- 您現在的位置：買賣IC網 > PDF目錄8749 > AD5310BRTZ-REEL7 (Analog Devices Inc)IC DAC 10BIT R-R W/BUFF SOT23-6 PDF資料下載
參數資料
| 型號： | AD5310BRTZ-REEL7 |
| 廠商： | Analog Devices Inc |
| 文件頁數： | 6/16頁 |
| 文件大小： | 0K |
| 描述： | IC DAC 10BIT R-R W/BUFF SOT23-6 |
| 產品培訓模塊： | Data Converter Fundamentals DAC Architectures |
| 標準包裝： | 3,000 |
| 設置時間： | 6µs |
| 位數： | 10 |
| 數據接口： | 串行 |
| 轉換器數目： | 1 |
| 電壓電源： | 單電源 |
| 功率耗散（最大）： | 1.25mW |
| 工作溫度： | -40°C ~ 105°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | SOT-23-6 |
| 供應商設備封裝： | SOT-23-6 |
| 包裝： | 帶卷 (TR) |
| 輸出數目和類型： | 1 電壓，單極；1 電壓，雙極 |
| 采樣率（每秒）： | 167k |
第1頁第2頁第3頁第4頁第5頁當前第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁
AD5310
Data Sheet
Rev. B | Page 14 of 16
APPLICATIONS INFORMATION
USING REF19x AS A POWER SUPPLY FOR AD5310
Because the supply current required by the AD5310 is extremely
low, an alternative option is to use a REF19x voltage reference
(REF195 for 5 V or REF193 for 3 V) to supply the required voltage
to the part (see Figure 32). This is especially useful if the power
supply is quite noisy or if the system supply voltages are at some
value other than 5 V or 3 V (for example, 15 V). The REF19x
outputs a steady supply voltage for the AD5310. If the low dropout
is 140 A. This is with no load on the output of the DAC. When
the DAC output is loaded, the REF195 also needs to supply the
current to the load. The total current required (with a 5 k load
on the DAC output) is
140 A + (5 V/5 k) = 1.14 mA
The load regulation of the REF195 is typically 2 ppm/mA, which
results in an error of 2.3 ppm (11.5 V) for the 1.14 mA current
drawn from it. This corresponds to a 0.002 LSB error.
Figure 32. REF195 as Power Supply to AD5310
BIPOLAR OPERATION USING THE AD5310
The AD5310 is designed for single-supply operation but a bipolar
output range is also possible using the circuit shown in Figure 33.
This circuit results in an output voltage range of ±5 V. Rail-to-rail
operation at the amplifier output is achievable using an AD820
or an OP295 as the output amplifier. The output voltage for any
input code can be calculated as follows:
×
+
×
×
=
R1
R2
V
R1
R2
R1
D
V
DD
O
1024
where D represents the input code in decimal (0 to 1023).
With VDD = 5 V, R1 = R2 = 10 k,
V
5
1024
10
×
=
D
VO
This is an output voltage range of ±5 V, with 000 hex corresponding
to a 5 V output and 3FF hex corresponding to a +5 V output.
Figure 33. Bipolar Operation with the AD5310
USING AD5310 WITH AN OPTO-ISOLATED
INTERFACE
In process control applications in industrial environments, it is
often necessary to use an opto-isolated interface to protect and
isolate the controlling circuitry from any hazardous common-
mode voltages that may occur in the area where the DAC is
functioning. Opto-isolators provide isolation in excess of 3 kV.
Because the AD5310 uses a 3-wire serial logic interface, it only
requires three opto-isolators to provide the required isolation
(see Figure 34). The power supply to the part also needs to be
isolated. This is done by using a transformer. On the DAC side
of the transformer, a 5 V regulator provides the 5 V supply required
for the AD5310.
Figure 34. AD5310 with an Opto-Isolated Interface
相關PDF資料 |
PDF描述 |
|---|---|
| LTC1663-8CMS8#PBF | IC D/A CONV 10BIT R-R 8-MSOP |
| LTC1663-8CMS8 | IC D/A CONV 10BIT R-R 8-MSOP |
| LTC2630ISC6-LZ12#TRPBF | IC DAC 12BIT R-R SC70-6 |
| VE-JNT-MZ-F2 | CONVERTER MOD DC/DC 6.5V 25W |
| SY100E193JZ | IC PARITY GENERATOR 8BIT 28PLCC |
相關代理商/技術參數 |
參數描述 |
|---|---|
| AD5310RBRMZ | 功能描述:10 Bit Digital to Analog Converter 1 10-MSOP 制造商:analog devices inc. 系列:- 包裝:管件 零件狀態:有效 位數:10 數模轉換器數:1 建立時間:7μs 輸出類型:Voltage - Buffered 差分輸出:無 數據接口:SPI 參考類型:外部， 內部 電壓 - 電源，模擬:2.7 V ~ 5.5 V 電壓 - 電源，數字:2.7 V ~ 5.5 V INL/DNL（LSB）:±0.5（最大），±0.5（最大） 架構:電阻串 DAC 工作溫度:-40°C ~ 105°C 封裝/外殼:10-TFSOP，10-MSOP（0.118"，3.00mm 寬） 供應商器件封裝:10-MSOP 標準包裝:50 |
| AD5310RBRMZ-RL7 | 功能描述:10 Bit Digital to Analog Converter 1 10-MSOP 制造商:analog devices inc. 系列:- 包裝:帶卷（TR） 零件狀態:有效 位數:10 數模轉換器數:1 建立時間:7μs 輸出類型:Voltage - Buffered 差分輸出:無 數據接口:SPI 參考類型:外部， 內部 電壓 - 電源，模擬:2.7 V ~ 5.5 V 電壓 - 電源，數字:2.7 V ~ 5.5 V INL/DNL（LSB）:±0.5（最大），±0.5（最大） 架構:電阻串 DAC 工作溫度:-40°C ~ 105°C 封裝/外殼:10-TFSOP，10-MSOP（0.118"，3.00mm 寬） 供應商器件封裝:10-MSOP 標準包裝:1,000 |
| AD5310WBRTZ-REEL7 | 制造商:AD 制造商全稱:Analog Devices 功能描述:2.7 V to 5.5 V, 140 muA, Rail-to-Rail Voltage Output 10-Bit DAC in a SOT-23 |
| AD5311 | 制造商:AD 制造商全稱:Analog Devices 功能描述:2.5 V to 5.5 V, 500 uA, Parallel Interface Quad Voltage-Output 8-/10-/12-Bit DACs |
| AD5311BRM | 功能描述:IC DAC 10BIT 2WIRE W/BUFF 8-MSOP RoHS:否 類別:集成電路 (IC) >> 數據采集 - 數模轉換器 系列:- 標準包裝:2,400 系列:- 設置時間:- 位數:18 數據接口:串行 轉換器數目:3 電壓電源:模擬和數字 功率耗散（最大）:- 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:36-TFBGA 供應商設備封裝:36-TFBGA 包裝:帶卷 (TR) 輸出數目和類型:* 采樣率（每秒）:* |
發布緊急采購，3分鐘左右您將得到回復。