參數(shù)資料
型號: MC68HC11A8BVP2
廠商: MOTOROLA INC
元件分類: 微控制器/微處理器
英文描述: HCMOS Single-Chip Microcontroller
中文描述: 8-BIT, MROM, 2 MHz, MICROCONTROLLER, PDIP48
封裝: DIP-48
文件頁數(shù): 85/158頁
文件大?。?/td> 776K
代理商: MC68HC11A8BVP2
MC68HC11A8
TECHNICAL DATA
RESETS, INTERRUPTS, AND LOW POWER MODES
MOTOROLA
9-5
9
of reset. The DLY control bit is set to specify that an oscillator start-up delay is imposed
upon recovery from STOP mode. The clock monitor system is disabled by CME equal
zero.
9.1.3 Computer Operating Properly (COP) Reset
The MCU includes a computer operating properly watchdog system to help protect
against software failures. To use a COP watchdog timer, a watchdog timer reset se-
quence must be executed on a regular periodic basis so that the watchdog timer is
never allowed to time out.
The internal COP function includes special control bits which permit specification of
one of four time out periods and even allows the function to be disabled completely.
The COP system has a separate reset vector.
The NOCOP control bit, which determines whether or not a watchdog timeout causes
a system reset, is implemented in an EEPROM cell in the CONFIG register. Once pro-
grammed, this bit remains set (or cleared) even when no power is applied, and the
COP function is enabled or disabled independent of resident software. The NOCOP
control bit may be preempted while in special modes to prevent the COP system from
causing a hardware reset.
Two other control bits in the OPTION register select one of four timeout durations for
the COP timer. The actual timeout period is dependent on the system E clock frequen-
cy, but for reference purposes,
Table 9-1
shows the relationship between the CR1 and
CR0 control bits and the COP timeout period for various system clock frequencies.
The default reset condition of the CR1 and CR0 bits is cleared which corresponds to
the shortest timeout period.
The sequence required to reset the watchdog timer is:
1. Write $55 to the COP reset register (COPRST) at $103A, followed by
2. Write $AA to the same address.
Both writes must occur in correct order prior to timeout but, any number of instructions
may be executed between the writes. The elapsed time between adjacent software re-
set sequences must never be greater than the COP time out period. Reading the CO-
PRST register does not return meaningful data and does not affect the watchdog
timer.
Table 9-1 COP Timeout Period versus CR1 and CR0
CR1 CR0
Rate
XTAL = 12.0
MHz Timeout
–0/+10.9 ms
10.923 ms
43.691 ms
174.76 ms
699.05 ms
3.0 MHz
XTAL = 2
23
Timeout
– 0/+15.6 ms
15.625 ms
62.5 ms
250 ms
1 s
2.1 MHz
XTAL = 8.0 MHz
Timeout
– 0/+16.4 ms
16.384 ms
65.536 ms
262.14 ms
1.049 s
2.0 MHz
XTAL = 4.9152
MHz Timeout
– 0/+26.7 ms
XTAL = 4.0 MHz
Timeout
– 0/+32.8 ms
32.768 ms
131.07 ms
524.29 ms
2.1 s
1.0 MHz
XTAL = 3.6864
MHz Timeout
– 0/+35.6 ms
0
0
1
1
0
1
0
1
2
15
÷
E
2
17
÷
E
2
19
÷
E
2
21
÷
E
E =
26.667 ms
106.67 ms
426.67 ms
1.707 s
1.2288 MHz
35.556 ms
142.22 ms
568.89 ms
2.276 s
921.6 kHz
相關PDF資料
PDF描述
MC68HC11A1CFN2 HCMOS Single-Chip Microcontroller
MC68HCP11A1CFN2 HCMOS Single-Chip Microcontroller
MC68HCP11A1CFN3 HCMOS Single-Chip Microcontroller
MC68HCP11A1CP2 HCMOS Single-Chip Microcontroller
MC68HCP11A1CP3 HCMOS Single-Chip Microcontroller
相關代理商/技術參數(shù)
參數(shù)描述
MC68HC11A8FN 制造商:FREESCALE 制造商全稱:Freescale Semiconductor, Inc 功能描述:8-Bit Microcontrollers
MC68HC11A8FN1 制造商:Motorola Inc 功能描述:
MC68HC11A8MCFN2 制造商:MOTOROLA 制造商全稱:Motorola, Inc 功能描述:HCMOS Single-Chip Microcontroller
MC68HC11A8P1 制造商:Rochester Electronics LLC 功能描述:- Bulk
MC68HC11A8TS 制造商:MOTOROLA 制造商全稱:Motorola, Inc 功能描述:8-Bit Microcontrollers