參數資料
型號： ELANSC300-25VI
廠商： Advanced Micro Devices, Inc.
元件分類： 32位微控制器
英文描述： Highly Integrated, Low-Power, 32-Bit Microcontroller
中文描述： 高度集成，低功耗，32位微控制器
文件頁數： 53/139頁
文件大小： 1388K
代理商： ELANSC300-25VI
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁當前第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁第126頁第127頁第128頁第129頁第130頁第131頁第132頁第133頁第134頁第135頁第136頁第137頁第138頁第139頁
élanSC300 Microcontroller Data Sheet
53
P R E L I M I N A R Y
In the PLL Block Diagram, the INT_PLL is the Interme-
diate PLL, and is used to multiply the 32.768-kHz input
frequency by 45 to produce a 1.4746-MHz input for use
by the LS_PLL and the VID_PLL. The LS_PLL, or Low-
Speed PLL, is used to again multiply the 1.4746-MHz
input by 25 to produce a 36.864-MHz output. This out-
put of the LS_PLL is then divided down to provide the
frequencies shown in Table 21.
The LS_PLL also generates a 2.048-MHz signal used
by the VID_PLL or Video PLL to generate the
14.336-MHz clock used by the Internal LCD Controller.
This frequency is also available on the X1OUT
pin for
use by an external video controller if selected.
The HS_PLL can be programmed to provide one of the
high-speed CPU clock frequencies shown in Table 20.
élanSC300 Microcontroller
Power Management
Dynamic CPU clock switching is the primary form of
power management in the élanSC300 microcontroller.
When the system is in the High-Speed PLL mode, the
élanSC300 microcontroller
can be configured to use
the High-Speed clock output of the PLL for main mem-
ory, local bus accesses, CPU idle cycles, and ROM ac-
cesses configured to use the High-Speed clock. During
cycles to I/O devices, PCMCIA, ROM, and other exter-
nal ISA devices, the CPU clock is dynamically switched
to the output of the Low-Speed PLL.
During operation in Low-Speed PLL mode, the CPU
clock is driven from Low-Speed clock output of the
Low-Speed PLL divide chain. The CPU clock fre-
quency used during Low Speed mode is programma-
ble to the following frequencies: 4.608 MHz, 2.304
MHz, 1.152 MHz, and 0.567 MHz. During Doze, Sleep,
and Suspend modes of operation, the CPU clock is
normally stopped. This clock operates at 9.216 MHz
when it is running.
Slow-refresh and self-refresh DRAMs are supported by
the élanSC300 microcontroller. The refresh timer
source and the refresh rate are selectable. When the
CPU clock is stopped, the only clock source for refresh
is the 32-kHz clock. CAS-before-RAS DRAM refresh is
performed.
When the DMA subsystem is idle, the DMA clock con-
trol logic stops the clock input to the DMA controllers.
The DMA clock is started whenever any of the DREQ
inputs go High. When the DMA cycle is in progress, the
DMA clock remains active as long as a DREQ input is
High or the internal AEN signal is active.
To reduce power consumption in Doze, Sleep, and
Suspend modes, the CPU clock is turned off. To further
reduce the power consumption in these three modes,
the High-Speed PLL is shut off. The Low-Speed PLL is
left on by default, but can be programmed to turn off in
all three modes.
For information about the signals associated with
power management (ACIN, BL4–BL1, EXTSMI, LPH,
PGP3–PGP0, PMC4–PMC0, and SUS/RES), see
“Power Management Interface” on page 40. For more
information, see Chapter 1 of the élan
TM
SC300 Micro-
controller Programmer’s Reference Manual
, order
#18470.
Table 20.
High-Speed CPU Clock Frequencies
2 x CPU Frequency
40 MHz
50 MHz
66 MHz
HS_PLL Output Frequency
39.496 MHz
50.023 MHz
65.829 MHz
Table 21.
PLL Output
Phase-Locked Loops
INT_PLL
LS_PLL
Frequency
Where Used
1.4746 MHz
36.864 MHz
1.8432 MHz
1.1892 MHz
39.496 MHz, 50.023 MHz,
or 65.829 MHz
14.336 MHz
LS_PLL and VID_PLL
Divide by 2
16450 UART clock
8254 Timer clock
Input to high speed/low speed MUX
HS_PLL
VID_PLL
LCD Controller
相關PDF資料
PDF描述
ELANSC300-33VI Highly Integrated, Low-Power, 32-Bit Microcontroller
ELANSC400-100AI Single-Chip, Low-Power, PC/AT-Compatible Microcontrollers
ELANSC400-33AC Single-Chip, Low-Power, PC/AT-Compatible Microcontrollers
ELANSC400-33AI Single-Chip, Low-Power, PC/AT-Compatible Microcontrollers
ELANSC400-66AC Single-Chip, Low-Power, PC/AT-Compatible Microcontrollers
相關代理商/技術參數
參數描述
ELANSC300-33KC 制造商:AMD 制造商全稱:Advanced Micro Devices 功能描述:Highly Integrated, Low-Power, 32-Bit Microcontroller
ELANSC300-33KI 制造商:AMD 制造商全稱:Advanced Micro Devices 功能描述:Highly Integrated, Low-Power, 32-Bit Microcontroller
ELANSC300-33VC 制造商:Rochester Electronics LLC 功能描述:- Bulk 制造商:Advanced Micro Devices 功能描述: 制造商:AMD 功能描述:
ELANSC300-33VI 制造商:AMD 制造商全稱:Advanced Micro Devices 功能描述:Highly Integrated, Low-Power, 32-Bit Microcontroller
ELANSC300WW WAF 制造商:Advanced Micro Devices 功能描述:
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*