參數資料
型號： LTC1704EGN#TRPBF
廠商： Linear Technology
文件頁數： 11/28頁
文件大小： 347K
描述： IC REG DL BUCK/LINEAR 16SSOP
標準包裝： 2,500
拓?fù)洌?/td> 降壓（降壓）（1），線性（LDO）（1）
功能： 任何功能
輸出數： 2
頻率 - 開關： 550kHz
電壓/電流 - 輸出 1： 控制器
電壓/電流 - 輸出 2： 控制器
帶 LED 驅動器： 無
帶監控器： 無
帶序列發生器： 無
電源電壓： 3.15 V ~ 5.5 V
工作溫度： -40°C ~ 85°C
安裝類型： 表面貼裝
封裝/外殼： 16-SSOP（0.154"，3.90mm 寬）
供應商設備封裝： 16-SSOP
包裝： 帶卷 (TR)
LTC1704/LTC1704B
11
1704bfa
APPLICATIO S I FOR ATIO
U
U
U
Overcurrent protection is achieved by limiting the drive
current. The input current at the REGILM pin programs the
current limit threshold. Refer to the Linear Regulator
Supply Current Limit Programming section for more
information on choosing R
REGILM
. The linear regulator
controller employs a foldback current limit scheme for
overcurrent protection. Under a short-circuit condition,
the external NPN transistor is subjected to the full input
voltage across its collector-emitter terminal. This increases
the power dissipation of the NPN and may eventually
cause damage to the transistor. LTC1704 overcomes this
problem by using a foldback current limit scheme whereby
the available drive current is reduced as the output voltage
at REGFB pin drops. This limits the power dissipation and
prevents catastrophic damage to the external NPN.
ARCHITECTURE DETAILS
Switcher Supply Architecture
The LTC1704 switcher supply is designed to operate as a
synchronous buck converter (Figure 1). The controller
includes two high power MOSFET gate drivers to control
the external N-channel MOSFETs QT and QB. The drivers
have 0.5& output impedances and can carry over an amp
of continuous current with peak currents up to 5A to slew
large MOSFET gates quickly. The drain of QT is connected
to the input supply and the source of QT connected to the
switching node SW. QB is the synchronous rectifier with
its drain at SW and its source at PGND. SW is connected
to one end of the inductor, with the other end connected
to V
OUTSW
. The output capacitor is connected from V
OUTSW
to PGND.
When a switching cycle begins, QB is turned off and QT is
turned on. SW rises almost immediately to V
IN
 and the
inductor current begins to increase. When the PWM pulse
completes, QT turns off and one nonoverlap interval later,
QB turns on. Now SW drops to PGND and the inductor
current decreases. The cycle repeats with the next tick of
the master clock. The percentage of time spent in each
mode is controlled by the duty cycle of the PWM signal,
which in turn is controlled by the feedback amplifier. The
master clock runs at a 550kHz rate and turns QT once
every 1.8祍. In a typical application with a 5V input and a
1.5V output, the duty cycle will be set at 1.5/5 " 100% or
30% by the feedback loop. This will give roughly a 540ns
on-time for QT and a 1.26祍 on-time for QB.
This constant frequency operation brings with it a couple
of benefits. Inductor and capacitor values can be chosen
with a precise operating frequency in mind and the feed-
back loop components can be similarly tightly specified.
Noise generated by the circuit will always be in a known
frequency band with the 550kHz frequency designed to
leave the 455kHz IF band free of interference. Subharmonic
oscillation and slope compensation, common headaches
with constant frequency current mode switchers, are
absent in voltage mode designs like the LTC1704. During
the time that QT is on, its source (the SW pin) is at V
IN
. V
IN
is also the power supply for the LTC1704. However, QT
requires V
IN
 + V
GS(ON)
 at its gate to achieve minimum R
ON
.
The LTC1704, needs to generate a gate drive signal at TG
higher than its highest supply voltage. To accomplish this,
the TG driver runs from floating supplies, with its negative
supply attached to SW and its power supply at BOOST.
This allows it to slew up and down with the source of QT.
Figure 1. Synchronous Buck Architecture
TG
SW
BG
PGND
LTC1704
QT
C
IN
QB
L
+
C
OUTSW
1704 F01
V
OUTSW
V
IN
+
Figure 2. Floating TG Driver Supply
TG
C
CP
D
CP
BOOST
SW
BG
PGND
PV
CC
LTC1704
QT
C
IN
QB
L
+
C
OUTSW
1704 F02
V
OUTSW
V
IN
+
相關PDF資料
PDF描述
LTC1966MPMS8#TRPBF IC RMS/DC CONV MICROPWR 8-MSOP
LTC1967IMS8#TRPBF IC CONVERTER RMS-DC PREC 8MSOP
LTC1968IMS8#TRPBF IC CONVERTER RMS-DC PREC 8MSOP
LTC3100EUD#TRPBF IC REG BUCK/BOOST/LINEAR 16-QFN
LTC3104IMSE#TRPBF IC REG DL BCK/LINEAR SYNC 16MSOP
相關代理商/技術參數
參數描述
LTC1705EGN 功能描述:IC PWR SUPPLY CONTROLLER 28SSOP RoHS:否 類別:集成電路 (IC) >> PMIC - 電源控制器，監視器 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:2,500 系列:- 應用:多相控制器 輸入電壓:- 電源電壓:9 V ~ 14 V 電流 - 電源:- 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:40-WFQFN 裸露焊盤 供應商設備封裝:40-TQFN-EP（5x5） 包裝:帶卷 (TR)
LTC1705EGN#PBF 功能描述:IC PWR SUPPLY CONTROLLER 28SSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 電源控制器，監視器 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:2,500 系列:- 應用:多相控制器 輸入電壓:- 電源電壓:9 V ~ 14 V 電流 - 電源:- 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:40-WFQFN 裸露焊盤 供應商設備封裝:40-TQFN-EP（5x5） 包裝:帶卷 (TR)
LTC1705EGN#TR 功能描述:IC PWR SUPPLY CONTROLLER 28SSOP RoHS:否 類別:集成電路 (IC) >> PMIC - 電源控制器，監視器 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:2,500 系列:- 應用:多相控制器 輸入電壓:- 電源電壓:9 V ~ 14 V 電流 - 電源:- 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:40-WFQFN 裸露焊盤 供應商設備封裝:40-TQFN-EP（5x5） 包裝:帶卷 (TR)
LTC1705EGN#TRPBF 功能描述:IC PWR SUPPLY CONTROLLER 28SSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 電源控制器，監視器 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:2,500 系列:- 應用:多相控制器 輸入電壓:- 電源電壓:9 V ~ 14 V 電流 - 電源:- 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:40-WFQFN 裸露焊盤 供應商設備封裝:40-TQFN-EP（5x5） 包裝:帶卷 (TR)
LTC1706CS8-19 功能描述:IC VID VOLTAGE PROGRAMMER 8SOIC RoHS:否 類別:集成電路 (IC) >> PMIC - 電源控制器，監視器 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:2,500 系列:- 應用:多相控制器 輸入電壓:- 電源電壓:9 V ~ 14 V 電流 - 電源:- 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:40-WFQFN 裸露焊盤 供應商設備封裝:40-TQFN-EP（5x5） 包裝:帶卷 (TR)
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*