- 您現在的位置：買賣IC網 > PDF目錄67723 > ISP1160BD-S (ST-ERICSSON) UNIVERSAL SERIAL BUS CONTROLLER, PQFP64 PDF資料下載
參數資料
| 型號： | ISP1160BD-S |
| 廠商： | ST-ERICSSON |
| 元件分類： | 總線控制器 |
| 英文描述： | UNIVERSAL SERIAL BUS CONTROLLER, PQFP64 |
| 封裝： | 10 X 10 MM, 1.40 MM HEIGHT, PLASTIC, MS-026, SOT-314-2, LQFP-64 |
| 文件頁數： | 17/88頁 |
| 文件大?。?/td> | 394K |
| 代理商： | ISP1160BD-S |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁當前第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁
Philips Semiconductors
ISP1160
Embedded USB Host Controller
Product data
Rev. 05 — 24 December 2004
24 of 88
9397 750 13963
Koninklijke Philips Electronics N.V. 2004. All rights reserved.
The data transfer can be done via the PIO mode or the DMA mode. The data transfer
rate can go up to 15 Mbyte/s. In the DMA operation, the single-cycle or multi-cycle
burst modes are supported. Multi-cycle burst modes of 1, 4 or 8 cycles per burst are
supported for the ISP1160.
9.4.2
Data organization
PTD data is used for every data transfer between a microprocessor and the USB bus,
and the PTD data resides in the buffer RAM. For an OUT or SETUP transfer, the
payload data is placed just after the PTD, after which the next PTD is placed. For an
IN transfer, RAM space is reserved for receiving a number of bytes that is equal to the
total bytes of the transfer. After this, the next PTD and its payload data are placed
(see Figure 18).
Remark: The PTD is dened for both the ATL and ITL type data transfer. For ITL, the
PTD data is put into ITL buffer RAM, and the ISP1160 takes care of the Ping-Pong
action for the ITL buffer RAM access.
The PTD data (PTD header and its payload data) is a structure of DWORD alignment.
This means that the memory address is organized in blocks of 4 bytes. Therefore, the
rst byte of every PTD and the rst byte of every payload data are located at an
address that is a multiple of 4. Figure 19 illustrates an example in which the rst
payload data is 14 bytes long, meaning that the last byte of the payload data is at the
location 15H. The next addresses (16H and 17H) are not multiples of 4. Therefore,
the rst byte of the next PTD will be located at the next multiple-of-four address (18H).
Fig 18. Buffer RAM data organization.
MGT952
PTD of OUT transfer
RAM buffer
payload data of OUT transfer
PTD of IN transfer
empty space for IN total data
PTD of OUT transfer
payload data of OUT transfer
top
bottom
000H
7FFH
相關PDF資料 |
PDF描述 |
|---|---|
| ISP1160BD/01,118 | UNIVERSAL SERIAL BUS CONTROLLER, PQFP64 |
| ISP1160BD/01,151 | UNIVERSAL SERIAL BUS CONTROLLER, PQFP64 |
| ISP1161A1BM,557 | UNIVERSAL SERIAL BUS CONTROLLER, PQFP64 |
| ISP1181BBS,551 | UNIVERSAL SERIAL BUS CONTROLLER, PQCC48 |
| ISP1181BBS,518 | UNIVERSAL SERIAL BUS CONTROLLER, PQCC48 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| ISP1160BM | 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:Embedded Universal Serial Bus Host Controller |
| ISP1160BM,557 | 功能描述:USB 接口集成電路 USB 1.1 HOST CONTROLLER RoHS:否 制造商:Cypress Semiconductor 產品:USB 2.0 數據速率: 接口類型:SPI 工作電源電壓:3.15 V to 3.45 V 工作電源電流: 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:WLCSP-20 |
| ISP1160BM/01 | 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:Embedded Universal Serial Bus Host Controller |
| ISP1160BM/01,118 | 功能描述:USB 接口集成電路 USB HOST CTRL RoHS:否 制造商:Cypress Semiconductor 產品:USB 2.0 數據速率: 接口類型:SPI 工作電源電壓:3.15 V to 3.45 V 工作電源電流: 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:WLCSP-20 |
| ISP1160BM/01,151 | 功能描述:USB 接口集成電路 DO NOT USE ORDER -T OR NO "-" RoHS:否 制造商:Cypress Semiconductor 產品:USB 2.0 數據速率: 接口類型:SPI 工作電源電壓:3.15 V to 3.45 V 工作電源電流: 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:WLCSP-20 |
發布緊急采購，3分鐘左右您將得到回復。