- 您現在的位置：買賣IC網 > PDF目錄98009 > MAXQ8913EWG+T (MAXIM INTEGRATED PRODUCTS INC) 16-BIT, FLASH, 10 MHz, RISC MICROCONTROLLER, PBGA58 PDF資料下載
參數資料
| 型號： | MAXQ8913EWG+T |
| 廠商： | MAXIM INTEGRATED PRODUCTS INC |
| 元件分類： | 微控制器/微處理器 |
| 英文描述： | 16-BIT, FLASH, 10 MHz, RISC MICROCONTROLLER, PBGA58 |
| 封裝： | ROHS COMPLIANT, WLP-58 |
| 文件頁數： | 19/22頁 |
| 文件大?。?/td> | 281K |
| 代理商： | MAXQ8913EWG+T |
MAXQ8913
16-Bit, Mixed-Signal Microcontroller with Op Amps,
ADC, and DACs for All-in-One Servo Loop Control
6
_______________________________________________________________________________________
RECOMMENDED DC OPERATING CONDITIONS (continued)
(VDVDD = VAVDD = 2.7V to 3.6V, TA = -40°C to +85°C.) (Note 1)
PARAMETER
SYMBOL
CONDITIONS
MIN
TYP
MAX
UNITS
SCLK Last Sample Edge to MOSI
Output Change (MOSI Last Hold)
tMLH
tMCK/
2 - tRF
ns
MISO Input Valid to SCLK
Sample Edge (MISO Setup)
tMIS
(Note 13)
2tRF
ns
MISO Input Hold After SCLK
Sample Edge
tMIH
0
ns
SPI: SLAVE MODE (See Figures 1, 3)
SPI Slave Operating Frequency
1/tSCK
fSYS/4
kHz
SCLK Input Pulse-Width
High/Low
tSCH, tSCL
tSCK/
2 - tRF
ns
I/O Rise/Fall Time
(This parameter is device
dependent.)
tRF
CL = 15pF, pullup = 560
16
ns
SSEL Active to First Shift Edge
tSSE
tRF
ns
MOSI Input to SCLK Sample
Edge Rise/Fall Setup
tSIS
tRF
ns
MOSI Input from SCLK Sample
Edge Transition Hold
tSIH
tRF
ns
MISO Output Valid After SCLK
Shift Edge Transition
tSOV
(Note 13)
2tRF
ns
SSEL Inactive to Next SSEL
Asserted
tSSH
tSYS +
tRF
ns
SCLK Inactive to SSEL
Deasserted
tSD
tRF
ns
MISO Output Disabled After
SSEL Edge Deasserted
tSLH
2tSYS
+ 2tRF
ns
Note 1:
Specifications to -20°C are guaranteed by design and are not production tested.
Note 2:
Connect to ground through a 1F capacitor.
Note 3:
Crystal connected to HFXIN, HFXOUT. Operating in /1 mode. Measured on the DVDD pin and the device not in reset. All
inputs are connected to GND or DVDD. Outputs do not source/sink any current. One timer B enabled, with the device exe-
cuting code from flash.
Note 4:
ISTOP is the total current into the device when the device is in stop mode.
Note 5:
Regulator, brownout disabled. Stop mode current through AVDD and DVDD.
Note 6:
Regulator disabled, brownout enabled. Stop mode current through AVDD and DVDD.
Note 7:
Regulator enabled, brownout enabled.
Note 8:
IOH(MAX) + IOL(MAX) for all outputs combined should not exceed 35mA to meet the specification.
Note 9:
VREF = VAVDD.
Note 10: The operational input voltage range for each individual input of a differentially configured pair is from GND to AVDD. The
operational input voltage difference is from -VREF/2 to +VREF/2.
Note 11: The typical value is applied when a conversion is requested with ADPMO = 0. Under these conditions, the minimum delay
is met. If ADPMO = 1, the user is responsible for ensuring the 4s delay time is met.
Note 12: Total on-board decoupling capacitance on the AVDD pin < 100nF. The output impedance of the regulator driving the
AVDD pin < 10
Ω.
Note 13: This value is the sum of input R/F and output R/F.
Note 14: Guaranteed by design and characterization.
相關PDF資料 |
PDF描述 |
|---|---|
| MB86290APFVS | GRAPHICS PROCESSOR, PQFP240 |
| MB86295S-PB-GS | GRAPHICS PROCESSOR, PBGA256 |
| MB86603 | SCSI BUS CONTROLLER, PQFP176 |
| MB86604A-PF | SCSI BUS CONTROLLER, PQFP100 |
| MB86605PMT | SCSI BUS CONTROLLER, PQFP144 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MAXQ8913EWG-T&R+ | 制造商:Maxim Integrated Products 功能描述:MAXQ8913 IMAGE STABILIZER WLF T&R - Gel-pak, waffle pack, wafer, diced wafer on film |
| MAXQ8913X-0000+ | 功能描述:16位微控制器 - MCU 16-Bit Mxd Sgnl MCU w/Op Amp ADC & DAC RoHS:否 制造商:Texas Instruments 核心:RISC 處理器系列:MSP430FR572x 數據總線寬度:16 bit 最大時鐘頻率:24 MHz 程序存儲器大小:8 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:2 V to 3.6 V 工作溫度范圍:- 40 C to + 85 C 封裝 / 箱體:VQFN-40 安裝風格:SMD/SMT |
| MAXQ-H2000 | 功能描述:子卡和OEM板 HDR BRD FOR MAX2000-RAX RoHS:否 制造商:BeagleBoard by CircuitCo 產品:BeagleBone LCD4 Boards 用于:BeagleBone - BB-Bone - Open Source Development Kit |
| MAXQ-JTAG | 功能描述:JTAG調試器 JTAG FOR PRGRAMNG/ DEBUGGING MAXQ RoHS:否 制造商:Olimex Ltd. 產品:JTAG In-Circuit Debuggers 工具用于評估:MSP430 Flash MCUs 用于:MSP430 Kick Start, MSPGCC 核心:MSP430 接口類型:JTAG, USB 工作電源電壓:12 V |
| MAXQ-JTAG-USB | 功能描述:JTAG調試器 JTAG FOR PRGRAMNG/ DEBUGGING MAXQ RoHS:否 制造商:Olimex Ltd. 產品:JTAG In-Circuit Debuggers 工具用于評估:MSP430 Flash MCUs 用于:MSP430 Kick Start, MSPGCC 核心:MSP430 接口類型:JTAG, USB 工作電源電壓:12 V |
發布緊急采購，3分鐘左右您將得到回復。