參數資料
型號： MC68HC05BD3P
廠商： FREESCALE SEMICONDUCTOR INC
元件分類： 微控制器/微處理器
英文描述： 8-BIT, MROM, 2.1 MHz, MICROCONTROLLER, PDIP40
封裝： PLASTIC, DIP-40
文件頁數： 42/112頁
文件大小： 864K
代理商： MC68HC05BD3P
MC68HC05BD3
MOTOROLA
4-3
RESETS AND INTERRUPTS
4
Note:
COP time-out is prevented by periodically writing a “0” to bit 0 of address $3FF0.
If the watchdog timer is allowed to time-out, an internal reset is generated to reset the MCU.
Because the internal reset signal is used, the MCU comes out of a COP reset in the same
operating mode it was in when the COP time-out was generated.
The COP reset function is always enabled.
See Section 5.3 for more information on the COP watchdog timer.
4.2
INTERRUPTS
The MCU can be interrupted by different sources – four maskable hardware interrupt and one
non-maskable software interrupt:
External signal on the IRQ pin
Multi-Function Timer (MFT)
M-Bus Interface (MBUS)
Sync Signal Processor (SSP)
Software Interrupt Instruction (SWI)
If the interrupt mask bit (I-bit) of the CCR is set, all maskable interrupts (internal and external) are
disabled. Clearing the I-bit enables interrupts.
Interrupts cause the processor to save the register contents on the stack and to set the interrupt
mask (I-bit) to prevent additional interrupts. The RTI instruction causes the register contents to be
recovered from the stack and normal processing to resume.
Unlike reset, hardware interrupts do not cause the current instruction execution to be halted, but
are considered pending until the current instruction is complete. The current instruction is the one
already fetched and being operated on. When the current instruction is complete, the processor
checks all pending hardware interrupts. If interrupts are not masked (CCR I-bit clear) the
processor proceeds with interrupt processing; otherwise, the next instruction is fetched and
executed.
Table 4-1 shows the relative priority of all the possible interrupt sources.
4.2.1
Non-maskable Software Interrupt (SWI)
The software interrupt (SWI) is an executable instruction and a non-maskable interrupt: it is
execute regardless of the state of the I-bit in the CCR. If the I-bit is zero (interrupt enabled), SWI
is executed after interrupts that were pending when the SWI was fetched, but before interrupts
generated after the SWI was fetched. The SWI interrupt service routine address is specied by
the contents of memory locations $3FFC and $3FFD.
TPG
33
F
re
e
sc
a
le
S
e
m
ic
o
n
d
u
c
to
r,
I
Freescale Semiconductor, Inc.
For More Information On This Product,
Go to: www.freescale.com
n
c
..
.
相關PDF資料
PDF描述
MC68HC05C9AFNR2 8-BIT, MROM, 2.1 MHz, MICROCONTROLLER, PQCC44
MC68HC05C9AFNR2 8-BIT, MROM, 2.1 MHz, MICROCONTROLLER, PQCC44
MC68HC05C9ACFNR2 8-BIT, MROM, 4.2 MHz, MICROCONTROLLER, PQCC44
MC68HC05C9AMB 8-BIT, MROM, 2.1 MHz, MICROCONTROLLER, PDIP42
MC68HC05C9AMFN 8-BIT, MROM, 2.1 MHz, MICROCONTROLLER, PQCC44
相關代理商/技術參數
參數描述
MC68HC05BD5 制造商:FREESCALE 制造商全稱:Freescale Semiconductor, Inc 功能描述:High-density complementary metal oxide semiconductor (HCMOS) microcontroller unit
MC68HC05C0CP 制造商:Motorola Inc 功能描述:
MC68HC05C12 制造商:FREESCALE 制造商全稱:Freescale Semiconductor, Inc 功能描述:HCMOS MICROCONTROLLER UNITS
MC68HC05C12B 制造商:FREESCALE 制造商全稱:Freescale Semiconductor, Inc 功能描述:HCMOS MICROCONTROLLER UNITS
MC68HC05C12CP 制造商:FREESCALE 制造商全稱:Freescale Semiconductor, Inc 功能描述:HCMOS MICROCONTROLLER UNITS
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*