- 您現在的位置：買賣IC網 > PDF目錄358742 > LAN91C96I (SMSC Corporation) NON-PCI SINGLE-CHIP FULL DUPLES ETHERNET CONTROLLER PDF資料下載
參數資料
| 型號： | LAN91C96I |
| 廠商： | SMSC Corporation |
| 英文描述： | NON-PCI SINGLE-CHIP FULL DUPLES ETHERNET CONTROLLER |
| 中文描述： | 非PCI單芯片以太網控制器全DUPLES |
| 文件頁數： | 20/110頁 |
| 文件大?。?/td> | 655K |
| 代理商： | LAN91C96I |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁當前第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁
Non-PCI Single-Chip Full Duplex Ethernet Controller
Rev.
11/18/2004
Page 20
SMSC DS – LAN91C96I
DATASHEET
Chapter 5
Functional Description
The LAN91C96I includes an arbitrated-shared memory of 6144 bytes. Any portion of this memory can be
used for receive or transmit packets.
The MMU unit allocates RAM memory to be used for transmit and receive packets, using 256 byte pages.
The arbitration is transparent to the CPU in every sense. There is no speed penalty for Local Bus type of
machines due to arbitration. There are no restrictions on what locations can be accessed at any time.
RAM accesses as well as MMU requests are arbitrated.
The RAM is accessed by mapping it into I/O space for sequential access. Except for the RAM accesses
and the MMU request/release commands, I/O accesses are not arbitrated.
The I/O space is 16 bits wide. Provisions for 8 bit systems are handled by the bus interface.
In the system memory space, up to 64 kbytes are decoded by the LAN91C96I as expansion ROM. The
ROM expansion area is 8 bits wide.
Device configuration is done using a serial EEPROM, with support for modifications to the EEPROM at
installation time.
The CSMA/CD core implements the 802.3 MAC layer protocol. It has two independent interfaces, the data
path and the control path.
In Local Bus mode, serial EEPROM is used for configuration and IEEE Node address making it software
compatible to the LAN9xxx family of Ethernet LAN Controllers. The EEPROM is optional for Local Bus
requiring a Minimum size of 64 X 16 bit word addresses.
Both interfaces are 16 bits wide. The control path provides a set of registers used to configure and control
the block. These registers are accessible by the CPU through the LAN91C96I I/O space. The data path is
of sequential access nature and typically works in one direction at any given time. An internal DMA type of
interface connects the data path to the device RAM through the arbiter and MMU.
The CSMA/CD data path interface is not accessible to the host CPU.
The internal DMA interface can arbitrate for RAM access and request memory from the MMU when
necessary.
An encoder/decoder block interfaces the CSMA/CD block on the serial side. The encoder will do the
Manchester encoding of the transmit data at 10 Mb/s, while the decoder will recover the receive clock, and
decode received data.
Carrier and Collision detection signals are also handled by this block and relayed to the CSMA/CD block.
The encoder/decoder block can interface the network through the AUI interface pairs, or it can be
programmed to use the internal 10BASE-T transceiver and connect to a twisted pair network.
The twisted pair interface takes care of the medium dependent signaling for 10BASE-T type of networks.
It is responsible for line interface (with external pulse transformers and pre-distortion resistors), collision
detection as well as the link integrity test function.
The LAN91C96I provides a 16-bit data path into RAM. The RAM is private and can only be accessed by
the system via the arbiter. RAM memory is managed by the MMU. Byte and word accesses to the RAM
are supported.
相關PDF資料 |
PDF描述 |
|---|---|
| LAN91C96I-MS | NON-PCI SINGLE-CHIP FULL DUPLES ETHERNET CONTROLLER |
| LAN91C96I-MU | NON-PCI SINGLE-CHIP FULL DUPLES ETHERNET CONTROLLER |
| LAN91C96IQFP | NON-PCI SINGLE-CHIP FULL DUPLES ETHERNET CONTROLLER |
| LAN91C96ITQFP | NON-PCI SINGLE-CHIP FULL DUPLES ETHERNET CONTROLLER |
| LANF72351D | ETHERNET 10BASE-T LAN FILTER MODULES |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LAN91C96I_07 | 制造商:SMSC 制造商全稱:SMSC 功能描述:Non-PCI Single-Chip Full Duplex Ethernet Controller |
| LAN91C96IMS | 制造商:Microchip Technology Inc 功能描述: |
| LAN91C96I-MS | 功能描述:以太網 IC Non-PCI 10 Mbps Ethernet MAC RoHS:否 制造商:Micrel 產品:Ethernet Switches 收發器數量:2 數據速率:10 Mb/s, 100 Mb/s 電源電壓-最大:1.25 V, 3.45 V 電源電壓-最小:1.15 V, 3.15 V 最大工作溫度:+ 85 C 封裝 / 箱體:QFN-64 封裝:Tray |
| LAN91C96I-MU | 功能描述:以太網 IC Non-PCI 10 Mbps Ethernet MAC RoHS:否 制造商:Micrel 產品:Ethernet Switches 收發器數量:2 數據速率:10 Mb/s, 100 Mb/s 電源電壓-最大:1.25 V, 3.45 V 電源電壓-最小:1.15 V, 3.15 V 最大工作溫度:+ 85 C 封裝 / 箱體:QFN-64 封裝:Tray |
| LAN91C96IQFP | 功能描述:以太網 IC Non-PCI 10 Mbps Ethernet MAC RoHS:否 制造商:Micrel 產品:Ethernet Switches 收發器數量:2 數據速率:10 Mb/s, 100 Mb/s 電源電壓-最大:1.25 V, 3.45 V 電源電壓-最小:1.15 V, 3.15 V 最大工作溫度:+ 85 C 封裝 / 箱體:QFN-64 封裝:Tray |
發布緊急采購，3分鐘左右您將得到回復。