- 您現在的位置：買賣IC網 > PDF目錄69034 > ML60851ETB (OKI ELECTRIC INDUSTRY CO LTD) UNIVERSAL SERIAL BUS CONTROLLER, PQFP44 PDF資料下載
參數資料
| 型號： | ML60851ETB |
| 廠商： | OKI ELECTRIC INDUSTRY CO LTD |
| 元件分類： | 總線控制器 |
| 英文描述： | UNIVERSAL SERIAL BUS CONTROLLER, PQFP44 |
| 封裝： | 10 X 10 MM, 0.80 MM PITCH, PLASTIC, TQFP-44 |
| 文件頁數： | 72/88頁 |
| 文件大?。?/td> | 1137K |
| 代理商： | ML60851ETB |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁當前第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁
Oki Semiconductor
ML60851E
72/84
DMA (Direct Memory Access)
It is possible to carry out 8-bit wide or 16-bit wide DMA transfer for the bulk transfer of EP1. The data bus used
is the following:
During 8-bit transfer: AD7 to AD0
During 16-bit transfer: D15 toD8, AD7 to AD0
Demand transfer and single transfer are supported. The settings of the DMA transfer mode and parameters are
done using the DMA control register and the DMA interval register described later in this manual.
In the demand transfer mode, the
DREQ pin is asserted when the reading or writing of a data packet becomes
possible. The
DREQ pin is de-asserted when the transfer of all the data of the receive packets is completed by
the external DMA controller. Therefore, other devices cannot access the local bus during DMA transfer.
On the other hand, in the single transfer mode, the
DREQ pin is de-asserted at the end of transfer of the number
of bytes (or words) of one transfer, and the other devices can access the local bus during this period.
Power-down
By setting the system control register (SYSCON) to value A0h, the oscillator circuit of the ML60851E can be
stopped and the ML60851E enters the power-down state.
The ML60851E cannot communicate with the USB bus after the internal oscillations are stopped.
In order to communicate with the USB bus after the termination of the power-down state, the internal oscillations
should be restarted and the initial settings should be done. Therefore, the ML60851E should not be powered
down during normal operation.
Note 1: Assertion of the
RESET signal causes the internal oscillations to be restarted.
Note 2: In the power-down state, reads and writes to the registers are possible but reads or writes to
FIFO are not possible.
相關PDF資料 |
PDF描述 |
|---|---|
| ML610Q346 | RISC MICROCONTROLLER, PQFP64 |
| ML610346 | RISC MICROCONTROLLER, PQFP64 |
| ML610Q347J-NNNTB | 8-BIT, FLASH, 4.2 MHz, RISC MICROCONTROLLER, PQFP64 |
| ML610347-XXXTB | 8-BIT, MROM, 4.2 MHz, RISC MICROCONTROLLER, PQFP64 |
| ML610347J-XXXTB | 8-BIT, MROM, 4.2 MHz, RISC MICROCONTROLLER, PQFP64 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| ML60852 | 制造商:OKI 制造商全稱:OKI electronic componets 功能描述:USB Device Controller |
| ML60852A | 制造商:OKI 制造商全稱:OKI electronic componets 功能描述:USB Device Controller |
| ML60852ATBZ010 | 功能描述:USB 接口集成電路 12 Mbps; USB Device Controller RoHS:否 制造商:Cypress Semiconductor 產品:USB 2.0 數據速率: 接口類型:SPI 工作電源電壓:3.15 V to 3.45 V 工作電源電流: 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:WLCSP-20 |
| ML60852ATBZ03A | 制造商:ROHM Semiconductor 功能描述: |
| ML-60-V2/80721 | 制造商:Thomas & Betts 功能描述: |
發布緊急采購，3分鐘左右您將得到回復。