參數資料
型號： APA2068KAI-TUL
廠商： Anpec Electronics Corporation
英文描述： Stereo 2.6W Audio Power Amplifier (with DC_Volume Control)
中文描述： 立體聲2.6W音頻功率放大器（帶DC_Volume控制）
文件頁數： 17/27頁
文件大小： 495K
代理商： APA2068KAI-TUL
Copyright
ANPEC Electronics Corp.
Rev. A.2 - Jul., 2005
APA2068
www.anpec.com.tw
17
Vbias
Circuit
OUT+
OUT-
RL
OP1
OP2
Volume Control
amplifier output
signal
Application Descriptions
BTL Operation
The APA2068 output stage (power amplifier) has two
pairs of operational amplifiers internally, allowed for
different amplifier configurations.
The power amplifier’s OP1 gain is setting by internal
unity-gain and input audio signal is come from internal
volume control amplifier, while the second amplifier OP2
is internally fixed in a unity-gain, inverting configuration.
Figure 1 shows that the output of OP1 is connected
to the input to OP2, which results in the output signals
of with both amplifiers with identical in magnitude, but
out of phase 180°. Consequently, the differential gain
for each channel is 2 x (Gain of SE mode).
By driving the load differentially through outputs OUT+
and OUT-, an amplifier configuration commonly referred
to as bridged mode is established. BTL mode operation
is different from the classical single-ended SE amplifier
configuration where one side of its load is connected
to ground.
A BTL amplifier design has a few distinct advantages
over the SE configuration, as it provides differentialdrive
to the load, thus doubling the output swing for
aspecified supply voltage.
Four times the output power is possible as compared
Figure 1: APA2068 internal configuration
(each channel)
Cbypass x 125k
1
≤
1
RiCi
<<
1
R
L
C
C
(1)
toa SE amplifier under the same conditions.
A BTL
configuration, such as the one used in APA2068, also
creates a second advantage over SE amplifiers. Since
the differential outputs, ROUT+, ROUT-, LOUT+, and
LOUT-, are biased at half-supply, no need DC voltage
exists across the load. This eliminates the need for an
output coupling capacitor which is required in a single
supply, SE configuration.
Single-Ended Operation
Consider the single-supply SE configuration shown
Application Circuit. A coupling capacitor is required to
block the DC offset voltage from reaching the load.
These capacitors can be quite large (approximately
33
μ
F to 1000
μ
F) so they tend to be expensive, occupy
valuable PCB area, and have the additional drawback
of limiting low-frequency performance of the system
(refer to the Output Coupling Capacitor).The rules
described still hold with the addition of the following
relationship:
Output SE/BTL Operation
The ability of the APA2068 to easily switch between
BTL and SE modes is one of its most important costs
saving features. This feature eliminates the requirement
for an additional headphone amplifier in applications
where internal stereo speakers are driven in BTL mode
but external headphone or speakers must be
accommodated.
Internal to the APA2068, two separate amplifiers drive
OUT+ and OUT- (see Figure 1). The SE/BTL input
controls the operation of the follower amplifier that drives
LOUT- and ROUT-.
When SE/BTL is held low, the OP2 is turn on and
the APA2068 is in the BTL mode.
When SE/BTL is held high, the OP2 is in a high
相關PDF資料
PDF描述
APA2308KITU Class AB Stereo Headphone Driver
APA2822 Dual Low-Voltage Power Amplifier
APA3544JI-TR Class AB Stereo Headphone Driver with Mute
APA3544JI-TU Class AB Stereo Headphone Driver with Mute
APA3544YI-TR Rotary Switch; Contact Current Max:1.5A; No. of Poles:3; No. of Switch Positions:5; Indexing:30 ; Switch Terminals:Through Hole RoHS Compliant: Yes
相關代理商/技術參數
參數描述
APA2069 制造商:ANPEC 制造商全稱:Anpec Electronics Coropration 功能描述:Stereo 2.6W Audio Power Amplifier (with DC_Volume Control)
APA2069_11 制造商:ANPEC 制造商全稱:Anpec Electronics Coropration 功能描述:Stereo 2.6W Audio Power Amplifier (with DC_Volume Control)
APA2069JI-TU 制造商:ANPEC 制造商全稱:Anpec Electronics Coropration 功能描述:Stereo 2.6W Audio Power Amplifier (with DC_Volume Control)
APA2069JI-TUG 制造商:ANPEC 制造商全稱:Anpec Electronics Coropration 功能描述:Stereo 2.6W Audio Power Amplifier (with DC_Volume Control)
APA2069JI-TUL 制造商:ANPEC 制造商全稱:Anpec Electronics Coropration 功能描述:Stereo 2.6W Audio Power Amplifier (with DC_Volume Control)
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*