- 您現在的位置：買賣IC網 > PDF目錄381309 > AS3932-BQFT (AUSTRIAMICROSYSTEMS AG) Programmable 3D LF Receiver; Package Type: QFN(4x4)-16; Temperature Range: -40 - +85 °C; Supply Voltage: 2,40-3,60 PDF資料下載
參數資料
| 型號： | AS3932-BQFT |
| 廠商： | AUSTRIAMICROSYSTEMS AG |
| 元件分類： | 微波射頻器件 |
| 英文描述： | Programmable 3D LF Receiver; Package Type: QFN(4x4)-16; Temperature Range: -40 - +85 °C; Supply Voltage: 2,40-3,60 |
| 封裝： | QFN(4x4)-16 |
| 文件頁數： | 24/34頁 |
| 文件大?。?/td> | 455K |
| 代理商： | AS3932-BQFT |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁當前第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁
24 - 34
AS3932
Datasheet - Detailed Description
8.6.1 Without Pattern Detection
Figure 18. Wake-up Protocol Overview without Pattern Detection (only carrier frequency detection)
In case the data correlation is disabled (
R1<1>
=0) the AS3932 wakes up upon detection of the carrier frequency only as shown in
Figure 18
. In
order to ensure that AS3932 wakes up the carrier burst has to last longer than 550 μs. To set AS3932 back to listening mode there are two
possibilities: either the microcontroller sends the direct command clear_wake via SDI or the time out option is used (
R7<7:5>
). In case the latter
is chosen, AS3932 is automatically set to listening mode after the time defined in T_OUT (
R7<7:5>
), counting starts at the low-to-high WAKE
edge on the WAKE pin.
8.6.2 Single Pattern Detection
The
Figure 19
shows the wake-up protocol in case the pattern correlation is enabled (
R1<1>
=1) for a 125 kHz carrier frequency. The initial
carrier burst has to be longer than 550 μs and can last maximum 16 bits (see bit rate definition in
Table 19
). If the ON/OFF mode is used
(
R1<5>
=1), the minimum value of the maximum carrier burst duration is limited to 10 ms. This is summarized in
Table 22
. In case the carrier
burst is too long the internal wake-up will be set back to low and the false wake-up counter (
R13<7:0>
) will be incremented by one. The carrier
burst must be followed by a preamble (0101... modulated carrier with a bit duration defined in
Table 19
) and the wake-up pattern stored in the
registers
R5<7:0>
and
R6<7:0>
. The preamble must have at least 4 bits and the preamble duration together with the pattern should not be
longer than 40 bits. If the wake-up pattern is correct, the signal on the WAKE pin goes high one bit after the end of the pattern and the data
transmission can get started. To set the chip back to listening mode the direct command clear_wake, as well as the time out option (
R7<7:5>
)
can be used.
Carrier Burst
Data
Carrier Burst > 550 us
WAKE
Clear_wake
DAT
相關PDF資料 |
PDF描述 |
|---|---|
| AS4C1M16E5 | 5V 1M×16 CMOS DRAM (EDO)(5V 1M×16 CMOS動態RAM（擴展數據總線）) |
| AS4C1M16F5 | 5V 1M×16 CMOS DRAM (Fast-page Mode)(5V 1M×16 CMOS動態RAM（快速頁面模式）) |
| AS4C256K16E0-50TC | 5V 256Kx16 CMOS DRAM (EDO) |
| AS4C256K16E0-30 | 5V 256Kx16 CMOS DRAM (EDO) |
| AS4C256K16E0-30JC | 5V 256Kx16 CMOS DRAM (EDO) |
相關代理商/技術參數 |
參數描述 |
|---|---|
| AS3932-BQFT-CUT TAPE | 制造商:AMS 功能描述:AS3932 Series 3.6 V 150 KHz 3D Low Frequency Wakeup Receiver - QFN-16 |
| AS3932-BTST | 功能描述:射頻接收器 RoHS:否 制造商:Skyworks Solutions, Inc. 類型:GPS Receiver 封裝 / 箱體:QFN-24 工作頻率:4.092 MHz 工作電源電壓:3.3 V 封裝:Reel |
| AS3932-DB | 制造商:ams 功能描述:AS3932 Demo Board Rx & Tx |
| AS3932-DK | 制造商:ams 功能描述:AS3932 Development System |
| AS3933 DB | 制造商:AMS 功能描述:BOARD DEMO FOR AS3933 |
發布緊急采購，3分鐘左右您將得到回復。