參數資料
型號： HSP50214BVC
廠商： HARRIS SEMICONDUCTOR
元件分類： 通信及網絡
英文描述： Programmable Downconverter
中文描述： SPECIALTY TELECOM CIRCUIT, PQFP120
文件頁數： 47/60頁
文件大小： 573K
代理商： HSP50214BVC
3-47
Configuration Control Word Definitions
Note that in the Configuration Control Register Tables, some
of the available 32 bits in a Control Word are not used.
Unused bits do not need to be written to the Master Register.
If the destination only has 16 bits, then only 2 bytes need to be
written to the Master Register. Figure 45 details the timing for
proper operation of the Microprocessor Write Section. Bits
identified as “Reserved” should be programmed to a zero.
NOTE: CLKIN or PROCCLK must be present to properly load
control words. Note in the header which is applicable.
CONTROL WORD 0: CHIP CONFIGURATION, INPUT SECTION, CIC GAIN (SYNCHRONOUS TO CLKIN)
BIT
POSITION
FUNCTION
DESCRIPTION
31-21
Reserved
Reserved.
20
Carrier NCO External
Sync Enable
0- The SYNCIN1 pin has no effect on the Carrier NCO.
1- When the SYNCIN1 pin is asserted, the carrier center frequency and phase are updated from the
holding registers to the active register. Also, if bit 0 of this word is active, the carrier phase accumulator
feedback will be zeroed to set the Carrier NCO to a known phase, allowing the NCOs of multiple parts
to be initialized and updated synchronously.
19
CIC External Sync
Enable
0- The SYNCIN1 pin has no effect on the CIC filter.
1- When the SYNCIN1 pin is asserted, the decimation counter is loaded, allowing the decimation
counters in multiple chips to be synchronized. When CW27 bit-22 is set to a 1, SYNCIN1 will reset both
front end and back end circuitry.
18
Input Format
0- Two’s Complement Input Format.
1- Offset Binary Input Format.
17
Input Mode
0- Input operates in Gated Mode.
1- Input operates in Interpolated Mode.
16-13
CIC Shift Gain
These bits control the barrel shifter at the input to the CIC filter. These bits are added to the
GAINADJ(2:0) pins to determine the total shift. The sum is saturated at 15. See the CIC Decimation Filter
Section for values to be programmed in this field based on CIC filter Decimation. Bit 16 is the MSB.
2
(R)] for 4 < R < 31
SG = 15 for R = 4.
SG = 0 for R = 32.
12-7
CIC Decimation
Counter Preload
These bits control the decimation in the CIC filter. Program this field to R-1, where R is the desired dec-
imation factor in the filter. The decimation factor range is 4-32. See CIC Filter Section for effective deci-
mation range relative to the CIC Shift Gain value. Bit 12 is the MSB.
While this field allows values from 0 - 63, the valid values are in the range from 4- 32.
6
CIC Bypassed
Active high, this bit routes the output of the input shifter to the output of the CIC with no filtering.
When the CIC filter is bypassed, CLKIN must be at least twice the input sample rate (ENI should be tog-
gled to achieve this). When the CIC filter is bypassed, the bottom 24 bits of the barrel shifter output are
routed to the halfband filters.
5-4
Number of Offset
Frequency Bits
00 - 8 bits.
01 - 16.
10 - 24.
11 - 32.
3
Syncout CLK Select
This bit selects whether the SYNCOUT signal is generated from CLKIN of from PROCCLK
0- CLKIN.
1- PROCLK.
2
Clear Phase Accum
0- Enable accumulator in Carrier NCO.
1- Zero feedback in accumulator.
1
Carrier NCO Offset
Frequency Enable
When set to 1, this bit enables the offset frequency word to be added to the center frequency Control
Word. The offset is loaded serially via the COF and COFSYNC pins.
0
Carrier NCO Load
Phase Accum On
Update
When this bit is set to 1, the
μ
P update to the Carrier NCO frequency or an external carrier NCO load
using SYNCIN1 will zero the feedback of the phase accumulator, as well as update the phase or frequen-
cy. This function can be used to set the NCO to a known phase synchronized to an external event.
HSP50214B
相關PDF資料
PDF描述
HSP50214BVI Programmable Downconverter
HT84 ADSL Coupling Transformers
HT84-00594 ADSL Coupling Transformers
HT8400594S ADSL Coupling Transformers
HT84-00595 ADSL Coupling Transformers
相關代理商/技術參數
參數描述
HSP50214BVCZ 功能描述:上下轉換器 120L MQFP COMTEMP 14-BIT PROG DWNCNVRT RoHS:否 制造商:Texas Instruments 產品:Down Converters 射頻:52 MHz to 78 MHz 中頻:300 MHz LO頻率: 功率增益: P1dB: 工作電源電壓:1.8 V, 3.3 V 工作電源電流:120 mA 最大功率耗散:1 W 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:PQFP-128
HSP50214BVI 功能描述:上下轉換器 120L MQFP INDTEMP 14-BIT PROGRAMMABLE DOWNCONVERTER 65MSPS RoHS:否 制造商:Texas Instruments 產品:Down Converters 射頻:52 MHz to 78 MHz 中頻:300 MHz LO頻率: 功率增益: P1dB: 工作電源電壓:1.8 V, 3.3 V 工作電源電流:120 mA 最大功率耗散:1 W 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:PQFP-128
HSP50214BVIZ 功能描述:上下轉換器 120L MQFP INDTEMP 14-BIT PROG DWNCNVRT RoHS:否 制造商:Texas Instruments 產品:Down Converters 射頻:52 MHz to 78 MHz 中頻:300 MHz LO頻率: 功率增益: P1dB: 工作電源電壓:1.8 V, 3.3 V 工作電源電流:120 mA 最大功率耗散:1 W 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:PQFP-128
HSP50214VC 制造商:Rochester Electronics LLC 功能描述:- Bulk
HSP50214VI 制造商:Rochester Electronics LLC 功能描述:- Bulk
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*