- 您現在的位置：買賣IC網 > PDF目錄376539 > D6571E (Electronic Theatre Controls, Inc.) Chip for an All-Digital Telephone Answering Machine with Flash Memory Interface PDF資料下載
參數資料
| 型號： | D6571E |
| 廠商： | Electronic Theatre Controls, Inc. |
| 英文描述： | Chip for an All-Digital Telephone Answering Machine with Flash Memory Interface |
| 中文描述： | 芯片的全數字電話應答機與快閃記憶體介面 |
| 文件頁數： | 17/117頁 |
| 文件大小： | 551K |
| 代理商： | D6571E |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁當前第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁
D6571E Data Sheet
DS6571E.2
DSP GROUP, INC., 3120 SCOTT BOULEVARD
SANTA CLARA, CA 95054 PH: 408 986-4300 FAX: 408 986-4490
17
In case of “cold start” the D6571E can generate silence
and 16 standard DTMF tones from the table below.
TONE
INDEX
0
No Tone
1
1
2
2
3
3
4
4
5
5
6
6
7
7
8
8
9
9
A
*
B
0
C
#
D
A
E
B
F
C
10
D
Note that tones A, B, C, D (entries D - 10) are available
in “cold start” but are not available by default in case of
“warm start.” Entries D - 10 should be programmed by
the user (User Defined tones) in case of “warm start.”
No User Defined Tones is available in case of “cold
start.”
New Tone Definition
The HOST can add tones to the table by sending the
first Tone Generation command with bit 11 = “1” and the
TONE INDEX in bits 4-0. The next three commands will
define the new tone (single or dual). The second
command defines “Tone 0” output gain in bits 0-3 and
“Tone 1” output gain in bits 4-7. Each tone can be
programmed from -24 dB (gain code 1111) to 6 dB (gain
code 0000) with resolution of 2 dB.
The user defined
tones may be programmed once only. Those tones can
be programmed in case of “warm start” only.
The third and fourth commands define the Tone 0
frequency and Tone 1 frequency respectively by the
following expression:
32767 * cos (2*
π
*fm/fs)
where: fm is the desired frequency and
fs is the sampling frequency (8000 Hz)
To define a single tone, either the third or fourth
command has to be 7FFFH. The HOST will define new
DTMF CODE
FREQ. 0
FREQ. 1
697
697
697
770
770
770
852
852
852
941
941
941
697
770
852
941
1209
1336
1477
1209
1336
1477
1209
1336
1477
1209
1336
1477
1633
1633
1633
1633
tones from the Idle mode and the D6571E will return to
Idle mode after the four commands/status sequence.
The HOST can use the newly defined tone from the tone
table immediately after the definition.
FSK Modem
FSK modem is implemented as a submode of the Tone
Generation mode. This mode allows to transmit and
receive FSK data with 1200 baud rate. This mode is
compatible with the CID receiver as well as wth
α
-5
function.
In this mode the D6571E receives byte stream from Host,
converts it to FSK bit stream, and generates it in frames.
The number of byte in the frame is specified by Host.
The D6571E generates “l(fā)eading mark bits” prior to the
FSK frame. The D6571E generates start and stop bits
for each byte of data (RS-232 protocol). The number of
start and stop bits can be programmed by Host. After
the frame has been transmitted the D6571E generates
“trailing mark bits.” The number of “l(fā)eading” and
“trailing” mark bits is host programmable.
After completion of frame generation the D6571E can go
to the FSK Receive mode without delay. In the FSK
Receive mode the D6571E can report to Host the number
of detected Channel Seizure bits and the number of
detected Mark bits. Sensitivity (rejection threshold) of
the FSK detector is host programmable (SelfTest and
Initialization command, Test mode = 0111, submode =
100).
Line Monitoring Mode
In this mode the D6571E monitors the telephone line for
the detection of a DTMF signal, CAS signal, and/or
existence of Call Progress Tones.
Caller Alert Signal (CAS) is a part of the Call Waiting
CID protocol. The same signal with the name Idle State
Tone Alert Signal is part of the V.23 protocol.
While in this mode, the D6571E is monitoring the
communication port every frame for a HOST command.
If no new command is detected, the D6571E continues
monitoring the line.
If an additional Line Monitoring command is detected,
the D6571E returns a status word to the HOST
containing the Call Progress Tone flag (bit 4), and the
index of the DTMF or CAS signal detected. The index is
defined as follows:
相關PDF資料 |
PDF描述 |
|---|---|
| D658S14SEITE1BIS5 | SCR / Diode Presspacks |
| D659S14SEITE1BIS5 | SCR / Diode Presspacks |
| D6694ZOV301RA300 | |
| D6694ZOV102RA720 | |
| D6694ZOV131RA140 | |
相關代理商/技術參數 |
參數描述 |
|---|---|
| D65792-000 | 制造商:TE Connectivity 功能描述:Fuse Chip 0.75A Fast 2-Pin Solder Pad Surface Mount T/R 制造商:TE Connectivity 功能描述:1206SFF075F/63-2 - Tape and Reel 制造商:TE Connectivity 功能描述:FUSE 0.75A 63V FAST SMD 1206 制造商:TE Connectivity / Raychem 功能描述:FUSE 0.75A 63V FAST SMD 1206 制造商:TE CONNECTIVITY RAYCHEM-POLYSWITCH 功能描述:El Fuse / 1206SFF075F/63-2 |
| D657ZOV271RA140 | 制造商:Maida Development Company 功能描述: |
| D-658 | 制造商:Triad Magnetics 功能描述: |
| D6582ZOV681RX260/CL | 制造商:Maida Development Company 功能描述: |
| D65840GJ029 | 制造商:NEC Electronics Corporation 功能描述:ELECTRONIC COMPONENT |
發布緊急采購，3分鐘左右您將得到回復。