- 您現在的位置：買賣IC網 > PDF目錄67998 > MPC7410RX400NE (FREESCALE SEMICONDUCTOR INC) 32-BIT, 400 MHz, RISC PROCESSOR, CBGA360 PDF資料下載
參數資料
| 型號： | MPC7410RX400NE |
| 廠商： | FREESCALE SEMICONDUCTOR INC |
| 元件分類： | 微控制器/微處理器 |
| 英文描述： | 32-BIT, 400 MHz, RISC PROCESSOR, CBGA360 |
| 封裝： | 25 X 25 MM, 3.20 MM HEIGHT, 1.27 MM PITCH, CERAMIC, BGA-360 |
| 文件頁數： | 28/73頁 |
| 文件大小： | 929K |
| 代理商： | MPC7410RX400NE |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁當前第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁
34
MPC7410 RISC Microprocessor Hardware Specications
MOTOROLA
System Design Information
1.8.3
Decoupling Recommendations
Due to the MPC7410 dynamic power management feature, large address and data buses, and high operating
frequencies, the MPC7410 can generate transient power surges and high frequency noise in its power
supply, especially while driving large capacitive loads. This noise must be prevented from reaching other
components in the MPC7410 system, and the MPC7410 itself requires a clean, tightly regulated source of
power. Therefore, it is recommended that the system designer place at least one decoupling capacitor at each
VDD, OVDD, and L2OVDD pin of the MPC7410. It is also recommended that these decoupling capacitors
receive their power from separate VDD, (L2)OVDD, and GND power planes in the PCB, utilizing short
traces to minimize inductance.
These capacitors should have a value of 0.01 F or 0.1 F. Only ceramic SMT (surface mount technology)
capacitors should be used to minimize lead inductance, preferably 0508 or 0603 orientations, where
connections are made along the length of the part.
In addition, it is recommended that there be several bulk storage capacitors distributed around the PCB,
feeding the VDD, L2OVDD, and OVDD planes, to enable quick recharging of the smaller chip capacitors.
These bulk capacitors should have a low ESR (equivalent series resistance) rating to ensure the quick
response time necessary. They should also be connected to the power and ground planes through two vias
to minimize inductance. Suggested bulk capacitors—100–330 F (AVX TPS tantalum or Sanyo OSCON).
1.8.4
Connection Recommendations
To ensure reliable operation, it is highly recommended to connect unused inputs to an appropriate signal
level through a resistor. Unused active low inputs should be tied to OVDD. Unused active high inputs should
be connected to GND. All NC (no connect) signals must remain unconnected.
Power and ground connections must be made to all external VDD, OVDD, L2OVDD, and GND pins of the
MPC7410. Note that power must be supplied to L2OVDD even if the L2 interface of the MPC7410 will not
be used; the remainder of the L2 interface may be left unterminated.
1.8.5
Output Buffer DC Impedance
The MPC7410 60x and L2 I/O drivers are characterized over process, voltage, and temperature. To measure
Z0, an external resistor is connected from the chip pad to OVDD or GND. Then, the value of each resistor is
The output impedance is the average of two components, the resistances of the pull-up and pull-down
devices. When data is held low, SW2 is closed (SW1 is open), and RN is trimmed until the voltage at the
pad equals (L2)OVDD/2. RN then becomes the resistance of the pull-down devices. When data is held high,
SW1 is closed (SW2 is open), and RP is trimmed until the voltage at the pad equals (L2)OVDD/2. RP then
becomes the resistance of the pull-up devices. RP and RN are designed to be close to each other in value.
Then, Z0 = (RP + RN)/2.
相關PDF資料 |
PDF描述 |
|---|---|
| MPC7410THX500LE | 32-BIT, 500 MHz, RISC PROCESSOR, CBGA360 |
| MPC7410RX400NE | 32-BIT, 400 MHz, RISC PROCESSOR, CBGA360 |
| MPC7410THX450LE | 32-BIT, 450 MHz, RISC PROCESSOR, CBGA360 |
| MPC7410TRX400NE | 32-BIT, 400 MHz, RISC PROCESSOR, CBGA360 |
| MPC7410THX400LE | 32-BIT, 400 MHz, RISC PROCESSOR, CBGA360 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MPC7410RX450NE | 制造商:FREESCALE 制造商全稱:Freescale Semiconductor, Inc 功能描述:MPC7410 RISC Microprocessor Hardware Specifications Addendum |
| MPC7410RX500LE | 功能描述:IC MPU 32BIT 500MHZ PPC 360-CBGA RoHS:否 類別:集成電路 (IC) >> 嵌入式 - 微處理器 系列:MPC74xx 標準包裝:2 系列:MPC8xx 處理器類型:32-位 MPC8xx PowerQUICC 特點:- 速度:133MHz 電壓:3.3V 安裝類型:表面貼裝 封裝/外殼:357-BBGA 供應商設備封裝:357-PBGA（25x25） 包裝:托盤 |
| MPC7410THX400LE | 功能描述:微處理器 - MPU NT HITCE RV1.4 1.8V -40C RoHS:否 制造商:Atmel 處理器系列:SAMA5D31 核心:ARM Cortex A5 數據總線寬度:32 bit 最大時鐘頻率:536 MHz 程序存儲器大小:32 KB 數據 RAM 大小:128 KB 接口類型:CAN, Ethernet, LIN, SPI,TWI, UART, USB 工作電源電壓:1.8 V to 3.3 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:FBGA-324 |
| MPC7410THX400NE | 制造商:Freescale Semiconductor 功能描述:MPU MPC74XX RISC 64BIT 0.18UM 400MHZ 1.8V/2.5V/3.3V 360FCCBG - Bulk |
| MPC7410THX450NE | 功能描述:微處理器 - MPU NT NITCE RV1.4,1.8V -40C RoHS:否 制造商:Atmel 處理器系列:SAMA5D31 核心:ARM Cortex A5 數據總線寬度:32 bit 最大時鐘頻率:536 MHz 程序存儲器大小:32 KB 數據 RAM 大小:128 KB 接口類型:CAN, Ethernet, LIN, SPI,TWI, UART, USB 工作電源電壓:1.8 V to 3.3 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:FBGA-324 |
發布緊急采購，3分鐘左右您將得到回復。