- 您現在的位置：買賣IC網 > PDF目錄45354 > MPC8245LVV350D (MOTOROLA INC) 32-BIT, 350 MHz, RISC PROCESSOR, PBGA352 PDF資料下載
參數資料
| 型號： | MPC8245LVV350D |
| 廠商： | MOTOROLA INC |
| 元件分類： | 微控制器/微處理器 |
| 英文描述： | 32-BIT, 350 MHz, RISC PROCESSOR, PBGA352 |
| 封裝： | 35 X 35 MM, 1.27 MM PITCH, LEAD FREE, TBGA-352 |
| 文件頁數： | 35/64頁 |
| 文件大?。?/td> | 893K |
| 代理商： | MPC8245LVV350D |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁當前第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁
40
MPC8245 Integrated Processor Hardware Specifications
MOTOROLA
PLL Configurations
1.6
PLL Configurations
The internal PLLs of the MPC8245 are configured by the PLL_CFG[0:4] signals. For a given
PCI_SYNC_IN (PCI bus) frequency, the PLL configuration signals set both the peripheral logic/memory
bus PLL (VCO) frequency of operation for the PCI-to-memory frequency multiplying and the MPC603e
CPU PLL (VCO) frequency of operation for memory-to-CPU frequency multiplying. The PLL
DA[14:15]
F1 J2
Output
GVDD
DRV_MEM_CTRL
2, 6
Notes:
1.
Place a pull-up resistor of 120
or less on the TEST0 pin.
2.
Treat these pins as no connects (NC) unless using debug address functionality.
3.
This pin has an internal pull-up resistor that is enabled only when the MPC8245 is in the reset state. The value of
the internal pull-up resistor is not guaranteed but is sufficient to ensure that a logic 1 is read into configuration bits
during reset if the signal is left unterminated.
4.
This pin is a reset configuration pin.
5.
DL[0] is a reset configuration pin and has an internal pull-up resistor that is enabled only when the MPC8245 is in
the reset state. The value of the internal pull-up resistor is not guaranteed but is sufficient to ensure that a logic 1
is read into configuration bits during reset.
6.
Multi-pin signals such as AD[31:0] and MDL[0:31] have their physical package pin numbers listed in order
corresponding to the signal names. Example: AD0 is on pin C22, AD1 is on pin D22,..., AD31 is on pin V25.
7.
GNT4 is a reset configuration pin and has an internal pull-up resistor that is enabled only when the MPC8245 is
in the reset state.
8.
Recommend a weak pull-up resistor (2–10 k
) be placed on this PCI control pin to LVDD.
9.
10. Recommend a weak pull-up resistor (2–10 k
) be placed on this pin to OVDD.
11. Recommend a weak pull-up resistor (2–10 k
) be placed on this pin to GVDD.
12. This pin has an internal pull-up resistor that is enabled at all times. The value of the internal pull-up resistor is not
guaranteed but is sufficient to prevent unused inputs from floating.
13. External PCI clocking source or fan-out buffer may be required for system if using the MPC8245 DUART
functionality since PCI_CLK[0:3] are not available in DUART mode. Only PCI_CLK4 is available in DUART mode.
14. This pin is a multiplexed signal and appears more than once in this table.
15. This pin is affected by programmable PCI_HOLD_DEL parameter.
16. This pin is an open-drain signal.
17. This pin can be programmed to be driven (default) or can be programmed (in PMCR2) to be open-drain.
18. This pin is a sustained three-state pin as defined by the PCI Local Bus Specification.
19. OSC_IN utilizes the 3.3-V PCI interface driver which is 5-V tolerant, see Table 2 for details.
20. PLL_CFG[0:4] signals are sampled a few clocks after the negation of HRST_CPU and HRST_CTRL.
21. SDRAM_CLK[0:3] and SDRAM_SYNC_OUT signals use DRV_MEM_CTRL for chip Rev 1.1 (A). These signals
use DRV_MEM_CLK for chip Rev 1.2 (B).
22. The 266- and 300-MHz part offerings can be run at a source voltage of 1.8 ± 100 mV or 2.0 ± 100 mV. Note that
source voltage should be 2.0 ± 100 mV for 333- and 350-MHz parts.
23. This pin was formally LAVDD on the MPC8240. It is a NC on the MPC8245. This should not pose a problem when
replacing an MPC8240 with an MPC8245.
24. The driver capability of this pin is hardwired to 40
and cannot be changed.
25. It is recommend that a weak pull-up resistor (2–10 k
) be placed on this pin to OVDD so that a 1 may be detected
at reset if an external memory clock is not being used and PLL[0:4] does not select a half-clock frequency ratio.
Table 17. MPC8245 Pinout Listing (continued)
Name
Pin Numbers
Type
Power
Supply
Output
Driver Type
Notes
相關PDF資料 |
PDF描述 |
|---|---|
| MPC8245LZU266D | 32-BIT, 266 MHz, RISC PROCESSOR, PBGA352 |
| MPC8245LVV300D | 32-BIT, 300 MHz, RISC PROCESSOR, PBGA352 |
| MPC8245LVV333D | 32-BIT, 333 MHz, RISC PROCESSOR, PBGA352 |
| MPC8245TVV300D | 32-BIT, 300 MHz, RISC PROCESSOR, PBGA352 |
| MPC8245ARVV400D | 32-BIT, 400 MHz, RISC PROCESSOR, PBGA352 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MPC8245LZU266D | 功能描述:微處理器 - MPU 266MHz 505.4MIPS RoHS:否 制造商:Atmel 處理器系列:SAMA5D31 核心:ARM Cortex A5 數據總線寬度:32 bit 最大時鐘頻率:536 MHz 程序存儲器大小:32 KB 數據 RAM 大小:128 KB 接口類型:CAN, Ethernet, LIN, SPI,TWI, UART, USB 工作電源電壓:1.8 V to 3.3 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:FBGA-324 |
| MPC8245LZU300D | 功能描述:微處理器 - MPU 300MHz 570MIPS RoHS:否 制造商:Atmel 處理器系列:SAMA5D31 核心:ARM Cortex A5 數據總線寬度:32 bit 最大時鐘頻率:536 MHz 程序存儲器大小:32 KB 數據 RAM 大小:128 KB 接口類型:CAN, Ethernet, LIN, SPI,TWI, UART, USB 工作電源電壓:1.8 V to 3.3 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:FBGA-324 |
| MPC8245LZU333D | 功能描述:微處理器 - MPU 333MHz 632.7MIPS RoHS:否 制造商:Atmel 處理器系列:SAMA5D31 核心:ARM Cortex A5 數據總線寬度:32 bit 最大時鐘頻率:536 MHz 程序存儲器大小:32 KB 數據 RAM 大小:128 KB 接口類型:CAN, Ethernet, LIN, SPI,TWI, UART, USB 工作電源電壓:1.8 V to 3.3 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:FBGA-324 |
| MPC8245LZU350D | 功能描述:微處理器 - MPU 350MHz 665MIPS RoHS:否 制造商:Atmel 處理器系列:SAMA5D31 核心:ARM Cortex A5 數據總線寬度:32 bit 最大時鐘頻率:536 MHz 程序存儲器大小:32 KB 數據 RAM 大小:128 KB 接口類型:CAN, Ethernet, LIN, SPI,TWI, UART, USB 工作電源電壓:1.8 V to 3.3 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:FBGA-324 |
| MPC8245RZU400D | 制造商:FREESCALE 制造商全稱:Freescale Semiconductor, Inc 功能描述:Part Number Specification for the MPC8245ARZUnnnX Series |
發布緊急采購，3分鐘左右您將得到回復。