- 您現在的位置：買賣IC網 > PDF目錄10541 > AD7352YRUZ (Analog Devices Inc)IC ADC DUAL 12BIT 3MSPS 16TSSOP PDF資料下載
參數資料
| 型號： | AD7352YRUZ |
| 廠商： | Analog Devices Inc |
| 文件頁數： | 10/21頁 |
| 文件大小： | 0K |
| 描述： | IC ADC DUAL 12BIT 3MSPS 16TSSOP |
| 設計資源： | DC-Coupled, Single-Ended-to-Differential Conversion Using AD8138 and AD7352 (CN0040) |
| 標準包裝： | 1 |
| 位數： | 12 |
| 采樣率（每秒）： | 3M |
| 數據接口： | DSP，MICROWIRE?，QSPI?，串行，SPI? |
| 轉換器數目： | 2 |
| 功率耗散（最大）： | 45mW |
| 電壓電源： | 單電源 |
| 工作溫度： | -40°C ~ 125°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 16-TSSOP（0.173"，4.40mm 寬） |
| 供應商設備封裝： | 16-TSSOP |
| 包裝： | 管件 |
| 輸入數目和類型： | 2 個差分，雙極 |
| 產品目錄頁面： | 777 (CN2011-ZH PDF) |
AD7352
Rev. A | Page 17 of 20
POWER-UP TIMES
The AD7352 has two power-down modes: partial power-down
and full power-down, which are described in detail in the
Down Mode sections. This section deals with the power-up
time required when coming out of any of these modes. Note
that the recommended decoupling capacitors must be in place
on the REFA and REFB pins for the power-up times to apply.
To power up from partial power-down mode, one dummy cycle
is required. The device is fully powered up after approximately
333 ns have elapsed from the falling edge of CS. When the partial
power-up time has elapsed, the ADC is fully powered up, and
the input signal is acquired properly. The quiet time, tQUIET,
must still be allowed from the point where the bus goes back
into three-state after the dummy conversion to the next falling
edge of CS.
To power up from full power-down mode, approximately
6 ms should be allowed from the falling edge of CS, shown
in
as tPOWER-UP2.
Note that during power-up from partial power-down mode, the
track-and-hold, which is in hold mode while the part is powered
down, returns to track mode after the first SCLK edge that the
part receives after the falling edge of CS.
When power supplies are first applied to the AD7352, the ADC
can power up in either of the power-down modes or in normal
mode. Because of this, it is best to allow a dummy cycle to elapse
to ensure that the part is fully powered up before attempting a
valid conversion. Likewise, if the part is to be kept in partial
power-down mode immediately after the supplies are applied,
then two dummy cycles must be initiated. The first dummy
cycle must hold CS low until after the 10th SCLK falling edge; in
the second cycle, CS must be brought high between the second
and 10th SCLK falling edges (see
).
Alternatively, if the part is to be placed into full power-down
mode when the supplies are applied, three dummy cycles must
be initiated. The first dummy cycle must hold CS low until after
the 10th SCLK falling edge; the second and third dummy cycles
place the part into full power-down mode (see
and
the
section).
POWER vs. THROUGHPUT RATE
The power consumption of the AD7352 varies with the
throughput rate. When using very slow throughput rates and
as fast an SCLK frequency as possible, the various power-down
options can be used to make significant power savings. However,
the AD7352 quiescent current is low enough that, even without
using the power-down options, there is a noticeable variation in
power consumption with sampling rate. This is true whether a
fixed SCLK value is used or it is scaled with the sampling
rate. Figure 29 shows a plot of power vs. throughput rate when
operating in normal mode for a fixed maximum SCLK frequency
and a SCLK frequency that scales with the sampling rate. The
internal reference was used for Figure 29.
10
12
14
16
18
20
22
24
26
28
30
0
1000
2000
3000
PO
W
E
R
(
m
W
)
THROUGHPUT (kSPS)
070
44
-029
80MHz SCLK
VARIABLE SCLK
Figure 29. Power vs. Throughput Rate
相關PDF資料 |
PDF描述 |
|---|---|
| 97-3108B-18-4P | CONN PLUG RT ANG 4POS W/PINS |
| AD9214BRSZ-65 | IC ADC 10BIT 65MSPS 28SSOP |
| MS3116P12-10PW | CONN PLUG 10POS STRAIGHT W/PINS |
| MS3116P12-10P | CONN PLUG 10POS STRAIGHT W/PINS |
| AD7276BRMZ | IC ADC 12BIT SRL 3MSPS 8MSOP |
相關代理商/技術參數 |
參數描述 |
|---|---|
| AD7352YRUZ-500RL7 | 功能描述:IC ADC DUAL 12BIT 3MSPS 16TSSOP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1,000 系列:- 位數:16 采樣率（每秒）:45k 數據接口:串行 轉換器數目:2 功率耗散（最大）:315mW 電壓電源:模擬和數字 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:28-SOIC（0.295"，7.50mm 寬） 供應商設備封裝:28-SOIC W 包裝:帶卷 (TR) 輸入數目和類型:2 個單端，單極 |
| AD7352YRUZ-RL | 功能描述:IC ADC DUAL 12BIT 3MSPS 16TSSOP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1,000 系列:- 位數:16 采樣率（每秒）:45k 數據接口:串行 轉換器數目:2 功率耗散（最大）:315mW 電壓電源:模擬和數字 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:28-SOIC（0.295"，7.50mm 寬） 供應商設備封裝:28-SOIC W 包裝:帶卷 (TR) 輸入數目和類型:2 個單端，單極 |
| AD7356 | 制造商:AD 制造商全稱:Analog Devices 功能描述:Differential Input,Dual,Simultaneous Sampling, 4.25 MSPS, 14-Bit, SAR ADC |
| AD7356_08 | 制造商:AD 制造商全稱:Analog Devices 功能描述:Differential Input, Dual, Simultaneous Sampling, 5 MSPS, 12-Bit, SAR ADC |
| AD7356BRUZ | 功能描述:IC ADC DUAL 12BIT 5MSPS 16TSSOP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1 系列:microPOWER™ 位數:8 采樣率（每秒）:1M 數據接口:串行，SPI? 轉換器數目:1 功率耗散（最大）:- 電壓電源:模擬和數字 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:24-VFQFN 裸露焊盤 供應商設備封裝:24-VQFN 裸露焊盤（4x4） 包裝:Digi-Reel® 輸入數目和類型:8 個單端，單極 產品目錄頁面:892 (CN2011-ZH PDF) 其它名稱:296-25851-6 |
發布緊急采購，3分鐘左右您將得到回復。