- 您現在的位置：買賣IC網 > Datasheet目錄41 > LTC1704EGN#TRPBF (Linear Technology)IC REG DL BUCK/LINEAR 16SSOP Datasheet資料下載
參數資料
| 型號： | LTC1704EGN#TRPBF |
| 廠商： | Linear Technology |
| 文件頁數： | 25/28頁 |
| 文件大?。?/td> | 347K |
| 描述： | IC REG DL BUCK/LINEAR 16SSOP |
| 標準包裝： | 2,500 |
| 拓?fù)洌?/td> | 降壓（降壓）（1），線性（LDO）（1） |
| 功能： | 任何功能 |
| 輸出數： | 2 |
| 頻率 - 開關： | 550kHz |
| 電壓/電流 - 輸出 1： | 控制器 |
| 電壓/電流 - 輸出 2： | 控制器 |
| 帶 LED 驅動器： | 無 |
| 帶監控器： | 無 |
| 帶序列發生器： | 無 |
| 電源電壓： | 3.15 V ~ 5.5 V |
| 工作溫度： | -40°C ~ 85°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 16-SSOP（0.154"，3.90mm 寬） |
| 供應商設備封裝： | 16-SSOP |
| 包裝： | 帶卷 (TR) |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁當前第25頁第26頁第27頁第28頁
LTC1704/LTC1704B
25
1704bfa
where V
BE(QEXT)
is base emitter voltage of QEXT and
V
DROPOUT
is the LTC1704 linear regulator controller drop-
out voltage.
The MJD44H11 from ON Semiconductor has a V
BE
of
around 0.9V at I
C
= 2A, 25癈 and the LTC1704s V
DROPOUT
is 1.1V maximum with 30mA of drive current.
If the computed minimum V
CC
is less than the LTC1704
requirement of 3.15V then 3.15V should be used.
The minimum V
INREG
is determined by the V
CE
saturation
voltage of QEXT when it is driven with a base current equal
to the maximum REGDR pin drive current. The D44H11
has a saturation voltage of around 0.2V at I
C
= 2A, 25癈.
A typical 1.5V V
OUTREG
, 2A application will need a mini-
mum V
CC
of 1.5V + 0.9V + 1.1V = 3.5V and a minimum
V
INREG
of 1.5V + 0.2V = 1.7V to operate.
If a V
OUTREG
of 0.8V is needed, the minimum V
CC
should
be 3.15V and the minimum V
INREG
is 0.8V + 0.2V = 1V.
External NPN Pass Transistor
The external NPN Pass transistor for the LTC1704 linear
regulator supply should be selected based on the follow-
ing criteria:
1. Maximum output current
2. DC current gain h
FE
3. Total allowable power dissipation
4. Gain bandwidth product f
T
The NPN transistor must be able to supply the maximum
operating current for the linear regulator supply. At the
same time, the DC current gain h
FE
must be large enough
such that the pass transistor can supply the maximum
load current with 30mA of base current. The transistor
must not be subjected to power dissipation higher than
the rated value, both during normal operation and over-
load conditions. Heat sink can be used to increase the
alloweable power dissipation rating. The gain bandwidth
product f
T
of the transistor determines how fast the linear
regulator can follow an output load change without losing
voltage regulation.
The MJD44H11 from ON Semiconductor and SGS-
Thomson can be used in the LTC1704 linear regulator
supply with current ratings up to 2A. The MJD44H11 from
ON Semiconductor can supply 8A of output current and
the minimum DC Current Gain h
FE
is 60 at IC = 2A. The
power dissipation rating is 1.75W without heat sink and
the gain bandwidth product f
T
of the MJD44H11 is typi-
cally 50MHz.
Linear Regulator Supply Current Limit Programming
The LTC1704 linear regulator uses an external resistor
R
REGILM
to program the NPN pass transistor base current.
This indirectly programs the linear regulator current limit
threshold. Figure 13 shows the setup. One end of the
resistor R
REGILM
is connected to an external voltage
source V
REGON
or, alternatively, it can be connected to the
V
CC
pin. The other end of the resistor is connected to the
REGILM pin. REGILM is internally regulated to 0.8V. The
voltage difference across this resistor generates the
REGILM pin input current. This current, together with the
internal 1.9礎 current source, programs the REGDR maxi-
mum output current. The actual linear regulator current
limit depends on the pass transistors widely distributed
DC current gain h
FE
, which makes this current limit scheme
not particularly accurate. Nevertheless, this method re-
moves the expensive current sense resistor and with
careful design, it is sufficient to protect the external NPN
from over damaging.
The following equation shows the relationship between
R
REGILM
and the linear regulator current limit threshold
I
LT
:
R
V
I
h
mA
REGILM
REGON
LT
FE
=
(
)( )
?/DIV>
?/DIV>
?/DIV>
?/DIV>
?/DIV>
?/DIV>
.
.
08 2100
75
where V
REGON
is the pull-up voltage source for R
REGILM
(see Figure 13).
When there is an overload at the linear regulator output,
the current limit circuit fires and the output voltage drops.
To protect the NPN from excessive heating, the controller
APPLICATIO S I FOR ATIO
U
U
U
相關PDF資料 |
PDF描述 |
|---|---|
| LTC1966MPMS8#TRPBF | IC RMS/DC CONV MICROPWR 8-MSOP |
| LTC1967IMS8#TRPBF | IC CONVERTER RMS-DC PREC 8MSOP |
| LTC1968IMS8#TRPBF | IC CONVERTER RMS-DC PREC 8MSOP |
| LTC3100EUD#TRPBF | IC REG BUCK/BOOST/LINEAR 16-QFN |
| LTC3104IMSE#TRPBF | IC REG DL BCK/LINEAR SYNC 16MSOP |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LTC1705EGN | 功能描述:IC PWR SUPPLY CONTROLLER 28SSOP RoHS:否 類別:集成電路 (IC) >> PMIC - 電源控制器，監視器 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:2,500 系列:- 應用:多相控制器 輸入電壓:- 電源電壓:9 V ~ 14 V 電流 - 電源:- 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:40-WFQFN 裸露焊盤 供應商設備封裝:40-TQFN-EP（5x5） 包裝:帶卷 (TR) |
| LTC1705EGN#PBF | 功能描述:IC PWR SUPPLY CONTROLLER 28SSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 電源控制器，監視器 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:2,500 系列:- 應用:多相控制器 輸入電壓:- 電源電壓:9 V ~ 14 V 電流 - 電源:- 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:40-WFQFN 裸露焊盤 供應商設備封裝:40-TQFN-EP（5x5） 包裝:帶卷 (TR) |
| LTC1705EGN#TR | 功能描述:IC PWR SUPPLY CONTROLLER 28SSOP RoHS:否 類別:集成電路 (IC) >> PMIC - 電源控制器，監視器 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:2,500 系列:- 應用:多相控制器 輸入電壓:- 電源電壓:9 V ~ 14 V 電流 - 電源:- 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:40-WFQFN 裸露焊盤 供應商設備封裝:40-TQFN-EP（5x5） 包裝:帶卷 (TR) |
| LTC1705EGN#TRPBF | 功能描述:IC PWR SUPPLY CONTROLLER 28SSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 電源控制器，監視器 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:2,500 系列:- 應用:多相控制器 輸入電壓:- 電源電壓:9 V ~ 14 V 電流 - 電源:- 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:40-WFQFN 裸露焊盤 供應商設備封裝:40-TQFN-EP（5x5） 包裝:帶卷 (TR) |
| LTC1706CS8-19 | 功能描述:IC VID VOLTAGE PROGRAMMER 8SOIC RoHS:否 類別:集成電路 (IC) >> PMIC - 電源控制器，監視器 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:2,500 系列:- 應用:多相控制器 輸入電壓:- 電源電壓:9 V ~ 14 V 電流 - 電源:- 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:40-WFQFN 裸露焊盤 供應商設備封裝:40-TQFN-EP（5x5） 包裝:帶卷 (TR) |
發布緊急采購，3分鐘左右您將得到回復。