參數資料
型號: LAN91C94
廠商: SMSC Corporation
英文描述: ISA/PCMCIA SINGLE CHIP ETHERNET CONTROLLER WITH RAM
中文描述: 的ISA / PCMCIA的單芯片以太網控制器與RAM
文件頁數: 19/55頁
文件大?。?/td> 482K
代理商: LAN91C94
FEAST Fast Ethernet Controller
for PCMCIA and Generic 16-Bit Applications
SMSC DS – LAN91C110 REV. B
Page 19
Rev. 09/05/02
MULCOL - Multiple collision detected for the last transmit frame. Set when more than one collision was experienced.
Cleared when TX_SUC is high at the end of the packet being sent.
SNGLCOL - Single collision detected for the last transmit frame. Set when a collision is detected. Cleared when TX_SUC
is high at the end of the packet being sent.
TX_SUC - Last transmit was successful. Set if transmit completes without a fatal error. This bit is cleared by the start of a
new frame transmission or when TXENA is set high. Fatal errors are:
16 collisions (1/2 duplex mode only)
SQET fail and STP_SQET = 1 (1/2 duplex mode only)
FIFO Underrun
Late collision (1/2 duplex mode only)
BANK 0
OFFSET
NAME
4
RECEIVE CONTROL REGISTER
TYPE
SYMBOL
RCR
READ/WRITE
HIGH
BYTE
SOFT
RST
FILT
CAR
ABORT_E
NB
Reserved
Reserved
Reserved
STRIP
CRC
RXEN
0
0
0
0
0
0
0
0
LOW
BYTE
Reserved
Reserved
Reserved
Reserved
Reserved
ALMUL
PRMS
RX_
ABORT
0
0
0
0
0
0
0
0
SOFT_RST - Software-Activated Reset. Active high. Initiated by writing this bit high and terminated by writing the bit low.
The LAN91C110’s configuration is not preserved except for Configuration, Base, and IA0-IA5 Registers. EEPROM is not
reloaded after software reset.
FILT_CAR - Filter Carrier. When set filters leading edge of carrier sense for 12 bit times (3 nibble times). Otherwise
recognizes a receive frame as soon as carrier sense is active. (Does NOT filter RX DV on MII!)
ABORT_ENB - Enables abort of receive when collision occurs. Defaults low. When set, the LAN91C110 will
automatically abort a packet being received when the appropriate collision input is This bit has no effect if the SWFDUP
bit in the TCR is set.
STRIP_CRC - When set it strips the CRC on received frames. When clear the CRC is stored in memory following the
packet. Defaults low.
RXEN - Enables the receiver when set. If cleared, completes receiving current frame and then goes idle. Defaults low on
reset.
ALMUL - When set accepts all multicast frames (frames in which the first bit of DA is '1'). When clear accepts only the
multicast frames that match the multicast table setting. Defaults low.
PRMS - Promiscuous mode. When set receives all frames. Does not receive its own transmission unless it is in Full
Duplex!
相關PDF資料
PDF描述
LAN91C110TQFP FEAST FAST ETHERNET CONTROLLER FOR PCMCIA AND GENERIC 16-BIT APPLICATIONS
LAN91C96I NON-PCI SINGLE-CHIP FULL DUPLES ETHERNET CONTROLLER
LAN91C96I-MS NON-PCI SINGLE-CHIP FULL DUPLES ETHERNET CONTROLLER
LAN91C96I-MU NON-PCI SINGLE-CHIP FULL DUPLES ETHERNET CONTROLLER
LAN91C96IQFP NON-PCI SINGLE-CHIP FULL DUPLES ETHERNET CONTROLLER
相關代理商/技術參數
參數描述
LAN91C94TQFP 制造商:Rochester Electronics LLC 功能描述:- Bulk 制造商:SMSC 功能描述:
LAN91C95 制造商:未知廠家 制造商全稱:未知廠家 功能描述:LAN Node Controller
LAN91C95TQFP 制造商:Rochester Electronics LLC 功能描述:- Bulk 制造商:SMSC 功能描述:
LAN91C95TQFP WAF 制造商:SMSC 功能描述:
LAN91C96 制造商:SMSC 功能描述: