參數資料
型號: C8051F005-TB
廠商: Silicon Laboratories Inc
文件頁數: 76/171頁
文件大?。?/td> 0K
描述: BOARD PROTOTYPING W/C8051F005
標準包裝: 1
類型: MCU
適用于相關產品: C8051F005
所含物品:
C8051F000/1/2/5/6/7
C8051F010/1/2/5/6/7
21.2.
Flash Programming Commands
The Flash memory can be programmed directly over the JTAG interface using the Flash Control, Flash Data, Flash
Address, and Flash Scale registers. These Indirect Data Registers are accessed via the JTAG Instruction Register.
Read and write operations on indirect data registers are performed by first setting the appropriate DR address in the
IR register. Each read or write is then initiated by writing the appropriate Indirect Operation Code (IndOpCode) to
the selected data register. Incoming commands to this register have the following format:
19:18
17:0
IndOpCode
WriteData
IndOpCode: These bit set the operation to perform according to the following table:
IndOpCode
Operation
0x
Poll
10
Read
11
Write
The Poll operation is used to check the Busy bit as described below. Although a Capture-DR is performed, no
Update-DR is allowed for the Poll operation. Since updates are disabled, polling can be accomplished by shifting
in/out a single bit.
The Read operation initiates a read from the register addressed by the IR. Reads can be initiated by shifting only 2
bits into the indirect register. After the read operation is initiated, polling of the Busy bit must be performed to
determine when the operation is complete.
The write operation initiates a write of WriteData to the register addressed by the IR. Registers of any width up to
18 bits can be written. If the register to be written contains fewer than 18 bits, the data in WriteData should be left-
justified, i.e. its MSB should occupy bit 17 above. This allows shorter registers to be written in fewer JTAG clock
cycles. For example, an 8-bit register could be written by shifting only 10 bits. After a Write is initiated, the Busy
bit should be polled to determine when the next operation can be initiated. The contents of the Instruction Register
should not be altered while either a read or write operation is in progress.
Outgoing data from the indirect Data Register has the following format:
19
18:1
0
ReadData
Busy
The Busy bit indicates that the current operation is not complete. It goes high when an operation is initiated and
returns low when complete. Read and Write commands are ignored while Busy is high. In fact, if polling for Busy
to be low will be followed by another read or write operation, JTAG writes of the next operation can be made while
checking for Busy to be low. They will be ignored until Busy is read low, at which time the new operation will
initiate. This bit is placed at bit 0 to allow polling by single-bit shifts. When waiting for a Read to complete and
Busy is 0, the following 18 bits can be shifted out to obtain the resulting data. ReadData is always right-justified.
This allows registers shorter than 18 bits to be read using a reduced number of shifts. For example, the result from a
byte-read requires 9 bit shifts (Busy + 8 bits).
167
Rev. 1.7
相關PDF資料
PDF描述
SK101M250ST CAP ALUM 100UF 250V 20% RADIAL
SLPX472M063E3P3 CAP ALUM 4700UF 63V 20% SNAP
SDR-R SCOTCH CODE REFILL R
C8051F206-TB BOARD PROTOTYPING W/C8051F206
0210490992 CABLE JUMPER 1.25MM .102M 29POS
相關代理商/技術參數
參數描述
C8051F005-TB-K 功能描述:BOARD PROTOTYPING W/C8051F005 制造商:silicon labs 系列:- 零件狀態:在售 板類型:評估平臺 類型:MCU 8-位 核心處理器:8051 操作系統:- 平臺:- 配套使用產品/相關產品:C8051F0xx 安裝類型:固定 內容:板 標準包裝:1
C8051F006 功能描述:8位微控制器 -MCU 32KB 12ADC RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT
C8051F006-GQ 功能描述:8位微控制器 -MCU 32KB 12ADC RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT
C8051F006-GQR 功能描述:8位微控制器 -MCU 32KB 12ADC 48Pin MCU Tape and Reel RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT
C8051F006R 功能描述:8位微控制器 -MCU C +-12Bit 48Pin RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT