參數資料
型號: XR17D154
廠商: Exar Corporation
英文描述: UNIVERSAL (3.3V AND 5V) PCI BUS QUAD UART
中文描述: 通用(3.3V和5V)PCI總線四的UART
文件頁數: 11/69頁
文件大?。?/td> 836K
代理商: XR17D154
xr
XR17D154
REV. 1.2.0
UNIVERSAL (3.3V AND 5V) PCI BUS QUAD UART
19
2.2.6
SLEEP [31:24] - (default 0x00)
Each UART can be separately enabled to enter Sleep mode through the Sleep register. Sleep mode reduces
power consumption when the system needs to put the UART(s) to idle. All of these conditions must be satisfied
for the D154 to enter sleep mode:
no interrupts pending (INT0 = 0x00)
divisor is a non-zero value for all channels (ie. DLL = 0x1)
sleep mode is enabled (SLEEP = 0x0F)
modem inputs for all channels are not toggling (MSR bits 0-3 = 0)
RX input pins for all channels are idling HIGH
The D154 stops its crystal oscillator to conserve power in the sleep mode. User can check the XTAL2 pin for
no clock output as an indication that the device has entered the sleep mode.
The D154 resumes normal operation by any of the following:
a receive data start bit transition (HIGH to LOW)
a data byte is loaded to the transmitter, THR or FIFO
a change of logic state on any of the modem or general purpose serial inputs: CTS#, DSR#, CD#, RI#
If the D154 is awakened by any one of the above conditions, it will return to the sleep mode automatically after
all interrupting conditions have been serviced and cleared. If the D154 is awakened by the modem inputs, a
read to the MSR is required to reset the modem inputs. In any case, the sleep mode will not be entered while
an interrupt is pending from any channel. The D154 will stay in the sleep mode of operation until it is disabled
by setting Sleep = 0x00. In this case, the quad UART is awaken by any of the UART channel from a receive
data byte or a change on the serial port. The UART is ready after 32 crystal clocks to ensure full functionality.
Also, a special interrupt is generated with an indication of no pending interrupt. Reading INT0 will clear this
special interrupt. Logic 0 (default) is disable and logic 1 is enable to sleep mode.
Important: The XR17D154 is a versatile device designed to operate with different VCC (core power supply)
and VIO(PCI bus I/O power supply). However, the VCC and VIO must be equal (VCC = VIO) for the sleep
mode to reduce power consumption. Any difference in these voltages will result in high currents, when placed
in sleep mode. If sleep mode is used, it is recommended that both VCC and VIO be powered by the PCI bus
VIO power pins. If sleep mode is not used, there is no concern about high currents whether VCC = VIO or VCC
> VIO. In any case, VCC should never be less than VIO.
SLEEP Register
Ind ividual U A R T C hann el S leep E n able
B it-7 B it-6 B it-5 B it-4 B it-3 B it-2 B it-1 B it-0
Rsvd
Ch-3 Ch-2 Ch-1 Ch-0
Rsvd Rsvd Rsvd
相關PDF資料
PDF描述
XRD8785 CMOS 8-Bit High Speed Analog-to-Digital Converter
XRT7250IQ100 Ultraframer DS3/E3/DS2/E2/DS1/E1/DS0
XRT7250 Ultraframer DS3/E3/DS2/E2/DS1/E1/DS0
XRT75VL00DIV E3/DS3/STS-1 LINE INTERFACE UNIT WITH SONET DESYNCHRONIZER
XRT75VL00D E3/DS3/STS-1 LINE INTERFACE UNIT WITH SONET DESYNCHRONIZER
相關代理商/技術參數
參數描述
XR17D154CV 功能描述:UART 接口集成電路 UART RoHS:否 制造商:Texas Instruments 通道數量:2 數據速率:3 Mbps 電源電壓-最大:3.6 V 電源電壓-最小:2.7 V 電源電流:20 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:LQFP-48 封裝:Reel
XR17D154CV-0A-EVB 功能描述:界面開發工具 Supports D154 144 ld TQFP, PCI Interface RoHS:否 制造商:Bourns 產品:Evaluation Boards 類型:RS-485 工具用于評估:ADM3485E 接口類型:RS-485 工作電源電壓:3.3 V
XR17D154CV-F 功能描述:UART 接口集成電路 3.3V-5V 64B FIFO temp 0C to 70C; UART RoHS:否 制造商:Texas Instruments 通道數量:2 數據速率:3 Mbps 電源電壓-最大:3.6 V 電源電壓-最小:2.7 V 電源電流:20 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:LQFP-48 封裝:Reel
XR17D154CVTR-F 制造商:Exar Corporation 功能描述:UART 4-CH 64Byte FIFO 3.3V/5V 144-Pin LQFP T/R 制造商:Exar Corporation 功能描述:XR17D154CVTR-F
XR17D154IV 功能描述:UART 接口集成電路 UART RoHS:否 制造商:Texas Instruments 通道數量:2 數據速率:3 Mbps 電源電壓-最大:3.6 V 電源電壓-最小:2.7 V 電源電流:20 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:LQFP-48 封裝:Reel