2-56
Intel
Integrated RAID Controller GSU31
User
’
s Manual
Rev 1.0
Advanced Installation Steps
2.5.6.5
Install GSU31 into an Existing NT 4.0 System
This procedure installs GSU31 into a system with an existing operating system installed. The
procedure ensures that the necessary software components are installed before installing GSU31.
Follow the required procedure below to install GSU31.
1. Have all hardware and software on hand. See system requirements in
Section 2.5.6.2
.
2. Back up your server.
3. Run the latest virus scan on any downloaded diskettes used for installation or on any existing
volumes.
4. Update Microsoft Windows NT Server 4.0 with the following software, if needed:
—
TCP/IP
—
Microsoft Windows NT 4.0 Service Pack 5 or greater (This will automatically upgrade IIS
2.0 to IIS 3.0 if IIS is already installed.).
—
If IIS is not already installed, install IIS version 3.0 (version 4.0 if this is a web server).
—
Microsoft Internet Explorer 4.00 or greater (recommended) or Netscape Navigator 4.08 or
greater.
5. If your browser uses a proxy server, then configure your browser using the procedure in
Section B.6,
“
Browser Configuration During Initial Installation
”
on page B-5
and return to this
procedure. If you have not configured your browser to use a proxy server, then go to
step 8
.
6. Configure Microsoft IIS
Warning:
Due to added security in GSU31, anonymous connections must be disabled in
Microsoft IIS in order to execute the GSU31 configuration utility in NT. If anonymous
connections are allowed to IIS on the target server, then the following message will appear on
the web browser after launching the GSU31 configuration utility shortcut:
Unable to open Driver
Could not open I
2
O Driver
To avoid the problem described above when attempting to run Storage Console, disable
Allow
Anonymous
connections to Microsoft IIS. Follow the directions below to disable
Allow
Anonymous
connections.
Note:
If you need to use the World Wide Web service capabilities of Internet Information
Server 4.0 to publish a web site on a server using GSU31, install IIS 4.0. Reconfigure IIS using
the IIS 4.0 instructions in
Section 2.5.7, Configuring Microsoft Internet Information Services
.
Return to this procedure when completed.
If you need to use IIS 4.0, reconfigure IIS using the IIS 4.0 instructions in
Section 2.5.7,
Configuring Microsoft Internet Information Services
. Go to
step 8
when completed.
7. Configure Microsoft IIS 3.0
a. Start
Internet Services Manager
from the
Microsoft Internet Server
program group.
b. Double-click on the server name in the WWW Service row (top computer name).
c. Under the
Service
tab in the
WWW Service Properties
window clear the
Allow Anonymous
checkbox in the
Password Authentication
section. See
Figure 2-43
.