- 您現在的位置：買賣IC網 > PDF目錄1932 > LPC12D27FBD100/301 (NXP Semiconductors)MCU 32BIT ARM CORTEX-M0 100-LQFP PDF資料下載
參數資料
| 型號： | LPC12D27FBD100/301 |
| 廠商： | NXP Semiconductors |
| 文件頁數： | 30/46頁 |
| 文件大小： | 0K |
| 描述： | MCU 32BIT ARM CORTEX-M0 100-LQFP |
| 標準包裝： | 90 |
| 系列： | LPC1200 |
| 核心處理器： | ARM? Cortex?-M0 |
| 芯體尺寸： | 32-位 |
| 速度： | 45MHz |
| 連通性： | I²C，IrDA，SPI，SSP，UART/USART |
| 外圍設備： | 欠壓檢測/復位，DMA，LCD，POR，PWM，WDT |
| 輸入/輸出數： | 40 |
| 程序存儲器容量： | 128KB（128K x 8） |
| 程序存儲器類型： | 閃存 |
| RAM 容量： | 8K x 8 |
| 電壓 - 電源 (Vcc/Vdd)： | 3 V ~ 3.6 V |
| 數據轉換器： | A/D 8x10b |
| 振蕩器型： | 內部 |
| 工作溫度： | -40°C ~ 85°C |
| 封裝/外殼： | 100-LQFP |
| 包裝： | 托盤 |
| 其它名稱： | 568-8372 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁當前第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁
LPC12D27
All information provided in this document is subject to legal disclaimers.
NXP B.V. 2011. All rights reserved.
Product data sheet
Rev. 1 — 20 September 2011
36 of 46
NXP Semiconductors
LPC12D27
32-bit ARM Cortex-M0 microcontroller
11.5 I2C-bus
[1]
Parameters are valid over operating temperature range unless otherwise specified.
[2]
A device must internally provide a hold time of at least 300 ns for the SDA signal (with respect to the VIH(min) of the SCL signal) to
bridge the undefined region of the falling edge of SCL.
[3]
Cb = total capacitance of one bus line in pF. If mixed with Hs-mode devices, faster fall times are allowed.
[4]
The maximum tf for the SDA and SCL bus lines is specified at 300 ns. The maximum fall time for the SDA output stage tf is specified at
250 ns. This allows series protection resistors to be connected in between the SDA and the SCL pins and the SDA/SCL bus lines
without exceeding the maximum specified tf.
[5]
In Fast-mode Plus, fall time is specified the same for both output stage and bus timing. If series resistors are used, designers should
allow for this when considering bus timing.
[6]
tHD;DAT is the data hold time that is measured from the falling edge of SCL; applies to data in transmission and the acknowledge.
[7]
The maximum tHD;DAT could be 3.45 s and 0.9 s for Standard-mode and Fast-mode but must be less than the maximum of tVD;DAT or
tVD;ACK by a transition time. This maximum must only be met if the device does not stretch the LOW period (tLOW) of the SCL signal. If
the clock stretches the SCL, the data must be valid by the set-up time before it releases the clock.
[8]
tSU;DAT is the data set-up time that is measured with respect to the rising edge of SCL; applies to data in transmission and the
acknowledge.
[9]
A Fast-mode I2C-bus device can be used in a Standard-mode I2C-bus system but the requirement tSU;DAT = 250 ns must then be met.
This will automatically be the case if the device does not stretch the LOW period of the SCL signal. If such a device does stretch the
LOW period of the SCL signal, it must output the next data bit to the SDA line tr(max) + tSU;DAT = 1000 + 250 = 1250 ns (according to the
Standard-mode I2C-bus specification) before the SCL line is released. Also the acknowledge timing must meet this set-up time.
Table 16.
Dynamic characteristics: I2C-bus pins
Symbol
Parameter
Conditions
Min
Max
Unit
fSCL
SCL clock
frequency
Standard-mode
0
100
kHz
Fast-mode
0
400
kHz
Fast-mode Plus 0
1
MHz
tf
fall time
of both SDA
and SCL
signals
Standard-mo
de
-
300
ns
Fast-mode
20 + 0.1
C
b
300
ns
Fast-mode
Plus
-
120
ns
tLOW
LOW period of
the SCL clock
Standard-mode
4.7
-
s
Fast-mode
1.3
-
s
Fast-mode Plus 0.5
-
s
tHIGH
HIGH period of
the SCL clock
Standard-mode
4.0
-
s
Fast-mode
0.6
-
s
Fast-mode Plus 0.26
-
s
tHD;DAT
data hold time
Standard-mode
0
-
s
Fast-mode
0
-
s
Fast-mode Plus 0
-
s
tSU;DAT
data set-up time [8][9]
Standard-mode
250
-
ns
Fast-mode
100
-
ns
Fast-mode Plus 50
-
ns
相關PDF資料 |
PDF描述 |
|---|---|
| LPC1315FBD48,551 | IC MCU 32BIT 32KB FLASH 48LQFP |
| LPC1343FBD48,151 | IC MCU 32BIT 32KB FLASH 48LQFP |
| LPC2103FBD48,151 | IC ARM7 MCU FLASH 32K 48-LQFP |
| LPC2106FBD48,151 | IC ARM7 MCU FLASH 128K 48-LQFP |
| LPC2292FBD144,551 | IC ARM7 MCU FLASH 256K 144-LQFP |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LPC12H25FBD64/301, | 功能描述:ARM微控制器 - MCU MCU RoHS:否 制造商:STMicroelectronics 核心:ARM Cortex M4F 處理器系列:STM32F373xx 數據總線寬度:32 bit 最大時鐘頻率:72 MHz 程序存儲器大小:256 KB 數據 RAM 大小:32 KB 片上 ADC:Yes 工作電源電壓:1.65 V to 3.6 V, 2 V to 3.6 V, 2.2 V to 3.6 V 工作溫度范圍:- 40 C to + 85 C 封裝 / 箱體:LQFP-48 安裝風格:SMD/SMT |
| LPC12H27FBD64/301, | 功能描述:ARM微控制器 - MCU MCU RoHS:否 制造商:STMicroelectronics 核心:ARM Cortex M4F 處理器系列:STM32F373xx 數據總線寬度:32 bit 最大時鐘頻率:72 MHz 程序存儲器大小:256 KB 數據 RAM 大小:32 KB 片上 ADC:Yes 工作電源電壓:1.65 V to 3.6 V, 2 V to 3.6 V, 2.2 V to 3.6 V 工作溫度范圍:- 40 C to + 85 C 封裝 / 箱體:LQFP-48 安裝風格:SMD/SMT |
| LPC130CTP | 功能描述:LED 光導管 Round Lightpipe 1.30" Clear RoHS:否 制造商:Bivar 產品:Light Pipes 顏色:Clear LED 大小: 主體形狀:Cylindrical 主體長度:0.125 in 材料:Polycarbonate |
| LPC-130-CTP | 制造商:Visual Communications Company (VCC) 功能描述:LIGHT PIPE SINGLE ROUND PANEL 制造商:Visual Communications Company (VCC) 功能描述:LIGHT PIPE, SINGLE, ROUND, PANEL; Length:33.02mm; Light Pipe Shape:Circular; No. of Light Pipes:1; Light Pipe Color:Clear; Light Pipe Mounting:Panel; Color:Clear Transparent; For Use With:SMD LEDs; Lens Color:Clear; Lens Style:Round ;RoHS Compliant: Yes |
| LPC130CTP-PK10 | 制造商:Visual Communications Company (VCC) 功能描述:Light Pipes |
發布緊急采購，3分鐘左右您將得到回復。