參數資料
型號： LT3570IFE#TRPBF
廠商： Linear Technology
文件頁數： 13/20頁
文件大?。?/td> 288K
描述： IC REG BUCK/BST/LINEAR 20TSSOP
標準包裝： 2,500
拓?fù)洌?/td> 降壓（降壓）（1），升壓（升壓）（1），線性（LDO）（1）
功能： 車載
輸出數： 3
頻率 - 開關： 500kHz ~ 2.1MHz
電壓/電流 - 輸出 1： 可調至0.8V，1.5A
電壓/電流 - 輸出 2： 可調至0.8V，1.5A
電壓/電流 - 輸出 3： 控制器
帶 LED 驅動器： 無
帶監控器： 無
帶序列發生器： 無
電源電壓： 2.5 V ~ 36 V
工作溫度： -40°C ~ 125°C
安裝類型： 表面貼裝
封裝/外殼： 20-TSSOP（0.173"，4.40mm 寬）裸露焊盤
供應商設備封裝： 20-TSSOP-EP
包裝： 帶卷 (TR)
LT3570
13
3570fb
into a tight local loop, minimizing EMI. The input capaci-
tor must have low impedance at the switching frequency
to do this effectively and it must have an adequate ripple
current rating. The RMS input current is:
 
 
I
IN2(RMS)
=I
OUT2
"
V
OUT2
V
IN2
V
OUT2
(
)
V
IN2
<
I
OUT2
2
and is largest when V
IN2
 = 2 " V
OUT2
 (50% duty cycle).
Considering that the maximum load current is ~1.5A, RMS
ripple current will always be less than 0.75A.
The high frequency of the LT3570 reduces the energy
storage requirements of the input capacitor, so that the
capacitance required is often less than 10糉. The combi-
nation of small size and low impedance (low equivalent
series resistance or ESR) of ceramic capacitors makes
them the preferred choice. The low ESR results in very
low voltage ripple. Ceramic capacitors can handle larger
mag nitudes of ripple current than other capacitor types
of the same value. Use X5R and X7R types.
An alternative to a high value ceramic capacitor is a lower
value along with a larger electrolytic capacitor, for ex ample
a 1糉 ceramic capacitor in parallel with a low ESR tantalum
capacitor. For the electrolytic capacitor, a value larger than
10糉 will be required to meet the ESR and ripple current
requirements. Because the input capacitor is likely to see
high surge currents when the input source is applied,
tantalum capacitors should be surge rated. The manu-
facturer may also recommend operation below the rated
voltage of the capacitor. Be sure to place the 1糉 ceramic
as close as possible to the V
IN2
 and GND pins on the IC
for optimal noise immunity.
A  nal caution is in order regarding the use of ceramic
capacitors at the input. A ceramic input capacitor can
combine with stray inductance to form a resonant tank
circuit. If power is applied quickly (for example by plug ging
the circuit into a live power source), this tank can ring,
doubling the input voltage and damaging the LT3570. The
solution is to either clamp the input voltage or dampen the
tank circuit by adding a lossy capacitor in parallel with the
ceramic capacitor. For details, see Application Note 88.
Boost Input Capacitor Selection
The capacitor of a boost converter is less critical due to
the fact that the input current waveform is triangular and
does not contain large squarewave currents as found in
the output capacitor. Capacitors in the range of 10糉 to
100糉 with an ESR of 0.3?or less work well up to the
full 1.5A switch current. Higher ESR capacitors may be
acceptable at low switch currents. Input capacitor ripple
current for boost converters is:
   
I
RIPPLE
=0.3"V
IN1
"
V
OUT1
V
IN1
f"L"V
OUT1
Buck Diode Selection
The catch diode (D2 from Figure 1) conducts current only
during switch-off time. Average forward current in normal
operation can be calculated from:
 
 
I
D(AVG)
=I
OUT1
"
V
IN1
V
OUT1
V
IN1
The only reason to consider a diode with a larger current
rating than necessary for nominal operation is for the
worst-case condition of shorted output. The diode current
will then increase to the typical peak switch current.
Peak reverse voltage is equal to the regulator input volt age.
Use a diode with a reverse voltage rating greater than the
input voltage. Table 3 lists several Schottky diodes and
their manufacturers.
Table 3. Schottky Diodes
PART NUMBER
V
R
 (V)
I
AVE
 (A)    V
F
 AT 1A (mV)
On Semiconductor
MBRM120E
20
1
530
MBRM140
40
1
550
Diodes Inc.
B120
20
1
500
B130
30
1
500
International Recti er
10BQ030
30
1
420
APPLICATIONS INFORMATION
相關PDF資料
PDF描述
LT3645HMSE#TRPBF IC REG DL BUCK/LINEAR 12-MSOP
LT3694IFE-1#TRPBF IC REG TRPL BUCK/LINEAR 20TSSOP
LT4220IGN#TR IC CTLR HOTSWAP DUAL 16-SSOP
LT4250LCN8 IC CONTRLR HOT SWAP NEG 48V 8DIP
LT4254CGN IC CTRLR HOTSWAP POSVOLT 16SSOP
相關代理商/技術參數
參數描述
LT3570IUF#PBF 功能描述:IC REG TRPL BCK/BST/LINEAR 24QFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - 線性 + 切換式 系列:- 標準包裝:2,500 系列:- 拓?fù)?降壓（降壓）同步（3），線性（LDO）（2） 功能:任何功能 輸出數:5 頻率 - 開關:300kHz 電壓/電流 - 輸出 1:控制器 電壓/電流 - 輸出 2:控制器 電壓/電流 - 輸出 3:控制器 帶 LED 驅動器:無 帶監控器:無 帶序列發生器:是 電源電壓:5.6 V ~ 24 V 工作溫度:-40°C ~ 85°C 安裝類型:* 封裝/外殼:* 供應商設備封裝:* 包裝:*
LT3570IUF#TRPBF 功能描述:IC REG TRPL BCK/BST/LINEAR 24QFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - 線性 + 切換式 系列:- 標準包裝:2,500 系列:- 拓?fù)?降壓（降壓）同步（3），線性（LDO）（2） 功能:任何功能 輸出數:5 頻率 - 開關:300kHz 電壓/電流 - 輸出 1:控制器 電壓/電流 - 輸出 2:控制器 電壓/電流 - 輸出 3:控制器 帶 LED 驅動器:無 帶監控器:無 帶序列發生器:是 電源電壓:5.6 V ~ 24 V 工作溫度:-40°C ~ 85°C 安裝類型:* 封裝/外殼:* 供應商設備封裝:* 包裝:*
LT3570IUF-PBF 制造商:LINER 制造商全稱:Linear Technology 功能描述:1.5A Buck Converter, 1.5A Boost Converter and LDO Controller
LT3570IUF-TRPBF 制造商:LINER 制造商全稱:Linear Technology 功能描述:1.5A Buck Converter, 1.5A Boost Converter and LDO Controller
LT3571EUD#PBF 功能描述:IC REG BOOST ADJ 0.47A 16QFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 標準包裝:250 系列:- 類型:降壓（降壓） 輸出類型:固定 輸出數:1 輸出電壓:1.2V 輸入電壓:2.05 V ~ 6 V PWM 型:電壓模式 頻率 - 開關:2MHz 電流 - 輸出:500mA 同步整流器:是 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:6-UFDFN 包裝:帶卷 (TR) 供應商設備封裝:6-SON（1.45x1） 產品目錄頁面:1032 (CN2011-ZH PDF) 其它名稱:296-25628-2
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*