- 您現在的位置：買賣IC網 > PDF目錄9618 > CY505YC64DTT (Silicon Laboratories Inc)IC CLK CK505 BROADWATER 64TSSOP PDF資料下載
參數資料
| 型號： | CY505YC64DTT |
| 廠商： | Silicon Laboratories Inc |
| 文件頁數： | 5/24頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC CLK CK505 BROADWATER 64TSSOP |
| 標準包裝： | 2,000 |
| 類型： | 時鐘/頻率發生器 |
| PLL： | 是 |
| 主要目的： | Intel CPU 服務器 |
| 輸入： | 晶體 |
| 輸出： | HCSL，LVCMOS |
| 電路數： | 1 |
| 比率 - 輸入:輸出： | 1:24 |
| 差分 - 輸入:輸出： | 無/是 |
| 頻率 - 最大： | 400.9MHz |
| 電源電壓： | 3.135 V ~ 3.465 V |
| 工作溫度： | 0°C ~ 85°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 64-TFSOP （0.240"，6.10mm 寬） |
| 供應商設備封裝： | 64-TSSOP |
| 包裝： | 帶卷 (TR) |
CY505YC64D
....................Document #: 001-03543 Rev *E Page 13 of 24
PD Assertion
When PS is sampled HIGH by two consecutive rising edges of
CPUC, all single-ended outputs will be held LOW on their next
HIGH-to-LOW transition and differential clocks must held
LOW. In the event that PD mode is desired as the initial
power-on state, PD must be asserted HIGH in less than 10
s
after asserting CK_PWRGD.
PD# Deassertion
The power-up latency is less than 1.8 ms. This is the time from
the deassertion of the PD# pin or the ramping of the power
supply until the time that stable clocks are output from the
clock chip. All differential outputs stopped in a three-state
condition resulting from power down will be driven high in less
than 300
s of PD# deassertion to a voltage greater than
200 mV. After the clock chip’s internal PLL is powered up and
locked, all outputs will be enabled within a few clock cycles of
each other. Below is an example showing the relationship of
clocks coming up.
CPU_STP# Assertion
The CPU_STP# signal is an active LOW input used to
synchronously stop and start the CPU output clocks while the
rest of the clock generator continues to function. When the
CPU_STP# pin is asserted, all CPU outputs that are set with
the SMBus configuration to be stoppable via assertion of
CPU_STP# are stopped within two to six CPU clock periods
after being sampled by two rising edges of the internal CPUC
clock. The final states of the stopped CPU signals are CPUT
= HIGH and CPUC = LOW.
PD#
USB, 48MHz
DOT96T
DOT96C
SRCT 100MHz
SRCC 100MHz
CPUT, 133MHz
PCI, 33 MHz
REF
CPUC, 133MHz
Figure 3. PD Assertion Timing Waveform
DOT96C
PD#
CPUC, 133MHz
CPUT, 133MHz
SRCC 100MHz
USB, 48MHz
DOT96T
SRCT 100MHz
Tstable
<1.8ms
PCI, 33MHz
REF
Tdrive_PW RDN#
<300
S, >200mV
PD Deassertion Timing Waveform
相關PDF資料 |
PDF描述 |
|---|---|
| VI-BTM-MW-F1 | CONVERTER MOD DC/DC 10V 100W |
| CS3106A-36-79S | CONN PLUG 20POS STRAIGHT W/SCKT |
| D38999/24FJ24PA | CONN RCPT 24POS JAM NUT W/PINS |
| VI-BTL-MW-F2 | CONVERTER MOD DC/DC 28V 100W |
| MS27467T17B35J | CONN PLUG 55POS STRAIGHT W/SCKT |
相關代理商/技術參數 |
參數描述 |
|---|---|
| CY50C475Z | 制造商:PHILIPS 功能描述:Miniature Monolithic Epoxy Coated Ceramic Radial Leads Capacitor - 4.7uF 50dcV +80-20% |
| CY512 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Stepper System Controller |
| CY512P | 制造商:CYLINK 功能描述:512P |
| CY525 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Stepper System Controller |
| CY525A | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Stepper Motor Controller/Driver |
發布緊急采購，3分鐘左右您將得到回復。