參數資料
型號： M37906M4C-XXXFP
元件分類： 微控制器/微處理器
英文描述： 16-BIT, MROM, 20 MHz, MICROCONTROLLER, PDSO42
封裝： 0.450 INCH, 0.80 MM PITCH, PLASTIC, SSOP-42
文件頁數： 85/99頁
文件大?。?/td> 1313K
代理商： M37906M4C-XXXFP
109
8168C-MCU Wireless-02/10
AT86RF212
The map EU1 takes more supply current than the North American map and uses the
normal (linearized) PA mode to provide medium output power up to -1 dBm for
O-QPSK-SIN-RC-{100/200/400} modes and 4 dBm for BPSK-20 mode.
The map EU2 uses the boost mode to provide higher TX power levels at the expense of
higher supply current. As a result, the maximum TX power is 2 dBm for O-QPSK-SIN-
RC-{100/200/400} and 5 dBm for BPSK-20.
Due to great regional distinctions of regulatory requirements, it is not possible to cover
all restrictions in this data sheet. Manufactures must take the responsibility to check
measurement results against the latest regulations of nations into which they market.
7.4 Frame Buffer
The AT86RF212 contains a 128 byte dual port SRAM. One port is connected to the SPI
interface, the other one to the internal transmitter and receiver modules. For data
communication, both ports are independent and simultaneously accessible.
The Frame Buffer utilizes the SRAM address space 0x00 to 0x7F for RX and TX
operation of the radio transceiver and can keep a single IEEE 802.15.4 RX or a single
TX frame of maximum length at a time.
Frame Buffer access modes are described in section 4.3.2. Frame Buffer access
conflicts are indicated by an underrun interrupt IRQ_6 (TRX_UR). Note that this
interrupt also occurs on the attempt to write frames longer than 127 octets to the Frame
Buffer (overflow). In this case, the content of the Frame Buffer is undefined.
Frame Buffer access is only possible if the digital voltage regulator is turned on. This is
valid in all device states except in SLEEP state. An access in P_ON state is possible
once pin 17 (CLKM) provides the 1 MHz master clock.
7.4.1 Data Management
Data in Frame Buffer (received data or data to be transmitted) can be changed by:
Frame Buffer or SRAM write access over SPI
receiving a new frame in BUSY_RX or BUSY_RX_AACK state
a change into SLEEP state
a reset
By default, there is no protection of the Frame Buffer against overwriting. Therefore, if a
frame is received during Frame Buffer read access of a previously received frame,
interrupt IRQ_6 (TRX_UR) is issued and the stored data might be overwritten.
Even so, the old frame data can be read if the SPI data rate is higher than the effective
over air data rate. For a data rate of 250 kbit/s, a minimum SPI clock rate of 1 MHz is
recommended. Finally, the microcontroller should check the transferred frame data
integrity by an FCS check.
To protect the Frame Buffer content against being overwritten by newly incoming
frames, the radio transceiver state should be changed to PLL_ON state after reception.
This can be achieved by writing the command PLL_ON to register bits TRX_CMD
(register 0x02, TRX_STATE) while or immediately after receiving the frame.
Alternatively, Dynamic Frame Buffer Protection can be used to protect received frames
against overwriting; for details, refer to section 9.7. Both procedures do not protect the
Frame Buffer from overwriting by the microcontroller.
相關PDF資料
PDF描述
M37906M8C-XXXFP 16-BIT, MROM, 20 MHz, MICROCONTROLLER, PDSO42
M37906M6C-XXXSP 16-BIT, MROM, 20 MHz, MICROCONTROLLER, PDIP42
M37906M4C-XXXFP 16-BIT, MROM, 20 MHz, MICROCONTROLLER, PDSO42
M37906M4C-XXXSP 16-BIT, MROM, 20 MHz, MICROCONTROLLER, PDIP42
M37906M4H-XXXSP 16-BIT, MROM, 20 MHz, MICROCONTROLLER, PDIP42
相關代理商/技術參數
參數描述
M37906M4C-XXXSP 制造商:RENESAS 制造商全稱:Renesas Technology Corp 功能描述:16-BIT CMOS MICROCOMPUTER
M37906M4H-XXXFP 制造商:RENESAS 制造商全稱:Renesas Technology Corp 功能描述:16-BIT CMOS MICROCOMPUTER
M37906M6C-XXXFP 制造商:RENESAS 制造商全稱:Renesas Technology Corp 功能描述:16-BIT CMOS MICROCOMPUTER
M37906M6C-XXXSP 制造商:RENESAS 制造商全稱:Renesas Technology Corp 功能描述:16-BIT CMOS MICROCOMPUTER
M37906M8C-XXXFP 制造商:RENESAS 制造商全稱:Renesas Technology Corp 功能描述:16-BIT CMOS MICROCOMPUTER
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*