參數資料
型號: HSP50214AVI
廠商: HARRIS SEMICONDUCTOR
元件分類: 通信及網絡
英文描述: Programmable Downconverter
中文描述: SPECIALTY TELECOM CIRCUIT, PQFP120
文件頁數: 13/60頁
文件大?。?/td> 467K
代理商: HSP50214AVI
13
The frequency of the NCO is the sum of a center frequency
Control Word, loaded via the microprocessor interface (Con-
trol Word 3, Bits 0 to 31), and an offset frequency, loaded seri-
ally via the COF and COFSYNC pins. The offset frequency
can be zeroed in Control Word 0, Bit 1. Both frequency control
terms are 32 bits and the addition is modulo 232. The output
frequency of the NCO is computed as:
or in terms of the programmed value:
where N is the 32-bit sum of the center and offset frequency
terms, fC is the frequency of the carrier NCO sinusoids, f
S
is
the input sampling frequency, and INT is the integer of the
computation. See the Microprocessor Write Section on
instructions for writing Control Word 3
.
For example, if N is 3267 (decimal), and f
S
is 65MHz, then fC
is 49.44Hz. If received data is modulated at a carrier fre-
quency of 10MHz, then the synthesizer/mixer should be pro-
grammed for N = 27627627 (hex) or D89D89B9 (hex).
Because the input enable, ENI, controls the operation of the
phase accumulator, the NCO output frequency is computed
relative to the input sample rate, f
S
, not to f
CLKIN
. The fre-
quency control, N, is interpreted as two’s complement
because the output of the NCO is quadrature. Negative fre-
quency L.O.s select the upper sideband; positive frequency
L.O.s select the lower sideband. The range of the NCO is -
fS/2 to + fS/2. The frequency resolution of the NCO is fS/(232)
or approximately 0.015Hz when CLKIN is 65 MSPS and ENI
is tied low.
The phase of the Carrier NCO can be shifted by adding a 10-
bit phase offset to the MSB’s (modulo 360o) of the output of
the phase accumulator. This phase offset control has a reso-
lution of 0.35o and can be interpreted as two’s complement
from -180o to 180o (-p to p) or as binary from 0 to 360o (0 to
2p). The phase offset is given by:
or, in terms of the parameter to be programmed:
where PO is the 10-bit two’s complement value loaded into the
Phase Offset Register (Control Word 4, Bits 9-0). For example,
a value of 32 (decimal) loaded into the Phase Offset Register
would produce a phase offset of 11.25o and a value of -512
would produce an offset of 180o. The phase offset is loaded via
the microprocessor interface. See the Microprocessor Write
Section on instructions for writing Control Word 4.
The most significant 18 bits from the phase adder are used as
the address a sin/cos lookup table. This lookup table maps
phase into sinusoidal amplitude. The sine and cosine values
have 18 bits of amplitude resolution. The spurious compo-
nents in the sine/cosine generation are at least -98dBc. The
sine and cosine samples are routed to the mixer section
where they are multiplied with the input samples to translate
the signal of interest to baseband.
The mixer multiplies the 14-bit input by the 18-bit quadrature
sinusoids. The mixer equations are:
The mixer output is rounded symmetrically to 15 bits.
To allow the frequency and phase of multiple parts to be
updated synchronously, two sets of registers are used for
latching the center frequency and phase offset words. The off-
set phase and center frequency Control Words are first
loaded into holding registers. The contents of the holding reg-
isters are transferred to active registers in one of two ways.
The first technique involves writing to a specific Control Word
Address. A processor write to Control Word 5, transfers the
center frequency value to the active register while a processor
write to Control Word 6 transfers the phase offset value to the
active register.
The second technique, designed for synchronizing updates to
multiple parts, uses the SYNCIN1 pin to update the active
registers. When Control Word 1, Bit 20 is set to 1, the
SYNCIN1 pin causes both the center frequency and Phase
Offset Holding Registers to be transferred to active registers.
Additionally, when Control Word 0, Bit 0 is set to 1, the feed-
back in the phase accumulator is zeroed when the transfer
from the holding to active register occurs. This feature pro-
vides synchronization of the phase accumulator starting
phase of multiple parts. It can also be used to reset the phase
of the NCO synchronous with a specific event.
f
C
f
S
* N
2
32
(
)
,
=
(EQ. 3)
N
INT f
C
2
32
f
S
×
[
]
HEX
,
=
(EQ. 3A)
SHIFT REG
SYNC
REG
REG
COF
COFSYNC
SIN/COS
ROM
REG
REG
TO MIXERS
COS
18
SIN
CARRIER
FREQUENCY
f
C
CARRIER
FREQUENCY
STROBE
CARRIER
PHASE
OFFSET
32
32
10
18
MUX
0
COF
MUX
0
CLEAR
PHASE
ACCUM
PHASE
ACCUMULATOR
CF
COF
ENABLE
R
E
G
REG
+
REG
+
Controlled via microprocessor interface.
18
CARRIER
PHASE
CARRIER
LOAD ON
UPDATE
R
E
G
STROBE
SYNC
CIRCUITRY
ENI
FIGURE 12. BLOCK DIAGRAM OF NCO SECTION
R
E
G
SYNCIN1
φ
OFF
2
π
PO 2
10
(
)
×
2
9
1
(
)
PO
2
9
1
(
)
<
<
(
)
;
=
(EQ. 4)
PO
INT 2
10
φ
OFF
)
2
π
]
HEX
π
φ
OFF
π
<
<
(
)
;
=
(EQ. 4A)
I
OUT
I
IN
ω
c
(
)
cos
×
=
(EQ. 5)
Q
OUT
I
IN
ω
c
(
)
sin
×
=
(EQ. 5A)
HSP50214A
相關PDF資料
PDF描述
HSP50214B Programmable Downconverter
HSP50214BVC Programmable Downconverter
HSP50214BVI Programmable Downconverter
HT84 ADSL Coupling Transformers
HT84-00594 ADSL Coupling Transformers
相關代理商/技術參數
參數描述
HSP50214B 制造商:INTERSIL 制造商全稱:Intersil Corporation 功能描述:Programmable Downconverter
HSP50214B_07 制造商:INTERSIL 制造商全稱:Intersil Corporation 功能描述:Programmable Downconverter
HSP50214BVC 功能描述:上下轉換器 120L MQFP COMTEMP 14-BIT PROGRAMMABLE DOWNCONVERTER 65MSPS RoHS:否 制造商:Texas Instruments 產品:Down Converters 射頻:52 MHz to 78 MHz 中頻:300 MHz LO頻率: 功率增益: P1dB: 工作電源電壓:1.8 V, 3.3 V 工作電源電流:120 mA 最大功率耗散:1 W 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:PQFP-128
HSP50214BVCZ 功能描述:上下轉換器 120L MQFP COMTEMP 14-BIT PROG DWNCNVRT RoHS:否 制造商:Texas Instruments 產品:Down Converters 射頻:52 MHz to 78 MHz 中頻:300 MHz LO頻率: 功率增益: P1dB: 工作電源電壓:1.8 V, 3.3 V 工作電源電流:120 mA 最大功率耗散:1 W 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:PQFP-128
HSP50214BVI 功能描述:上下轉換器 120L MQFP INDTEMP 14-BIT PROGRAMMABLE DOWNCONVERTER 65MSPS RoHS:否 制造商:Texas Instruments 產品:Down Converters 射頻:52 MHz to 78 MHz 中頻:300 MHz LO頻率: 功率增益: P1dB: 工作電源電壓:1.8 V, 3.3 V 工作電源電流:120 mA 最大功率耗散:1 W 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:PQFP-128