
MPC5534 Microcontroller Data Sheet, Rev. 5
Revision History for the MPC5534 Data Sheet
Freescale Semiconductor
52
5
Revision History for the MPC5534 Data Sheet
The history of revisions made to this data sheet are described in this section. The changes are divided into
each revision of this document.
The substantive changes incorporated in MPC5534 Data Sheet revision 4.0 to produce revision 5.0 are:
Text changes
Table and figure changes
Within each group, the changes are listed in sequential page number order.
5.1
Changes Between Revisions 4.0 and 5.0
The following table lists the substantive text changes made to paragraphs.
5.2
Changes Between Revisions 3.0 and 4.0
The following table lists the substantive text changes made to paragraphs.
Table 28. Text Changes Between Rev. 4.0 and 5.0
Location
Description of Changes
Title page:
Changed the Revision number from 4.0 to 5.0. Changed the date format to DD MMM YYYY. Made the same
changes in the lower left corner of the back page.
Updated the address of Semiconductor Equipment and Materials International
3081 Zanker Rd.
San Jose, CA., 95134
(408) 943-6900
Added footnote 9: For frequencies up to and including 80 MHz, if VDD is within ±5% of 1.5 V, then
APC = RWSC = 0b010 is a valid setting.
4 Mechanicals:
Added the following NOTE before the 208 and 324 BGA Maps:
NOTE
The MPC5500 devices are pin compatible for software portability and use the primary
function names to label the pins in the BGA diagram. Although some devices do not support
all the primary functions shown in the BGA diagram, the muxed and GPIO signals on those
pins remain available. See the signals chapter in the device reference manual for the signal
muxing.
Last paragraph: Changed the first sentence FROM . . . the voltage on the pins goes to high-impedance until . . .
TO. . .the pins go to a high-impedance state until . . .