參數資料
型號： ADSP-TS101SAB1Z100
廠商： Analog Devices Inc
文件頁數： 5/48頁
文件大?。?/td> 0K
描述： IC DSP CTRLR 128BIT BUS 625-BGA
標準包裝： 1
系列： TigerSHARC®
類型： 定點/浮點
接口： 主機接口，連接端口，多處理器
時鐘速率： 300MHz
非易失內存： 外部
芯片上RAM： 768kB
電壓 - 輸入/輸出： 3.30V
電壓 - 核心： 1.20V
工作溫度： -40°C ~ 85°C
安裝類型： 表面貼裝
封裝/外殼： 625-BBGA
供應商設備封裝： 625-PBGA（27x27）
包裝： 托盤
ADSP-TS101S
Rev. C
|
Page 13 of 48
|
May 2009
Table 5. Pin Definitions—External Port Bus Controls
Signal
Type
Term
Description
ADDR31–0
1
I/O/T
nc
Address Bus. The DSP issues addresses for accessing memory and peripherals on these pins. In
a multiprocessor system, the bus master drives addresses for accessing internal memory or I/O
processor registers of other ADSP-TS101S processors. The DSP inputs addresses when a host or
another DSP accesses its internal memory or I/O processor registers.
DATA63–0
I/O/T
nc
External Data Bus. Data and instructions are received, and driven by the DSP, on these pins.
RD
2
I/O/T (pu
3)
nc
Memory Read. RD is asserted whenever the DSP reads from any slave in the system, excluding
SDRAM. When the DSP is a slave, RD is an input and indicates read transactions that access its
internal memory or universal registers. In a multiprocessor system, the bus master drives RD.
The RD pin changes concurrently with ADDR pins.
WRL2
I/O/T (pu3)nc
Write Low. WRL is asserted in two cases: When the ADSP-TS101S writes to an even address word
of external memory or to another external bus agent; and when the ADSP-TS101S writes to a
32-bit zone (host, memory, or DSP programmed to 32-bit bus). An external master (host or DSP)
asserts WRL for writing to a DSP’s low word of internal memory. In a multiprocessor system, the
bus master drives WRL. The WRL pin changes concurrently with ADDR pins. When the DSP is a
slave, WRL is an input and indicates write transactions that access its internal memory or
universal registers.
WRH2
I/O/T (pu3)nc
Write High. WRH is asserted when the ADSP-TS101S writes a long word (64 bits) or writes to an
odd address word of external memory or to another external bus agent on a 64-bit data bus.
An external master (host or another DSP) must assert WRH for writing to a DSP’s high word of
64-bit data bus. In a multiprocessing system, the bus master drives WRH. The WRH pin changes
concurrently with ADDR pins. When the DSP is a slave, WRH is an input and indicates write
transactions that access its internal memory or universal registers.
ACK
I/O/T
epu
Acknowledge. External slave devices can deassert ACK to add wait states to external memory
accesses. ACK is used by I/O devices, memory controllers, and other peripherals on the data
phase. The DSP can deassert ACK to add wait states to read accesses of its internal memory. The
ADSP-TS101S does not drive ACK during slave writes. Therefore, an external (approximately
10 k
) pull-up is required.
BMS2, 4
O/T
(pu/pd3)
au
Boot Memory Select. BMS is the chip select for boot EPROM or flash memory. During reset, the
DSP uses BMS as a strap pin (EBOOT) for EPROM boot mode. When the DSP is configured to
boot from EPROM, BMS is active during the boot sequence. Pull-down enabled during RESET
(asserted); pull-up enabled after RESET (deasserted). In a multiprocessor system, the DSP bus
master drives BMS. For details see Reset and Booting on Page 9 and the EBOOT signal
description in Table 16 on Page 19.
MS1–0
O/T (pu
3)nc
Memory Select. MS0 or MS1 is asserted whenever the DSP accesses memory banks 0 or 1,
respectively. MS1–0 are decoded memory address pins that change concurrently with ADDR
pins. When ADDR31:26 = 0b000010, MS0 is asserted. When ADDR31:26 = 0b000011, MS1 is
asserted. In multiprocessor systems, the master DSP drives MS1–0.
Type column symbols: A = asynchronous; G = ground; I = input; O = output; o/d = open drain output; P = power supply;
pd = internal pull-down approximately 100 k; pu = internal pull-up approximately 100 k; T = three-state
Term (for termination) column symbols: epd = external pull-down approximately 10 k to VSS; epu = external pull-up approximately 10 k
to VDD-IO, nc = not connected; au = always used.
相關PDF資料
PDF描述
EBM08DSEF CONN EDGECARD 16POS .156 EYELET
EBM08DSAI CONN EDGECARD 16POS R/A .156 SLD
VE-2WP-CY-F4 CONVERTER MOD DC/DC 13.8V 50W
171-009-213R031 CONN DB9 FEMALE DIP SLD NICKEL
TPSC106K020H0700 CAP TANT 10UF 20V 10% 2312
相關代理商/技術參數
參數描述
ADSP-TS101SAB2-000 功能描述:IC DSP CONTROLLER 6MBIT 484 BGA RoHS:否 類別:集成電路 (IC) >> 嵌入式 - DSP（數字式信號處理器） 系列:TigerSHARC® 標準包裝:2 系列:StarCore 類型:SC140 內核 接口:DSI，以太網，RS-232 時鐘速率:400MHz 非易失內存:外部 芯片上RAM:1.436MB 電壓 - 輸入/輸出:3.30V 電壓 - 核心:1.20V 工作溫度:-40°C ~ 105°C 安裝類型:表面貼裝 封裝/外殼:431-BFBGA，F(xiàn)CBGA 供應商設備封裝:431-FCPBGA（20x20） 包裝:托盤
ADSP-TS101SAB2-050 制造商:Analog Devices 功能描述:TIGERSHARC - Trays
ADSP-TS101SAB2-100 功能描述:IC DSP CONTROLLER 6MBIT 484 BGA RoHS:否 類別:集成電路 (IC) >> 嵌入式 - DSP（數字式信號處理器） 系列:TigerSHARC® 標準包裝:2 系列:StarCore 類型:SC140 內核 接口:DSI，以太網，RS-232 時鐘速率:400MHz 非易失內存:外部 芯片上RAM:1.436MB 電壓 - 輸入/輸出:3.30V 電壓 - 核心:1.20V 工作溫度:-40°C ~ 105°C 安裝類型:表面貼裝 封裝/外殼:431-BFBGA，F(xiàn)CBGA 供應商設備封裝:431-FCPBGA（20x20） 包裝:托盤
ADSP-TS101SAB2Z000 功能描述:IC DSP FLOAT/FIXED 250MHZ 484BGA RoHS:是 類別:集成電路 (IC) >> 嵌入式 - DSP（數字式信號處理器） 系列:TigerSHARC® 標準包裝:2 系列:StarCore 類型:SC140 內核 接口:DSI，以太網，RS-232 時鐘速率:400MHz 非易失內存:外部 芯片上RAM:1.436MB 電壓 - 輸入/輸出:3.30V 電壓 - 核心:1.20V 工作溫度:-40°C ~ 105°C 安裝類型:表面貼裝 封裝/外殼:431-BFBGA，F(xiàn)CBGA 供應商設備封裝:431-FCPBGA（20x20） 包裝:托盤
ADSP-TS101SAB2Z100 功能描述:IC DSP CTRLR 6MBIT 300MHZ 484BGA RoHS:是 類別:集成電路 (IC) >> 嵌入式 - DSP（數字式信號處理器） 系列:TigerSHARC® 標準包裝:40 系列:TMS320DM64x, DaVinci™ 類型:定點 接口:I²C，McASP，McBSP 時鐘速率:400MHz 非易失內存:外部 芯片上RAM:160kB 電壓 - 輸入/輸出:3.30V 電壓 - 核心:1.20V 工作溫度:0°C ~ 90°C 安裝類型:表面貼裝 封裝/外殼:548-BBGA，F(xiàn)CBGA 供應商設備封裝:548-FCBGA（27x27） 包裝:托盤 配用:TMDSDMK642-0E-ND - DEVELPER KIT W/NTSC CAMERA296-23038-ND - DSP STARTER KIT FOR TMS320C6416296-23059-ND - FLASHBURN PORTING KIT296-23058-ND - EVAL MODULE FOR DM642TMDSDMK642-ND - DEVELOPER KIT W/NTSC CAMERA
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*