參數資料
型號： DS26504L+
廠商： Maxim Integrated Products
文件頁數： 43/129頁
文件大?。?/td> 0K
描述： IC T1/E1/J1 64KCC ELEMENT 64LQFP
產品培訓模塊： Lead (SnPb) Finish for COTS
Obsolescence Mitigation Program
標準包裝： 1
功能： BITS 元件
接口： 64KCC，E1，T1
電路數： 1
電源電壓： 3.14 V ~ 3.47 V
電流 - 電源： 150mA
工作溫度： 0°C ~ 70°C
安裝類型： 表面貼裝
封裝/外殼： 64-LQFP
供應商設備封裝： 64-LQFP（10x10）
包裝： 托盤
包括： *
產品目錄頁面： 1430 (CN2011-ZH PDF)
DS26504 T1/E1/J1/64KCC BITS Element
20 of 129
NAME
TYPE
FUNCTION
RD(DS)/
RMODE2
I
Active-Low Read Input-Data Strobe/Receive Mode Select Bit 2
RD (DS): DS is active high when BIS[1:0] = 01. See the bus timing diagrams.
RMODE2: In Hardware Mode (BIS[1:0] = 11), this pin selects the receive side
operating mode.
CS/
RLB
I
Active-Low Chip Select/Remote Loopback Enable
CS: This active-low signal must be low to read or write to the device. This
signal is used for both the parallel port and the serial port modes.
RLB: In Hardware Mode (BIS[1:0] = 11), when high, remote loopback is
enabled. This function is only valid when the transmit side and receive side are
in the same operating mode.
ALE (AS)/
A7/MPS1
I
Address Latch Enable (Address Strobe)/Address Bus Bit 7/MCLK
Prescale Select 1
ALE (AS): In multiplexed bus operation (BIS[1:0] = 00), this pin serves to
demultiplex the bus on a positive-going edge.
A7: In nonmultiplexed bus operation (BIS[1:0] = 01), this pin serves as A[7].
MPS1: In Hardware Mode (BIS[1:0] = 11), MCLK prescale select is used to set
the prescale value for the PLL.
WR (R/W)/
TMODE3
I
Active-Low Write Input (Read/Write)/Transmit Mode Select 3
WR: In Processor Mode, this pin is the active-low write signal.
TMODE3: In Hardware Mode, this pin selects the transmit-side operating
mode.
4.5 JTAG
NAME
TYPE
FUNCTION
JTCLK
I
JTAG Clock. This clock input is typically a low frequency (less than 10MHz)
50% duty cycle clock signal.
JTMS
I
JTAG Mode Select (with pullup). This input signal is used to control the
JTAG controller state machine and is sampled on the rising edge of JTCLK.
JTDI
I
JTAG Data Input (with pullup). This input signal is used to input data into
the register that is enabled by the JTAG controller state machine and is sampled
on the rising edge of JTCLK.
JTDO
O
JTAG Data Output. This output signal is the output of an internal scan shift
register enabled by the JTAG controller state machine and is updated on the
falling edge of JTCLK. The pin is in the high-impedance mode when a register
is not selected or when the
JTRST signal is high. The pin goes into and exits the
high-impedance mode after the falling edge of JTCLK.
JTRST
I
Active-Low JTAG Reset. This input forces the JTAG controller logic into the
reset state and forces the JTDO pin into high impedance when low. This pin
should be low while power is applied and set high after the power is stable.
The pin can be driven high or low for normal operation, but must be high for
JTAG operation.
相關PDF資料
PDF描述
MC908QT2AMFQE IC MCU 8BIT 1.5K FLASH 8-DFN
MC9S08LG16CLH IC MCU 8BIT LG16 FLASH 64-LQFP
DS21354LC1+ IC TXRX E1 3.3V 100-LQFP
S9S08SG16E1MTL MCU 16K FLASH 28-TSSOP
MC9S08SL16CTJ MCU 16KB FLASH SLIC 20TSSOP
相關代理商/技術參數
參數描述
DS26504L+ 功能描述:計時器和支持產品 E1/T1/J1/64Kcc Bits Element RoHS:否 制造商:Micrel 類型:Standard 封裝 / 箱體:SOT-23 內部定時器數量:1 電源電壓-最大:18 V 電源電壓-最小:2.7 V 最大功率耗散: 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝:Reel
DS26504LN 功能描述:計時器和支持產品 E1/T1/J1/64Kcc Bits Element RoHS:否 制造商:Micrel 類型:Standard 封裝 / 箱體:SOT-23 內部定時器數量:1 電源電壓-最大:18 V 電源電壓-最小:2.7 V 最大功率耗散: 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝:Reel
DS26504LN+ 功能描述:計時器和支持產品 E1/T1/J1/64Kcc Bits Element RoHS:否 制造商:Micrel 類型:Standard 封裝 / 箱體:SOT-23 內部定時器數量:1 電源電壓-最大:18 V 電源電壓-最小:2.7 V 最大功率耗散: 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝:Reel
DS26504LN+T&R 制造商:Maxim Integrated Products 功能描述:T1/E1/J1 ENH BITS IC LQFP LF T&R - Tape and Reel 制造商:Maxim Integrated Products 功能描述:IC T1/E1/J1 64KCC ELEMENT 64LQFP
DS26504LN+T&R 功能描述:網絡控制器與處理器 IC E1/T1/J1/64Kcc Bits Element RoHS:否 制造商:Micrel 產品:Controller Area Network (CAN) 收發器數量: 數據速率: 電源電流（最大值）:595 mA 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:PBGA-400 封裝:Tray
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*