MC80F0208/16/24
Preliminary
112
MAR. 2005 Ver 0.2
Function
Description
Load HEX File
Load the data from the selected file storage into the memory buffer.
Save HEX File
Save the current data in your memory buffer to a disk storage by using the Intel Motorolla HEX
format.
Erase
Erase the data in your target MCU before programming it.
Blank Check
Verify whether or not a device is in an erased or unprogrammed state.
Program
This button enables you to place new data from the memory buffer into the target device.
Read
Read the data in the target MCU into the buffer for examination. The checksum will be displayed
on the checksum box.
Verify
Assures that data in the device matches data in the memory buffer. If your device is secured, a
verification error is detected.
Option Write
Progam the configuration data of target MCU. The security locking is performed with this button.
Option
Set the configuration data of target MCU. The security locking is set with this button.
AUTO
Erase & Program & Verify.
Auto Option Write
If selected with check mark, the option write is performed after erasure and write.
Edit Buffer
Modify the data in the selected address in your buffer memory
Fill Buffer
Fill the selected area with a data.
Goto
Display the selected page.
OSC. ______ MHz
Enter your target system’s oscillator value with discarding below point.
Start ______
Starting address
End ______
End address
Checksum
Display the checksum(Hexdecimal) after reading the target device.
Com Port
Select serial port.
Baud Rate
Select UART baud rate.
Select Device
Select target device.
Page Up Key
Display the previous page of your memory buffer.
Page Down Key
Display the higher page than the current location.
Table 1. ISP Function Description