
Operating Modes and On-Chip Memory
EPROM/OTPROM
M68HC11E Family — Rev. 5
Data Sheet
MOTOROLA
Operating Modes and On-Chip Memory
For More Information On This Product,
  Go to: www.freescale.com
55
ELAT — EPROM/OTPROM Latch Control Bit
When ELAT = 1, writes to EPROM cause address and data to be latched and 
the EPROM/OTPROM cannot be read. ELAT can be read any time. ELAT can 
be written any time except when EPGM = 1; then the write to ELAT is disabled. 
0 = EPROM address and data bus configured for normal reads 
1 = EPROM address and data bus configured for programming 
For the MC68HC711E9: 
a.
EPGM enables the high voltage necessary for both EEPROM and 
EPROM/OTPROM programming. 
b.
ELAT and EELAT are mutually exclusive and cannot both equal 1. 
BYTE — Byte/Other EEPROM Erase Mode Bit
Refer to 
2.5 EEPROM
. 
ROW — Row/All EEPROM Erase Mode Bit
Refer to 
2.5 EEPROM
.
ERASE — Erase Mode Select Bit
Refer to 
2.5 EEPROM
. 
EELAT — EEPROM Latch Control Bit
Refer to 
2.5 EEPROM
. 
EPGM —EPROM/OTPROM/EEPROM Programming Voltage Enable Bit
EPGM can be read any time and can be written only when ELAT = 1 (for 
EPROM/OTPROM programming) or when EELAT = 1 (for EEPROM 
programming). 
0 = Programming voltage to EPROM/OTPROM/EEPROM array 
disconnected 
1 = Programming voltage to EPROM/OTPROM/EEPROM array connected 
MBE — Multiple-Byte Programming Enable Bit
When multiple-byte programming is enabled, address bit 5 is considered a don’t 
care so that bytes with address bit 5 = 0 and address bit 5 = 1 both get 
programmed. MBE can be read in any mode and always reads 0 in normal 
modes. MBE can be written only in special modes. 
0 = EPROM array configured for normal programming 
1 = Program two bytes with the same data 
Address: $1036
Bit 7
6
5
4
3
2
1
Bit 0
Read:
MBE
ELAT
EXCOL
EXROW
T1
T0
PGM
Write:
Reset:
0
0
0
0
0
0
0
0
= Unimplemented
Figure 2-15. MC68HC711E20 EPROM Programming
Control Register (EPROG)
F
Freescale Semiconductor, Inc.
n
.