- 您現在的位置：買賣IC網 > PDF目錄30770 > LTC3766IGN#TRPBF (LINEAR TECHNOLOGY CORP) SWITCHING CONTROLLER, 316 kHz SWITCHING FREQ-MAX, PDSO28 PDF資料下載
參數資料
| 型號： | LTC3766IGN#TRPBF |
| 廠商： | LINEAR TECHNOLOGY CORP |
| 元件分類： | 穩壓器 |
| 英文描述： | SWITCHING CONTROLLER, 316 kHz SWITCHING FREQ-MAX, PDSO28 |
| 封裝： | 0.150 INCH, LEAD FREE, PLASTIC, SSOP-28 |
| 文件頁數： | 60/60頁 |
| 文件大?。?/td> | 607K |
| 代理商： | LTC3766IGN#TRPBF |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁當前第60頁
LTC3766
9
3766f
PIN FUNCTIONS (SSOP/QFN)
FGD (Pin 20/Pin 17): Forward Gate Rising Edge Delay. A
resistor to GND sets the delay from PT+ rising to FG rising
(and SG falling). This delay is used to optimize the dead
time between the turn-off of SG and the turn-on of the
primary-side MOSFET. In standalone mode (100k or 50k
resistor on MODE), this dead time is set adaptively and
the FGD pin can be grounded. See Setting the Gate Driver
Delays in the Applications Information section.
NDRV (Pin 21/Pin 18): Drive Output for the External Pass
Device of the High Voltage Linear Regulator Controller.
Connect to the base (NPN) or gate (MOSFET) of an exter-
nal N-type device. Tie to VCC pin if only using the internal
LDO (VAUX pin).
VIN (Pin 22/Pin 19): Connect to a higher voltage bias
supply when using the linear regulator controller. The VIN
pin supplies bias to the internal standby and monitoring
circuits, the linear regulator controller, and the differential
amplifier. Tie to VAUX pin if only using the internal LDO.
SW (Pin 23/Pin 20): Connect (Kelvin) to the drain of the
synchronous MOSFET. This input is used for adaptive
shoot-through prevention and leading-edge blanking,
monitoringthehighlevelSWnodevoltageandSGreverse-
current protection. When SW is high, the voltage on this
pin is internally measured for use in the inductor ripple
cancellation and volt-second limit circuits. When SW is
low and SG is high, this pin sources a small current and
is used for SG reverse overcurrent protection. A resistor
can be placed between the SW pin and the drain of the
synchronousMOSFETtoadjusttheSGreverse-overcurrent
threshold. The SW pin is internally clamped to 50V.
VAUX (Pin 24/Pin 21): Auxiliary Power Input. This is the
power input to an internal LDO that is connected to VCC.
Whenever VAUXisgreaterthan4.7V(or8Vforhighvoltage
mode), this LDO will supply power to VCC, bypassing the
main linear regulator that is powered from VIN. See VAUX
Connection in the Applications Information section. Do
not exceed 16V on the VAUX pin.
PT–,PT+(Pin25,26/Pin22,23):PulseTransformerDriver
Outputs. For most applications, these connect to a pulse
transformer through a series DC-blocking capacitor. The
PWM information is multiplexed together with DC power
andsentthroughthepulsetransformertotheprimaryside.
The PWM signal is then decoded by the LTC3765 active
clamp forward controller and gate driver. In standalone
mode (100k or 50k resistor on MODE), the PT+ pin has a
standard PWM signal and may be directly connected to
the gate of a primary-side MOSFET, while a reference clock
is generated on the PT– pin.
PGND (Pin 27/Pin 24): Gate Driver Ground Pin. Connect to
power ground at the source of the synchronous MOSFET.
VCC (Pin 28/Pin 25): Main VCC Input for All Driver and
Control Circuitry.
相關PDF資料 |
PDF描述 |
|---|---|
| LTC3766MPUFD#PBF | SWITCHING CONTROLLER, 316 kHz SWITCHING FREQ-MAX, PQCC28 |
| LTC3766EUFD#PBF | SWITCHING CONTROLLER, 316 kHz SWITCHING FREQ-MAX, PQCC28 |
| LTC3805EDD | SWITCHING CONTROLLER, 700 kHz SWITCHING FREQ-MAX, PDSO10 |
| LTC3805EMSE | SWITCHING CONTROLLER, 700 kHz SWITCHING FREQ-MAX, PDSO10 |
| LTC3805HMSE#TR | SWITCHING CONTROLLER, 700 kHz SWITCHING FREQ-MAX, PDSO10 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LTC3766IUFD#PBF | 功能描述:IC CONTROLLER SYNCH 28QFN RoHS:是 類別:集成電路 (IC) >> PMIC - 電源控制器，監視器 系列:Direct Flux Limit™, PolyPhase® 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:2,500 系列:- 應用:多相控制器 輸入電壓:- 電源電壓:9 V ~ 14 V 電流 - 電源:- 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:40-WFQFN 裸露焊盤 供應商設備封裝:40-TQFN-EP（5x5） 包裝:帶卷 (TR) |
| LTC3766IUFD#TRPBF | 功能描述:IC CONTROLLER SYNCH 28QFN RoHS:是 類別:集成電路 (IC) >> PMIC - 電源控制器，監視器 系列:Direct Flux Limit™, PolyPhase® 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:2,500 系列:- 應用:多相控制器 輸入電壓:- 電源電壓:9 V ~ 14 V 電流 - 電源:- 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:40-WFQFN 裸露焊盤 供應商設備封裝:40-TQFN-EP（5x5） 包裝:帶卷 (TR) |
| LTC3766MPGN#PBF | 功能描述:IC CONTROLLER SYNCH 28SSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 電源控制器，監視器 系列:Direct Flux Limit™, PolyPhase® 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:2,500 系列:- 應用:多相控制器 輸入電壓:- 電源電壓:9 V ~ 14 V 電流 - 電源:- 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:40-WFQFN 裸露焊盤 供應商設備封裝:40-TQFN-EP（5x5） 包裝:帶卷 (TR) |
| LTC3766MPGN#TRPBF | 功能描述:IC CONTROLLER SYNCH 28SSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 電源控制器，監視器 系列:Direct Flux Limit™, PolyPhase® 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:2,500 系列:- 應用:多相控制器 輸入電壓:- 電源電壓:9 V ~ 14 V 電流 - 電源:- 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:40-WFQFN 裸露焊盤 供應商設備封裝:40-TQFN-EP（5x5） 包裝:帶卷 (TR) |
| LTC3766MPUFD#PBF | 功能描述:IC CONTROLLER SYNCH 28QFN RoHS:是 類別:集成電路 (IC) >> PMIC - 電源控制器，監視器 系列:Direct Flux Limit™, PolyPhase® 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:2,500 系列:- 應用:多相控制器 輸入電壓:- 電源電壓:9 V ~ 14 V 電流 - 電源:- 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:40-WFQFN 裸露焊盤 供應商設備封裝:40-TQFN-EP（5x5） 包裝:帶卷 (TR) |
發布緊急采購，3分鐘左右您將得到回復。