- 您現在的位置：買賣IC網 > PDF目錄69027 > MC68HC05P9DWR2 (MOTOROLA INC) 8-BIT, MROM, 2.1 MHz, MICROCONTROLLER, PDSO28 PDF資料下載
參數資料
| 型號： | MC68HC05P9DWR2 |
| 廠商： | MOTOROLA INC |
| 元件分類： | 微控制器/微處理器 |
| 英文描述： | 8-BIT, MROM, 2.1 MHz, MICROCONTROLLER, PDSO28 |
| 封裝： | SOIC-28 |
| 文件頁數： | 34/88頁 |
| 文件大?。?/td> | 6557K |
| 代理商： | MC68HC05P9DWR2 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁當前第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁
4
MC68HC05E0
MOTOROLA
4-7
RESETS, INTERRUPTS AND LOW POWER MODES
4.2.2
Non-Maskable Software interrupt (SWI)
The software interrupt SWI is an executable instruction and a non-maskable interrupt: it is
executed regardless of the state of the I bit in the CCR. If the I bit is zero (interrupts enabled), SWI
is executed after interrupts which were pending when the SWI was fetched, but before interrupts
generated after the SWI was fetched. The SWI interrupt service routine address is specied by
the contents of memory locations $FFFC and $FFFD.
4.2.3
Maskable Hardware Interrupts
If the interrupt mask bit (I bit) of the CCR is set, all maskable interrupts (internal and external) are
disabled. Clearing the I bit enables interrupts.
Note:
The internal interrupt latch is cleared in the rst part of the interrupt service routine;
therefore, one external interrupt pulse could be latched and serviced as soon as the I
bit is cleared.
4.2.3.1
External Interrupt (INTX)
The interrupt request is latched immediately following the selected edge on the INTX pin. It is then
synchronized internally and serviced by the routine that has its start address contained in memory
locations $FFFA and $FFFB. The External Interrupt Mask bit (INTMX) in the Interrupt Control
Register ($000E) allows this interrupt to be masked from the processor.
4.2.3.2
Real Time Interrupt
The interrupt request is latched when the Real Time Interrupt Timer times out. It is then
synchronized internally and serviced by the routine that has its start address contained in memory
locations $FFFA and $FFFB. The Real Time Interrupt Enable bit (RTIE) in the RTI Control Register
($0018) allows this interrupt to be masked from the processor.
4.2.3.3
Port C Wake-up
The interrupt request is latched when a dened Wake-up signal appears on one of the pins of Port
C. It is then synchronized internally and serviced by the routine that has its start address contained
in memory locations $FFFA and $FFFB. The Wake-up Enable bits (WEn) in the Wake-up Enable
Register ($0013) allow these interrupts to be masked from the processor.
43
相關PDF資料 |
PDF描述 |
|---|---|
| MC68HC05RC18P | 8-BIT, MROM, 2.1 MHz, MICROCONTROLLER, PDIP28 |
| MC68HC05RC18FN | 8-BIT, MROM, 2.1 MHz, MICROCONTROLLER, PQCC44 |
| MC68HC05SR3FB | 8-BIT, MROM, 2 MHz, MICROCONTROLLER, PQFP44 |
| MC68HC05SR3CFB | 8-BIT, MROM, 2 MHz, MICROCONTROLLER, PQFP44 |
| MC68HC05T7B | 8-BIT, MROM, 2.1 MHz, MICROCONTROLLER, PDIP56 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MC68HC05P9P | 制造商:FREESCALE 制造商全稱:Freescale Semiconductor, Inc 功能描述:HCMOS MICROCONTROLLER UNIT |
| MC68HC05PV8 | 制造商:FREESCALE 制造商全稱:Freescale Semiconductor, Inc 功能描述:Techinal Data - rev 1.9 |
| MC68HC05PV8A | 制造商:FREESCALE 制造商全稱:Freescale Semiconductor, Inc 功能描述:Techinal Data - rev 1.9 |
| MC68HC05RC16 | 制造商:FREESCALE 制造商全稱:Freescale Semiconductor, Inc 功能描述:General Release Specification |
| MC68HC05RC16DW | 制造商:FREESCALE 制造商全稱:Freescale Semiconductor, Inc 功能描述:General Release Specification |
發布緊急采購，3分鐘左右您將得到回復。