
MB86290A
12
s
s RECOMMENDED OPERATING CONDITIONS
*1 : The analog and PLL power supplies are included.
*2 : The HSYNC, VSYNC, and EO signals are input.
*3 : AOUTR, AOUTG, and AOUTB pins
*4 : AOUTR, AOUTG, AOUTB pins
*5 : ACOMPR, ACOMPG, ACOMPB pins
*6 : Using BCLKI at 90 MHz or more
Notes :
The VDDL and VDDH power supplies can be turned on or off in either order.
Note, however, that the VDDH voltage must not be applied alone continuously for several seconds.
Do not input the HSYNC, VSYNC or signal with the power-supply voltage not applied. (See “Input voltage”
in “s ABSOLUTE MAXIMUM RATINGS”.)
After turning the power on, input a pulse remaining at low level for at least 500 ns to the S pin. Then, set
the S pin to high level and input the RESET signal held at low level for at least 300
s.
WARNING: The recommended operating conditions are required in order to ensure the normal operation of the
semiconductor device. All of the device’s electrical characteristics are warranted when the device is
operated within these ranges.
Always use semiconductor devices within their recommended operating condition ranges. Operation
outside these ranges may adversely affect reliability and could result in device failure.
No warranty is made with respect to uses, operating conditions, or combinations not represented on
the data sheet. Users considering application outside the listed conditions are advised to contact their
FUJITSU representatives beforehand.
Parameter
Symbol
Value
Unit
Min
Typ
Max
Power-supply voltage
VDDL*1
2.3
2.5
2.7
V
VDDL*2
2.6*6
VDDH
3.0
3.3
3.6
3.5*6
Input voltage (High level)
VIH
2.0
VDDH
+ 0.3
V
VIHV*3
2.0
5.5
Input voltage (Low level)
VIL
0.3
+ 0.8
V
VILV*3
0.3
+ 0.8
VREF pin input voltage
VREF
1.05
1.10
1.15
V
VRO pin external resistor
RVRO
2.7
k
AOUT pin external resistor*4
RAOUT
75
ACOMP pin external capacitor*5
CACOMP
0.1
F
Ambient operating temperature
TA
40
+ 85
°C
+ 70*6