.0 ms
100 ms
VGS = 10 V
SINGLE PULSE
TC = 25°C
RDS(on) LIMIT
THERMAL LIMIT
PACKAGE LIMIT
SAFE OPERATING AREA
The Forward Biased Safe Operating Area curves define
the maximum simultaneous drain–to–source voltage and
drain current that a transistor can handle safely when it is
forward biased. Curves are based upon maximum peak
junction temperature and a case temperature (TC) of 25°C.
Peak repetitive pulsed power limits are determined by using
the thermal response data in conjunction with the procedures
discussed in AN569, “Transient Thermal Resistance –
General Data and Its Use.”
Switching between the off–state and the on–state may
traverse any load line provided neither rated peak current
(IDM) nor rated voltage (VDSS) is exceeded, and that the
transition time (tr, tf) does not exceed 10 s. In addition the
total power averaged over a complete switching cycle must
not exceed (TJ(MAX) – TC)/(R
θJC).
A power MOSFET designated E–FET can be safely used
in switching circuits with unclamped inductive loads. For
reliable operation, the stored energy from circuit inductance
dissipated in the transistor while in avalanche must be less
than the rated limit and must be adjusted for operating
conditions differing from those specified. Although industry
practice is to rate in terms of energy, avalanche energy
capability is not a constant. The energy rating decreases
non–linearly with an increase of peak current in avalanche
and peak junction temperature.
Although many E–FETs can withstand the stress of
drain–to–source avalanche at currents up to rated pulsed
current (IDM), the energy rating is specified at rated
continuous current (ID), in accordance with industry
custom. The energy rating must be derated for temperature
as shown in the accompanying graph (Figure 13). Maximum
energy at currents below rated continuous ID can safely be
assumed to equal the values indicated.
di/dt
trr
ta
tp
IS
0.25 IS
TIME
IS
tb
TJ, STARTING JUNCTION TEMPERATURE (°C)
E
25
75
150
200
100
0
Figure 13. Maximum Avalanche Energy versus
Starting Junction Temperature
,SINGLE
PULSE
DRAIN-T
O-SOURCE
AS
AV
ALANCHE
ENERGY
(mJ)
50
100
125
ID = 20 A
150
50
Figure 14. Diode Reverse Recovery Waveform
相關PDF資料
PDF描述
MTD1N50ET4 1 A, 500 V, 5 ohm, N-CHANNEL, Si, POWER, MOSFET
MTD1N50EG 1 A, 500 V, 5 ohm, N-CHANNEL, Si, POWER, MOSFET
MTD1N50E1 1 A, 500 V, 5 ohm, N-CHANNEL, Si, POWER, MOSFET
MTD1P40ET4 1 A, 400 V, 8 ohm, P-CHANNEL, Si, POWER, MOSFET
MTD1P40E 1 A, 400 V, 8 ohm, P-CHANNEL, Si, POWER, MOSFET
相關代理商/技術參數
參數描述
MTD1350 制造商:MARKTECH 制造商全稱:Marktech Corporate 功能描述:Infrared Flat Top Photo Diode
MTD1361 功能描述:馬達/運動/點火控制器和驅動器 Motor Drive IC RoHS:否 制造商:STMicroelectronics 產品:Stepper Motor Controllers / Drivers 類型:2 Phase Stepper Motor Driver 工作電源電壓:8 V to 45 V 電源電流:0.5 mA 工作溫度:- 25 C to + 125 C 安裝風格:SMD/SMT 封裝 / 箱體:HTSSOP-28 封裝:Tube
MTD1361-7101 功能描述:馬達/運動/點火控制器和驅動器 Power IC RoHS:否 制造商:STMicroelectronics 產品:Stepper Motor Controllers / Drivers 類型:2 Phase Stepper Motor Driver 工作電源電壓:8 V to 45 V 電源電流:0.5 mA 工作溫度:- 25 C to + 125 C 安裝風格:SMD/SMT 封裝 / 箱體:HTSSOP-28 封裝:Tube
MTD1361F 功能描述:馬達/運動/點火控制器和驅動器 Motor Drive IC RoHS:否 制造商:STMicroelectronics 產品:Stepper Motor Controllers / Drivers 類型:2 Phase Stepper Motor Driver 工作電源電壓:8 V to 45 V 電源電流:0.5 mA 工作溫度:- 25 C to + 125 C 安裝風格:SMD/SMT 封裝 / 箱體:HTSSOP-28 封裝:Tube
MTD1361F_10 制造商:SHINDENGEN 制造商全稱:Shindengen Electric Mfg.Co.Ltd 功能描述:Constant Current Control Function (Fixed OFF Time)