- 您現在的位置：買賣IC網 > PDF目錄378471 > CXD3021 (Sony Corporation) CD Digital Signal Processor with Built-in Digital Servo and DAC PDF資料下載
參數資料
| 型號： | CXD3021 |
| 廠商： | Sony Corporation |
| 元件分類： | 數字信號處理 |
| 英文描述： | CD Digital Signal Processor with Built-in Digital Servo and DAC |
| 中文描述： | CD數字信號處理器，具有內置數字伺服和DAC |
| 文件頁數： | 72/161頁 |
| 文件大?。?/td> | 1311K |
| 代理商： | CXD3021 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁當前第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁第126頁第127頁第128頁第129頁第130頁第131頁第132頁第133頁第134頁第135頁第136頁第137頁第138頁第139頁第140頁第141頁第142頁第143頁第144頁第145頁第146頁第147頁第148頁第149頁第150頁第151頁第152頁第153頁第154頁第155頁第156頁第157頁第158頁第159頁第160頁第161頁
– 72 –
CXD3021R
[2] Subcode Interface
There are two methods for reading out a subcode externally.
The 8-bit subcodes P to W can be read out from SBSO by inputting EXCK.
Sub-Q can be read out after checking CRC of the 80 bits in the subcode frame.
Sub-Q can be read out from the SQSO pin by inputting 80 clock pulses to the SQCK pin when SCOR comes
correctly and CRCF is high.
§ 2-1. P to W Subcode Readout
Data can be read out by inputting EXCK immediately after WFCK falls. (See Timing Chart 2-1.)
§ 2-2. 80-bit Sub-Q Readout
Fig. 2-2 shows the peripheral block of the 80-bit Sub-Q register.
First, Sub-Q, regenerated at one bit per frame, is input to the 80-bit serial/parallel register and the CRC check
circuit.
96-bit Sub-Q is input, and if the CRC is OK, it is output to SQSO with CRCF = 1. In addition, 80 bits are
loaded into the parallel/serial register.
When SQSO goes high after SCOR is output, the CPU determines that new data (which passed the CRC
check) has been loaded.
When the 80-bit data is loaded, the order of the MSB and LSB is inverted within each byte. As a result,
although the sequence of the bytes is the same, the bits within the bytes are now ordered LSB first.
Once the 80-bit data load is confirmed, SQCK is input so that the data can be read.
The SQCK input is detected, and the retriggerable monostable multivibrator is reset while the input is low.
The retriggerable monostable multivibrator has a time constant from 270 to 400μs. When the duration when
SQCK is high is less than this time constant, the monostable multivibrator is kept reset; during this interval,
the serial/parallel register is not loaded into the parallel/serial register.
While the monostable multivibrator is being reset, data cannot be loaded in the peak detection parallel/serial
register or the 80-bit parallel/serial register.
In other words, while reading out with a clock cycle shorter than this time constant, the register will not be
rewritten by CRCOK and others.
The previously mentioned peak detection register can be connected to the shift-in of the 80-bit parallel/serial
register.
For ring control 1, input and output are shorted during peak meter and level meter modes.
For ring control 2, input and output are shorted during peak meter mode.
This is because the register is reset with each readout in level meter mode, and to prevent readout
destruction in peak meter mode.
As a result, the 96-bit clock must be input in peak meter mode.
The absolute time after peak is stored in the memory in peak meter mode. (See Timing Chart 2-3.)
The high and low intervals for SQCK should be between 750ns and 120μs.
相關PDF資料 |
PDF描述 |
|---|---|
| CXD3021R | Silver Mica Capacitor; Capacitance:25000pF; Capacitance Tolerance:+/- 1%; Series:CD42; Voltage Rating:500VDC; Capacitor Dielectric Material:Mica; Termination:Radial Leaded; Lead Pitch:27mm; Leaded Process Compatible:Yes RoHS Compliant: Yes |
| CXD3030 | System-on-a-Chip (SoC) Device Supports 48ⅴ Speed CD-ROM Drives |
| CXD3152R | Signal Processor LSI for Single-chip CCD B/W Camera |
| CXD3204R | IEEE1394 LSI for D-STB, D-VHS, and DTV |
| CXD3220 | IEEE1394 Link/Transaction Layer Controller LSI for SBP-2 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| CXD3021R | 制造商:SONY 制造商全稱:Sony Corporation 功能描述:CD Digital Signal Processor with Built-in Digital Servo and DAC |
| CXD3027 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:CD Audio Digital Signal-Processing LSI Device with On-Chip Digital Servo System Allows Listening without Sound Skipping |
| CXD3027R | 制造商:SONY 制造商全稱:Sony Corporation 功能描述:CD Digital Signal Processor with Built-in Digital Servo + Shock-Proof Memory Controller + Digital High & Bass Boost |
| CXD3027R-1 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:CD Audio Digital Signal-Processing LSI Device with On-Chip Digital Servo System Allows Listening without Sound Skipping |
| CXD3029R | 制造商:SONY 制造商全稱:Sony Corporation 功能描述:CD Digital Signal Processor with Built-in Digital Servo + Shock-proof Memory Controller + Digital High & Bass Boost |
發布緊急采購，3分鐘左右您將得到回復。