- 您現在的位置：買賣IC網 > PDF目錄11593 > KSZ8842-PMBL (Micrel Inc)IC ETHERNT SW 2PORT PCI 100LFBGA PDF資料下載
參數資料
| 型號： | KSZ8842-PMBL |
| 廠商： | Micrel Inc |
| 文件頁數： | 47/119頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC ETHERNT SW 2PORT PCI 100LFBGA |
| 特色產品： | Micrel Drives Ethernet Into the Global Automotive World |
| 標準包裝： | 260 |
| 控制器類型： | 以太網開關控制器 |
| 接口： | PCI |
| 電源電壓： | 3.1 V ~ 3.5 V |
| 工作溫度： | 0°C ~ 70°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 100-LFBGA |
| 供應商設備封裝： | 100-LFBGA |
| 包裝： | 托盤 |
| 產品目錄頁面： | 1081 (CN2011-ZH PDF) |
| 配用： | 576-1636-ND - BOARD EVALUATION KSZ8842-PMQL |
| 其它名稱： | 576-3089 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁當前第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁
Micrel, Inc.
KSZ8842-PMQL/PMBL
October 2007
33
M9999-100207-1.5
For ingress rate limiting, KSZ8842-PMQL/PMBL provides options to selectively choose frames from all types, multicast,
broadcast, and flooded unicast frames. The KSZ8842-PMQL/PMBL counts the data rate from those selected type of
frames. Packets are dropped at the ingress port when the data rate exceeds the specified rate limit.
For egress rate limiting, the Leaky Bucket algorithm is applied to each output priority queue for shaping output traffic.
Inter frame gap is stretched on a per frame base to generate smooth, non-bursty egress traffic. The throughput of each
output priority queue is limited by the egress rate specified.
If any egress queue receives more traffic than the specified egress rate throughput, packets may be accumulated in the
output queue and packet memory. After the memory of the queue or the port is used up, packet dropping or flow control
will be triggered. As a result of congestion, the actual egress rate may be dominated by flow control/dropping at the
ingress end, and may be therefore slightly less than the specified egress rate.
To reduce congestion, it is a good practice to make sure the egress bandwidth exceeds the ingress bandwidth.
MAC Filtering Function
Use the static table to assign a dedicated MAC address to a specific port. When a unicast MAC address is not recorded
in the static table, it is also not learned in the dynamic MAC table. The KSZ8842-PMQL/PMBL includes an option that
can filter or forward unicast packets for an unknown MAC address. This option is enabled by SGCR7[7].
The unicast MAC address filtering function is useful in preventing the broadcast of unicast packets that could degrade
the quality of this port in applications such as voice over Internet Protocol (VoIP).
Configuration Interface
The KSZ8842-PMQL/PMBL operates as a managed switch or a repeater, however it cannot be used as an unmanaged
switch.
EEPROM Interface
The external serial EEPROM with a standard microwire bus interface is used for non-volatile storage of information
such as the host MAC address and ID, (for example, 93C46 or 93C66 EEPROM devices.)
If the EEEN pin/ball is pulled high, the KSZ8842-PMQL/PMBL performs an automatic read of the external EEPROM
words 0H to 6H after the de-assertion of Reset. The EEPROM values are placed in certain host-accessible registers.
EEPROM read/write functions can also be performed by software read/writes to the EEPCR registers.
The KSZ8842-PMQL/PMBL EEPROM format is given below.
WORD
15
8
7
0
0H
Reserved
1H
Host MAC Address Byte 2
Host MAC Address Byte 1
2H
Host MAC Address Byte 4
Host MAC Address Byte 3
3H
Host MAC Address Byte 6
Host MAC Address Byte 5
4H
Subsystem ID
5H
Subsystem Vendor ID
6H
Reserved
7H-3FH
Not used by KSZ8842-PMQL/PMBL (available for user to use)
Table 7. EEPROM Format
Loop back Support
The KSZ8842-PMQL/PMBL provides loop back support for remote diagnostic of failure. In loop back mode, the speed
at both PHY ports will be set to 100BASE-TX full-duplex mode. Two types of loop back are supported: Far-end Loop
back and Near-end (Remote) Loop back.
Far-end Loop back:
Far-end loop back is conducted between the KSZ8842-PMQL/PMBL’s two PHY ports. The loop back path starts at the
“Originating” PHY. The originating PHY port’s receive inputs (RXP/RXM), wrap around at the “l(fā)oop back” PHY port’s
PMD/PMA, and ends at the “Originating” PHY port’s transmit outputs (TXP/TXM).
相關PDF資料 |
PDF描述 |
|---|---|
| KSZ8893FQL-FX | IC SWITCH ETH 3PORT 128-PQFP |
| PIC12C509AT-04E/SN | IC MCU OTP 1KX12 8SOIC |
| PIC16F1829T-I/SS | MCU PIC 14K FLASH 1K RAM 20SSOP |
| V72A24C400BL3 | CONVERTER MOD DC/DC 24V 400W |
| PIC16F677-E/SS | IC PIC MCU FLASH 2KX14 20SSOP |
相關代理商/技術參數 |
參數描述 |
|---|---|
| KSZ8842-PMBL AM | 功能描述:以太網 IC 2-Port Ethernet Switch/Repeater + 32-bit/33MHz PCI bus interface(Lead Free) RoHS:否 制造商:Micrel 產品:Ethernet Switches 收發器數量:2 數據速率:10 Mb/s, 100 Mb/s 電源電壓-最大:1.25 V, 3.45 V 電源電壓-最小:1.15 V, 3.15 V 最大工作溫度:+ 85 C 封裝 / 箱體:QFN-64 封裝:Tray |
| KSZ8842-PMBL AM TR | 功能描述:以太網 IC 2-Port Ethernet Switch/Repeater + 32-bit/33MHz PCI bus interface(Lead Free) RoHS:否 制造商:Micrel 產品:Ethernet Switches 收發器數量:2 數據速率:10 Mb/s, 100 Mb/s 電源電壓-最大:1.25 V, 3.45 V 電源電壓-最小:1.15 V, 3.15 V 最大工作溫度:+ 85 C 封裝 / 箱體:QFN-64 封裝:Tray |
| KSZ8842-PMBLAM | 制造商:Micrel 功能描述:Ethernet Switch 2-Port 10Mbps/100Mbps |
| KSZ8842-PMBL-AM | 功能描述:Ethernet Switch 10/100 Base-T/TX PHY PCI Interface 制造商:microchip technology 系列:- 包裝:托盤 零件狀態:要求報價 協議:以太網 功能:開關 接口:PCI 標準:10/100 Base-T/TX PHY 電壓 - 電源:3.1 V ~ 3.5 V 電流 - 電源:122mA 工作溫度:-40°C ~ 85°C 封裝/外殼:100-LFBGA 供應商器件封裝:* 標準包裝:260 |
| KSZ8842-PMBL-EVAL | 功能描述:以太網開發工具 2+1 Port 10/100 Ethernet Switch with 32b/33MHz PCI Interface (BGA Version) Eval Board RoHS:否 制造商:Micrel 產品:Evaluation Boards 類型:Ethernet Transceivers 工具用于評估:KSZ8873RLL 接口類型:RMII 工作電源電壓: |
發布緊急采購，3分鐘左右您將得到回復。