參數資料
型號： DEMO56F8014
廠商： Freescale Semiconductor
文件頁數： 102/124頁
文件大?。?/td> 0K
描述： BOARD DEMO MC56F8014 W/US PS
標準包裝： 1
類型： MCU
適用于相關產品： 56F8014
所含物品： 板，線纜，CD，電源
配用： APMOTOR56F8000E-ND - KIT DEMO MOTOR CTRL SYSTEM
相關產品： MC56F8014VFAE-ND - IC DIGITAL SIGNAL CTRLR 32-LQFP
Resets
56F8014 Technical Data, Rev. 11
Freescale Semiconductor
79
be put into its Standby mode (LRSTDBY) to reduce the power utilization of that regulator.
All peripherals, except the COP/watchdog timer, run at the system clock (peripheral bus) frequency1,
which is the same as the main processor frequency in this architecture. The COP timer runs at
MSTR_OSC / 1024. The maximum frequency of operation is SYS_CLK = 32MHz. The only exception is
the Quad Timer and PWM, which can be configured to operate at three times the system bus rate using
TCR and PCR controls, provided the PLL is active and selected.
6.6 Resets
The SIM supports four sources of reset, as shown in Figure 6-15. The two asynchronous sources are the
external reset pin and the Power-On Reset (POR). The two synchronous sources are the software reset,
which is generated within the SIM itself by writing the SIM_CTRL register in Section 6.3.1, and the COP
reset. The SIM uses these to generate resets for the internal logic. These are outlined in Table 6-4. The
first column lists the four primary resets which are calculated. The JTAG circuitry is reset by the Power-On
Reset. Columns two through five indicate which reset sources trigger these reset signals. The last column
provides additional detail.
Figure 6-15 provides a graphic illustration of the details in Table 6-4. Note that the POR_Delay blocks
use the Relaxation Oscillator Clock as their time base since other system clocks are inactive during this
phase of reset.
1. The Quad Timer and PWM modules can be operated at three times the IPBus clock frequency.
Table 6-4 Primary System Resets
Reset Sources
Reset Signal
POR
External
Software
COP
Comments
EXTENDED_POR
X
Stretched version of POR. Relevant 64
Relaxation Oscillator Clock cycles after
POR deasserts.
CLKGEN_RST
X
Released 32 Relaxation Oscillator Clock
cycles after all reset sources have
released.
PERIP_RST
X
Releases 32 Relaxation Oscillator Clock
cycles after the CLKGEN_RST is
released.
CORE_RST
X
Releases 32 SYS_CLK periods after
PERIP_RST is released.
相關PDF資料
PDF描述
VE-BTR-EY-F2 CONVERTER MOD DC/DC 7.5V 50W
VE-BTR-EY-F1 CONVERTER MOD DC/DC 7.5V 50W
VE-BTR-EX-S CONVERTER MOD DC/DC 7.5V 75W
VE-BTR-EW-S CONVERTER MOD DC/DC 7.5V 100W
VE-BTM-EY-F4 CONVERTER MOD DC/DC 10V 50W
相關代理商/技術參數
參數描述
DEMO56F8014-E 功能描述:開發板和工具包 - 其他處理器 MC56F8014 BD W/UNIV PS RoHS:否 制造商:Freescale Semiconductor 產品:Development Systems 工具用于評估:P3041 核心:e500mc 接口類型:I2C, SPI, USB 工作電源電壓:
DEMO56F8014-EE 功能描述:開發板和工具包 - 其他處理器 MC56F8014 BD W/UNIV PS RoHS:否 制造商:Freescale Semiconductor 產品:Development Systems 工具用于評估:P3041 核心:e500mc 接口類型:I2C, SPI, USB 工作電源電壓:
DEMO90121DA 功能描述:KIT DEMO RFID DOOR ACCESS RoHS:是 類別:RF/IF 和 RFID >> 過時/停產零件編號 系列:- 標準包裝:1 系列:- 類型:用于 200/300 系列的歐盟開發套件 適用于相關產品:Zensys RF 模塊 所含物品:開發板，模塊，編程器，軟件，線纜，電源 其它名稱:703-1019Q3225667
DEMO90121LR 功能描述:KIT DEMO LONG RANGE READER RoHS:是 類別:RF/IF 和 RFID >> RFID 評估和開發套件及電路板 系列:- 產品培訓模塊:M24LR64 Dual Interface EEPROM 標準包裝:1 系列:- 類型:讀取器模塊 頻率:13.56MHz 適用于相關產品:M24LR-64-R 已供物品:2 根基準天線，I2C 和 RFID 讀取器，樣品 其它名稱:497-10480
DEMO908AP64 功能描述:開發板和工具包 - S08 / S12 MC68HC908AP64 DEMO BRD RoHS:否 產品:Development Kits 工具用于評估:MC9S12G128 核心:S12 接口類型:CAN, LIN, RS-232, USB 工作電源電壓:5 V 制造商:Freescale Semiconductor
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*