- 您現在的位置：買賣IC網 > PDF目錄381305 > AS1533-T (AUSTRIAMICROSYSTEMS AG) 12-Bit, 4-CH, ADC, 300ksps; Package Type: TSSOP-16 PDF資料下載
參數資料
| 型號： | AS1533-T |
| 廠商： | AUSTRIAMICROSYSTEMS AG |
| 元件分類： | ADC |
| 英文描述： | 12-Bit, 4-CH, ADC, 300ksps; Package Type: TSSOP-16 |
| 封裝： | TSSOP-16 |
| 文件頁數： | 23/28頁 |
| 文件大?。?/td> | 920K |
| 代理商： | AS1533-T |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁當前第23頁第24頁第25頁第26頁第27頁第28頁
www.austriamicrosystems.com
Revision 1.00
23 - 28
AS1532/AS1533
Data Sheet
- Application Information
9 Application Information
Initialization
When power is first applied to the AS1532/AS1533 internal power-on reset circuitry sets the devices for normal opera-
tion. At this point, the devices can perform data conversions with CSN held low.
Note:
The device requires 10μs after the power supplies stabilize; no conversions should be initiated during this time.
The digital output at pin DOUT will be all 0s until an analog-to-digital conversion is initiated.
Serial Interface
The AS1532/AS1533 fully support SPI, QSPI, and Microwire interfaces. For SPI, select the correct clock polarity and
sampling edge in the SPI control registers (set CPOL = 0 and CPHA = 0).
Note:
Microwire, SPI, and QSPI all transmit a byte and receive a byte at the same time.
Using the circuit shown in
Figure 33 on page 24
, the simplest software interface requires only three 8-bit transfers to
perform a conversion (one 8-bit transfer to configure the AS1532/AS1533, and two more 8-bit transfers to clock out the
12-bit conversion result).
Serial Interface Configuration
The following steps describe how to configure the serial interface:
1. Confirm that the CPU serial interface is in master mode (so the CPU generates the serial clock).
2. Choose a clock frequency from 500kHz to 6.4MHz (AS1532) or 4.8MHz (AS1533).
3. Set up the control byte and call it TB1. TB1 should be in the format 1XXXXXXX binary, where the Xs indicate the
selected channel, conversion mode, and power mode.
4. Use a general-purpose I/O line on the CPU to pull CSN low.
5. Transmit TB1 and simultaneously receive a byte (RB1). Ignore this byte.
6. Transmit a byte of all zeros ($00
h
) and simultaneously receive byte RB2.
7. Transmit a byte of all zeros ($00
h
) and simultaneously receive byte RB3.
8. Pull CSN high.
Bytes RB2 and RB3 (see
Figure 21 on page 17
) contain the results of the conversion, padded with three leading zeros
and one trailing zero. The total conversion time is a function of the serial-clock frequency and the amount of idle time
between 8-bit transfers. To avoid excessive track/hold droop, make sure the total conversion time does not exceed
120μs.
相關PDF資料 |
PDF描述 |
|---|---|
| AS1538-BTST | 12-bit, 8-CH, 50ksps ADC, I2C; Package Type: TSSOP-16 |
| AS1539-BTST | 10-bit, 8-CH, 50ksps ADC, I2C; Package Type: TSSOP-16; Temperature Range: -40 - +85 °C; Output Interface: I"C; Supply Voltage: 2,70-5,50 |
| AS1542-BTST | 12-bit 16-CH 1Msps w Sequencer; Package Type: TSSOP-28 |
| AS1543-BQFT | 12-bit 8-CH 1Msps w Sequencer; Package Type: TQFN(4x4)-20 |
| AS1545-BQFT | Dual 12-bit, 12-CH, 1Msps; Package Type: TQFN(5x5)-32 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| AS1534 | 制造商:AMSCO 制造商全稱:austriamicrosystems AG 功能描述:12-bit, 8-Channel, Low-Power, 200ksps A/D Converter |
| AS1536 | 制造商:AMSCO 制造商全稱:austriamicrosystems AG 功能描述:12-Bit, Single Supply, Low-Power, 73ksps A/D Converters |
| AS15360204PD | 制造商:Raltron Electronics Corporation 功能描述: |
| AS15360FLF | 制造商:TT Electronics / IRC 功能描述:AS15360FLF |
| AS15360HLF | 制造商:TT Electronics / IRC 功能描述:AS15360HLF |
發布緊急采購，3分鐘左右您將得到回復。