- 您現在的位置：買賣IC網 > PDF目錄10333 > AD7452BRTZ-REEL7 (Analog Devices Inc)IC ADC 12BIT DIF 555KSPS SOT23-8 PDF資料下載
參數資料
| 型號： | AD7452BRTZ-REEL7 |
| 廠商： | Analog Devices Inc |
| 文件頁數： | 17/29頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC ADC 12BIT DIF 555KSPS SOT23-8 |
| 標準包裝： | 3,000 |
| 位數： | 12 |
| 采樣率（每秒）： | 555k |
| 數據接口： | DSP，MICROWIRE?，QSPI?，串行，SPI? |
| 轉換器數目： | 1 |
| 功率耗散（最大）： | 7.25mW |
| 電壓電源： | 單電源 |
| 工作溫度： | -40°C ~ 85°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | SOT-23-8 |
| 供應商設備封裝： | SOT-23-8 |
| 包裝： | 帶卷 (TR) |
| 輸入數目和類型： | 1 個差分，雙極 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁當前第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁
AD7452
Rev. B | Page 23 of 28
AD7452*
ADSP-21xx*
SCLK
DR
RFS
TFS
SCLK
SDATA
CS
03154-A
-040
*ADDITIONAL PINS REMOVED FOR CLARITY
Figure 40. Interfacing to the ADSP-21xx
The timer registers, for example, are loaded with a value that
provides an interrupt at the required sample interval. When an
interrupt is received, a value is transmitted with TFS/DT (ADC
control word). The TFS is used to control the RFS and therefore
the reading of data. The frequency of the serial clock is set in
the SCLKDIV register. When the instruction to transmit with
TFS is given (i.e., AX0 = TX0), the state of the SCLK is checked.
The DSP waits until the SCLK has gone high, low, and high
again before the transmission starts. If the timer and SCLK
values are chosen such that the instruction to transmit occurs
on or near the rising edge of SCLK, the data may be transmitted
or it may wait until the next clock edge.
For example, the ADSP-2111 has a master clock frequency of
16 MHz. If the SCLKDIV register is loaded with the value 3, an
SCLK of 2 MHz is obtained and eight master clock periods
elapse for every SCLK period. If the timer registers are loaded
with the value 803, 100.5 SCLKs occur between interrupts and
subsequently between transmit instructions. This situation
results in nonequidistant sampling because the transmit
instruction is occurring on an SCLK edge. If the number of
SCLKs between interrupts is a whole integer figure of N,
equidistant sampling is implemented by the DSP.
AD7452 to TMS320C5x/C54x
The serial interface on the TMS320C5x/C54x uses a continuous
serial clock and frame synchronization signals to synchronize
the data transfer operations with peripheral devices like the
AD7452. The CS input allows easy interfacing between the
TMS320C5x/C54x and the AD7452 without any glue logic
required. The serial port of the TMS320C5x/C54x is set up to
operate in burst mode with internal CLKx (Tx serial clock) and
FSx (Tx frame sync). The serial port control register (SPC) must
have the following setup: FO = 0, FSM = 1, MCM = 1, and TxM
= 1. The format bit, FO, may be set to 1 to set the word length to
eight bits in order to implement the power-down mode on the
AD7452. The connection diagram is shown in Figure 41. It
should be noted that for signal processing applications, it is
imperative that the frame synchronization signal from the
TMS320C5x/C54x provides equidistant sampling.
AD7452*
TMS320C5x/
C54x*
CLKx
DR
FSx
FSR
SCLK
SDATA
CS
CLKR
03154-A
-041
*ADDITIONAL PINS REMOVED FOR CLARITY
Figure 41. Interfacing to the TMS320C5x/C54x
AD7452 to DSP56xxx
The connection diagram in Figure 42 shows how the AD7452
can be connected to the SSI (synchronous serial interface) of
the DSP56xxx family of DSPs from Motorola. The SSI is
operated in synchronous mode (SYN bit in CRB = 1) with
internally generated 1-word frame sync for both Tx and Rx
(Bits FSL1 = 0 and FSL0 = 0 in CRB). Set the word length to 16
by setting Bits WL1 = 1 and WL0 = 0 in CRA. To implement
power-down mode on the AD7452, the word length can be
changed to eight bits by setting Bits WL1 = 0 and WL0 = 0 in
CRA. It should be noted that for signal processing applications,
it is imperative that the frame synchronization signal from the
DSP56xxx provides equidistant sampling.
AD7452*
DSP56xxx*
SCLK
SRD
SR2
SCLK
SDATA
CS
03154-A
-042
*ADDITIONAL PINS REMOVED FOR CLARITY
Figure 42. Interfacing to the DSP56xxx
相關PDF資料 |
PDF描述 |
|---|---|
| LTC2365HTS8#TRPBF | IC ADC 12BIT 1MSPS TSOT23-8 |
| VI-BW2-MW-S | CONVERTER MOD DC/DC 15V 100W |
| LTC2493CDE#PBF | IC ADC 24BIT DELTA SIG 14-DFN |
| VI-BW1-MW-S | CONVERTER MOD DC/DC 12V 100W |
| VI-2WV-MX-S | CONVERTER MOD DC/DC 5.8V 75W |
相關代理商/技術參數 |
參數描述 |
|---|---|
| AD7453 | 制造商:AD 制造商全稱:Analog Devices 功能描述:Pseudo Differential, 555 kSPS, 12-Bit ADC in an 8-Lead SOT-23 |
| AD7453ART-REEL7 | 制造商:Analog Devices 功能描述: |
| AD7453ARTZ-REEL7 | 功能描述:IC ADC 12BIT DFF 600KSPS SOT23-8 RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:2,500 系列:- 位數:16 采樣率（每秒）:15 數據接口:MICROWIRE?，串行，SPI? 轉換器數目:1 功率耗散（最大）:480µW 電壓電源:單電源 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:38-WFQFN 裸露焊盤 供應商設備封裝:38-QFN（5x7） 包裝:帶卷 (TR) 輸入數目和類型:16 個單端，雙極；8 個差分，雙極 配用:DC1011A-C-ND - BOARD DELTA SIGMA ADC LTC2494 |
| AD7453BRT-R2 | 制造商:Analog Devices 功能描述:ADC Single SAR 555ksps 12-bit Serial 8-Pin SOT-23 T/R 制造商:Rochester Electronics LLC 功能描述:12-BIT P/DIFF I/PUT, 600KSPS ADC I.C. - Bulk |
| AD7453BRT-REEL7 | 制造商:Analog Devices 功能描述:ADC Single SAR 555ksps 12-bit Serial 8-Pin SOT-23 T/R |
發布緊急采購，3分鐘左右您將得到回復。