參數資料
型號： ADSP-BF544BBCZ-4A
廠商： Analog Devices Inc
文件頁數： 11/100頁
文件大小： 0K
描述： IC CCD SIGNAL PROCESSOR 400BGA
標準包裝： 1
系列： Blackfin®
類型： 定點
接口： CAN，SPI，SSP，TWI，UART
時鐘速率： 400MHz
非易失內存： 外部
芯片上RAM： 196kB
電壓 - 輸入/輸出： 2.50V，3.30V
電壓 - 核心： 1.25V
工作溫度： -40°C ~ 85°C
安裝類型： 表面貼裝
封裝/外殼： 400-LFBGA，CSPBGA
供應商設備封裝： 400-CSPBGA（17x17）
包裝： 托盤
Rev. C
|
Page 18 of 100
|
February 2010
ADSP-BF542/ADSP-BF544/ADSP-BF547/ADSP-BF548/ADSP-BF549
Power Domains
As shown in Table 6, the ADSP-BF54x Blackfin processors sup-
port different power domains. The use of multiple power
domains maximizes flexibility while maintaining compliance
with industry standards and conventions. By isolating the inter-
nal logic of the ADSP-BF54x Blackfin processors into its own
power domain separate from the RTC and other I/O, the pro-
cessors can take advantage of dynamic power management
without affecting the RTC or other I/O devices. There are no
sequencing requirements for the various power domains.
VOLTAGE REGULATION
The ADSP-BF54x Blackfin processors provide an on-chip volt-
age regulator that can generate processor core voltage levels
from an external supply (see specifications in Operating Condi-
external components required to complete the power manage-
ment system. The regulator controls the internal logic voltage
levels and is programmable with the voltage regulator control
register (VR_CTL) in increments of 50 mV. This register can be
accessed using the bfrom_SysControl() function in the on-chip
ROM. To reduce standby power consumption, the internal volt-
age regulator can be programmed to remove power to the
processor core while keeping I/O power supplied. While in
hibernate state, VDDEXT, VDDRTC, VDDDDR, VDDUSB, and VDDVR can
still be applied, eliminating the need for external buffers. The
voltage regulator can be activated from this power-down state
by assertion of the RESET pin, which then initiates a boot
sequence. The regulator can also be disabled and bypassed at the
user’s discretion. For all 600 MHz speed grade models and all
automotive grade models, the internal voltage regulator must
not be used and VDDVR must be tied to VDDEXT. For additional
information regarding design of the voltage regulator circuit,
see Switching Regulator Design Considerations for the ADSP-
BF533 Blackfin Processors (EE-228).
CLOCK SIGNALS
The ADSP-BF54x Blackfin processors can be clocked by an
external crystal, a sine wave input, or a buffered, shaped clock
derived from an external clock oscillator.
If an external clock is used, it should be a TTL-compatible signal
and must not be halted, changed, or operated below the speci-
fied frequency during normal operation. This signal is
connected to the processor’s CLKIN pin. When an external
clock is used, the XTAL pin must be left unconnected.
Alternatively, because the ADSP-BF54x Blackfin processors
include an on-chip oscillator circuit, an external crystal may be
used. For fundamental frequency operation, use the circuit
shown in Figure 7. A parallel-resonant, fundamental frequency,
microprocessor-grade crystal is connected across the CLKIN
and XTAL pins. The on-chip resistance between CLKIN and the
XTAL pin is in the 500 k
range. Typically, further parallel
resistors are not recommended. The two capacitors and the
series resistor shown in Figure 7 fine-tune phase and amplitude
of the sine frequency. The 1MOhm pull-up resistor on the
XTAL pin guarantees that the clock circuit is properly held inac-
tive when the processor is in the hibernate state.
The capacitor and resistor values shown in Figure 7 are typical
values only. The capacitor values are dependent upon the crystal
manufacturers’ load capacitance recommendations and the PCB
physical layout. The resistor value depends on the drive level
specified by the crystal manufacturer. System designs should
verify the customized values based on careful investigations on
multiple devices over temperature range.
Table 6. Power Domains
Power Domain
VDD Range
All internal logic, except RTC, DDR, and USB
VDDINT
RTC internal logic and crystal I/O
VDDRTC
DDR external memory supply
VDDDDR
USB internal logic and crystal I/O
VDDUSB
Internal voltage regulator
VDDVR
MXVR PLL and logic
VDDMP
All other I/O
VDDEXT
Figure 6. Voltage Regulator Circuit
VDDVR
(LOW-INDUCTANCE)
VDDINT
VROUT
100μF
VROUT
GND
SHORT AND LOW-
INDUCTANCE WIRE
VDDVR
+
100μF
10μF
LOW ESR
100nF
SETOFDECOUPLING
CAPACITORS
FDS9431A
ZHCS1000
2.7V TO 3.6V
INPUT VOLTAGE
RANGE
NOTE: DESIGNER SHOULD MINIMIZE
TRACE LENGTH TO FDS9431A.
10μH
相關PDF資料
PDF描述
ADSP-21488KSWZ-4A IC CCD SIGNAL PROCESSOR 100LQFP
ADSP-21488KSWZ-3A1 IC DSP SHARC 400MHZ 100LQFP
JWS10028/A PWR SUP 28.0V 3.6A SNG OUTPUT
MAX6505UTP020+T IC TEMP SWITCH DL TRIP SOT23-6
ADSP-BF533SBBZ400 IC DSP CTLR 16BIT 400MHZ 169-BGA
相關代理商/技術參數
參數描述
AD5111 制造商:AD 制造商全稱:Analog Devices 功能描述:Single-Channel, 128-/64-/32-Position, Up/Down, ±8% Resistor Tolerance, Nonvolatile Digital Potentiometer
AD5111BCPZ10-500R7 功能描述:IC DGTL POT 128POS 10K 8LFCSP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 數字電位器 系列:- 標準包裝:3,000 系列:DPP 接片:32 電阻（歐姆）:10k 電路數:1 溫度系數:標準值 300 ppm/°C 存儲器類型:非易失 接口:3 線串行（芯片選擇，遞增，增/減） 電源電壓:2.5 V ~ 6 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:8-WFDFN 裸露焊盤 供應商設備封裝:8-TDFN（2x3） 包裝:帶卷 (TR)
AD5111BCPZ10-RL7 功能描述:IC DGTL POT 128POS 10K 8LFCSP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 數字電位器 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:1 系列:- 接片:256 電阻（歐姆）:100k 電路數:1 溫度系數:標準值 35 ppm/°C 存儲器類型:非易失 接口:3 線串口 電源電壓:2.7 V ~ 5.25 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:8-WDFN 裸露焊盤 供應商設備封裝:8-TDFN-EP（3x3） 包裝:剪切帶 (CT) 產品目錄頁面:1399 (CN2011-ZH PDF) 其它名稱:MAX5423ETA+TCT
AD5111BCPZ80-500R7 功能描述:IC DGTL POT 128POS 80K 8LFCSP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 數字電位器 系列:- 標準包裝:3,000 系列:DPP 接片:32 電阻（歐姆）:10k 電路數:1 溫度系數:標準值 300 ppm/°C 存儲器類型:非易失 接口:3 線串行（芯片選擇，遞增，增/減） 電源電壓:2.5 V ~ 6 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:8-WFDFN 裸露焊盤 供應商設備封裝:8-TDFN（2x3） 包裝:帶卷 (TR)
AD5111BCPZ80-RL7 功能描述:IC DGTL POT 128POS 80K 8LFCSP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 數字電位器 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:1 系列:- 接片:256 電阻（歐姆）:100k 電路數:1 溫度系數:標準值 35 ppm/°C 存儲器類型:非易失 接口:3 線串口 電源電壓:2.7 V ~ 5.25 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:8-WDFN 裸露焊盤 供應商設備封裝:8-TDFN-EP（3x3） 包裝:剪切帶 (CT) 產品目錄頁面:1399 (CN2011-ZH PDF) 其它名稱:MAX5423ETA+TCT
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*