參數資料
型號： LTC1704EGN#TRPBF
廠商： Linear Technology
文件頁數： 26/28頁
文件大?。?/td> 347K
描述： IC REG DL BUCK/LINEAR 16SSOP
標準包裝： 2,500
拓撲： 降壓（降壓）（1），線性（LDO）（1）
功能： 任何功能
輸出數： 2
頻率 - 開關： 550kHz
電壓/電流 - 輸出 1： 控制器
電壓/電流 - 輸出 2： 控制器
帶 LED 驅動器： 無
帶監控器： 無
帶序列發生器： 無
電源電壓： 3.15 V ~ 5.5 V
工作溫度： -40°C ~ 85°C
安裝類型： 表面貼裝
封裝/外殼： 16-SSOP（0.154"，3.90mm 寬）
供應商設備封裝： 16-SSOP
包裝： 帶卷 (TR)
LTC1704/LTC1704B
26
1704bfa
reduces the available base current to minimize the I
LOAD
 "
V
CE
 product across the pass transistor. The amount of
current reduction depends on the REGFB pin voltage and
the R
REGILM
 resistance (refer to the Typical Performance
Characteristics Curves). This current limit foldback scheme
limits the NPN power dissipation and prevents it from
blowing up. However, in cases when there is a constant
current load at the regulator output, this current limit
foldback scheme can create a start-up problem. In spite of
this, most applications do not have full load requirement
during start-up. To fulfill majority applications require-
ments, the LTC1704 linear regulator allows a small amount
of base current when the linear regulator output is shorted
or V
REGFB
= 0V. The actual regulator short-circuit current
can be calculated from the following equation:
I
h   mA
V
R
SH  FE
REGON
REGILM
=
+
?/DIV>
?/DIV>
?/DIV>
?/DIV>
?/DIV>
?/DIV>
48
08
300
.
 .
"
This short-circuit current should be checked against the
load requirement to allow proper start-up.
Linear Regulator Power Down
The linear regulator can be powered down easily. A pull-
down device (MOFF as shown in Figure 13) that is capable
of overcoming the REGILM pin 1.9礎 weak pull-up current
can shut down the linear regulator. As shown in Figure 13,
if the resistor R
REGILM
 is smaller than 400k, forcing
V
REGON
 to ground can overcome the pull-up current and
power down the linear regulator. When both the REGILM
and RUN/SS pins are forced low, LTC1704 enters shut-
down mode and the quiescent current is reduced to 75礎.
Linear Regulator Turn-On Delay
The external capacitor C
DELAY
from the REGILM pin to
ground allows the REGILM pin to ramp up slowly and adds
APPLICATIO S I FOR ATIO
U
U
U
a delay to the turn-on time of the linear regulator. The
current through the resistor R
REGILM
, the internal pull-up
current and the external capacitor C
DELAY
 controls the
REGILM pin slew rate. To power up the linear regulator,
the potential at the REGILM pin should not be below 0.8V.
To add power sequencing to the linear regulator is easy.
Once the current limit resistor R
REGILM
 is chosen, the
capacitor C
DELAY
 can be added to program the turn on
delay using the following equation:
t
C
V
R
A
DELAY
DELAY
REGON
REGILM
=
+  ?/DIV>
08
08
19
. "
 .
.
The actual turn-on delay, which includes the time for the
external NPN to charge the output capacitor, will be longer
than the calculated value.
The LTC1704 linear regulator turn-on delay circuit is
versatile; C
DELAY
 capacitance should be larger than 100pF
to allow instantaneous power up to seconds long delay.
Linear Regulator Output Bypass Capacitor
The linear regulator requires the use of an output capacitor
as part of the frequency compensation network. A mini-
mum output capacitor of 10礔 with an ESR lower than
100m& is recommended to prevent oscillations. Larger
values of output capacitance with low ESR should be used
to provide improved transient response for large load
current changes.
Many different types of capacitors are available and have
widely varying characteristics. These capacitors differ in
capacitor tolerance (sometimes ranging up to ?00%),
equivalent series resistance, equivalent series inductance
and capacitance temperature coefficient. Low ESR tanta-
lum capacitors are recommended for this linear regulator.
相關PDF資料
PDF描述
LTC1966MPMS8#TRPBF IC RMS/DC CONV MICROPWR 8-MSOP
LTC1967IMS8#TRPBF IC CONVERTER RMS-DC PREC 8MSOP
LTC1968IMS8#TRPBF IC CONVERTER RMS-DC PREC 8MSOP
LTC3100EUD#TRPBF IC REG BUCK/BOOST/LINEAR 16-QFN
LTC3104IMSE#TRPBF IC REG DL BCK/LINEAR SYNC 16MSOP
相關代理商/技術參數
參數描述
LTC1705EGN 功能描述:IC PWR SUPPLY CONTROLLER 28SSOP RoHS:否 類別:集成電路 (IC) >> PMIC - 電源控制器，監視器 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:2,500 系列:- 應用:多相控制器 輸入電壓:- 電源電壓:9 V ~ 14 V 電流 - 電源:- 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:40-WFQFN 裸露焊盤 供應商設備封裝:40-TQFN-EP（5x5） 包裝:帶卷 (TR)
LTC1705EGN#PBF 功能描述:IC PWR SUPPLY CONTROLLER 28SSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 電源控制器，監視器 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:2,500 系列:- 應用:多相控制器 輸入電壓:- 電源電壓:9 V ~ 14 V 電流 - 電源:- 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:40-WFQFN 裸露焊盤 供應商設備封裝:40-TQFN-EP（5x5） 包裝:帶卷 (TR)
LTC1705EGN#TR 功能描述:IC PWR SUPPLY CONTROLLER 28SSOP RoHS:否 類別:集成電路 (IC) >> PMIC - 電源控制器，監視器 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:2,500 系列:- 應用:多相控制器 輸入電壓:- 電源電壓:9 V ~ 14 V 電流 - 電源:- 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:40-WFQFN 裸露焊盤 供應商設備封裝:40-TQFN-EP（5x5） 包裝:帶卷 (TR)
LTC1705EGN#TRPBF 功能描述:IC PWR SUPPLY CONTROLLER 28SSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 電源控制器，監視器 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:2,500 系列:- 應用:多相控制器 輸入電壓:- 電源電壓:9 V ~ 14 V 電流 - 電源:- 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:40-WFQFN 裸露焊盤 供應商設備封裝:40-TQFN-EP（5x5） 包裝:帶卷 (TR)
LTC1706CS8-19 功能描述:IC VID VOLTAGE PROGRAMMER 8SOIC RoHS:否 類別:集成電路 (IC) >> PMIC - 電源控制器，監視器 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:2,500 系列:- 應用:多相控制器 輸入電壓:- 電源電壓:9 V ~ 14 V 電流 - 電源:- 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:40-WFQFN 裸露焊盤 供應商設備封裝:40-TQFN-EP（5x5） 包裝:帶卷 (TR)
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*