參數資料
型號: MDS213CG
廠商: ZARLINK SEMICONDUCTOR INC
元件分類: 網絡接口
英文描述: 12-Port 10/100Mbps + 1Gbps Ethernet Switch
中文描述: DATACOM, LAN SWITCHING CIRCUIT, PBGA456
封裝: 35 X 35 MM, 2.33 MM HEIGHT, MS-034, HSBGA-456
文件頁數: 48/120頁
文件大小: 1678K
代理商: MDS213CG
MDS213
Data Sheet
48
Zarlink Semiconductor Inc.
Figure 18 - Time Diagram of LED Interface
12.0 Data Forwarding Protocol and Data Flow
12.1 Data Forwarding Protocol
12.1.1 Frame Reception
For normal frame reception, a 128-byte block of frame data is stored in the RxFIFO. This block may be shorter if an
End of Frame (EOF) arrives. At that point, the RxDMA will request the use of the internal memory bus. When this
memory request is granted, the RxDMA will move the block from the RxFIFO to the Frame Data Buffer (FDB).
The MAC ports are partitioned into two groups, one for the Gbps Port and one for all 12 of the 100Mbps Ports. The
service discipline is round robin for both the Gbps Port and 100/10Mbps group. After the entire frame is moved to
the frame data buffer (FDB), a switch request will be sent to the Search Engine (Reference Search Engine Section)
12.1.2 Unicast Frame Forwarding
For forwarding of the unicast frame, the Search Engine first resolves the destination device and the destination
port, and sends a switch response is sent back to the Frame Engine. The Frame Engine will obtain the type (unicast
or multicast), the destination port, and the destination device from the search response. After processing the search
response, the Frame Engine will notify the destination port that it has a frame to forward to the destination port's
TxFIFO.
For local forwarding (e.g. the destination port is in the local device), the Frame Engine will send the job to the
Transmission Scheduling queue of the destination port.
For remote forwarding (i.e. the destination port is in the remote device), the Frame Engine will create a data
forwarding request command message (DATA_FWD_REQ), which is sent via the XPipe to the remote device. The
remote Frame Engine, after receiving this DATA_FWD_REQ message, will place a job in the Transmission
Scheduling queue of the destination port.The port will serve the next job from the Transmission Scheduling queue
when the following two conditions are met:
It is enough room for a 1.5Kbyte frame (a maximum-sized frame) within the TxFIFO.
The end-of-frame (EOF) of the current frame has arrived at the TxFIFO.
One Frame
256x80nsec
Master dev sub-frame
16 slots
Slave dev sub-frame
16 slots
LED_CLKO
Cycle #0
Cycle #1 Cycle #2
Cycle #3 Cycle #4
Cycle #5 Cycle #6 Cycle #7 Cycle #8
LED_SYNCI/O
LED_DI/O
P0
bit 0
bit 1
bit 2
bit 3
bit 4
bit 5
bit 6
bit 7
bit 0
bit 1
P1
1* one pulse for every 256 cycles
相關PDF資料
PDF描述
MDS220 Analog IC
MDS221 Analog IC
MDS223 Analog IC
MDS35-800 DIODE / SCR MODULE
MDS35 DIODE / SCR MODULE
相關代理商/技術參數
參數描述
MDS217 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Analog IC
MDS-21E09 制造商:ITT Interconnect Solutions 功能描述:BACKSHELL - Bulk
MDS21P-6AA-000 制造商:Amphenol Corporation 功能描述:MICRO D/18in WIRE 26AWG 7 STRD THRU HOLE
MDS21P-6BF-000 制造商:Amphenol Corporation 功能描述:MICRO D/36in WIRE 26AWG 7 STRD FLOT
MDS21S-6AA-000 制造商:Amphenol Corporation 功能描述:MICRO D/18in WIRE 26AWG 7 STRD THRU HOLE